2008 Citroen C4 stop start
[x] Cancel search: stop startPage 43 of 257
44
III
C O M F O R T
6 - A i r c o n d i t i o n i n g
The air conditioning will only operate when the engine is running.
5 - R e a r s c r e e n d e m i s t i n g
Can only be operated with the en-gine running.
D e m i s t i n g - d e i c i n g o f t h e w i n d s c r e e n a n d f r o n t s i d e w i n d o w s
One press on control 5 acti-vates the electric demisting of the rear screen and, ac-cording to version, the exte-rior rear view mirrors. The warning lamp comes on.
It switches off automatically to avoid excessive consumption of power.
One press stops the demisting.
A further press starts it again.
Note: If the engine is stopped be-fore the end of demisting, the latter will resume the next time the engine is started.
Press on control 6. The warning lamp comes on.
For air conditioning, the air blower control 3 must not be on position "0".
Air conditioning is obtained by mix-ing the warm air with refrigerated air. The control for the blown air temper-ature 4 adjusts the air conditioning provided the control 6 is operational.
- Place the controls for temperature a n d a i r fl o w o n m a x i m u m .
- Close the central air vents.
- Operate the air conditioning by pressing the control 6, the warning lamp comes on.
Note: you should not be in air recir-culation.
Page 45 of 257
46
III
C O M F O R T
Notes:
- When you enter the vehicle, the temperature inside the vehicle may be much colder (or warmer) than a comfortable temperature. It is no use modifying the displayed temperature to try to attain the desired level of comfort. The system automatically strives to compensate this temperature discrepancy as rapidly as possible.
- When starting the engine from cold, in order to avoid distributing too much cold air, the blower will attain its optimum level gradually.
M a n u a l r e c a l l i n g o f o n e o r m o r e f u n c t i o n s
All the functions 4, 6 and 7 can be adjusted manually.
Display of the function "AUTO" then disappears.
C e n t r a l a n d l a t e r a l a i r vents.
C e n t r a l a n d l a t e r a l a i r v e n t s a n d p a s s e n g e r f o o t w e l l s .
P a s s e n g e r f o o t w e l l s .
T h e w i n d s c r e e n , f r o n t s i d e w i n d o w s a n d p a s s e n g e r f o o t w e l l s .
T h e w i n d s c r e e n a n d f r o n t s i d e w i n d o w s .
4 - A i r c o n d i t i o n i n g 6 - A d j u s t m e n t o f t h e a i r d i s t r i b u t i o n
5 - Air recirculation
To stop the air conditioning, press on the control 4. The symbol " A / C " disappears.
To restart it, press again on the control 4. The symbol " A / C " dis-plays.
When you press on control 5, the entry of air from out-side is blocked off and the associated symbol is dis-played.
This function can also be accessed by pressing the appropriate button on the steering wheel.
While retaining the other settings, this position excludes disagreeable odours or emissions coming from outside. It should be cancelled as soon as possible to prevent misting and to allow fresh air into the cabin.
To deactivate the air recirculation, press again on control 5.
Press the button successive-ly so that the display shows, i n t u r n , t h e a i r fl o w t o :
Page 46 of 257
47
III
C O M F O R T
7 - A i r fl o w
Heater blower speed: press button:
9 - D e m i s t i n g - d e i c i n g o f t h e rear screen
When this function is work-ing, the warning lamp comes on and the symbol appears on the display.
This control is for rapid deicing or demisting of the rear screen.
It switches off automatically to avoid excessive consumption of power.
To stop it, press again on the control 9.
P r e s s A U T O t o r e t u r n t h e s y s t e m t o i t s a u t o m a t i c f u n c t i o n .
To increase it
To decrease it.
T h e l e v e l o f a i r fl o w i s r e p r e s e n t e d o n t h e d i s p l a y b y t h e p r o g r e s s i v e fi l l -ing of the fan blades.
A press on the control 7 deactivates the function "AUTO". To restart it, press again on the control AUTO.
Note: to avoid condensation and poor air quality in the passenger compartment, it is recommended a l w a y s t o m a i n t a i n a s u f fi c i e n t fl o w of air.
8 - D e m i s t i n g - d e i c i n g o f t h e w i n d s c r e e n a n d f r o n t s i d e w i n d o w s
While it is operating, the warning lamp lights and the symbol appears on the dis-play.
This control is for rapid deicing or demisting of the windscreen, acting a u t o m a t i c a l l y o n t h e a i r b l o w e r fl o w , air distribution, air conditioning and air entry.
To stop it, press again on control 8or on the control AUTO.
Note: you should not have air recir-culation selected.
Page 63 of 257
63
IV
A C C E S S
If you decide to drive with the doors locked, remem-ber that in the event of an accident this renders a c c e s s m o r e d i f fi c u l t f o r t h e emergency services.
Locking the doors from the inside
With the doors closed, press button B once to operate the electric central locking and unlocking.
The doors can still be opened from inside.
The central locking will not operate if a door is open, or not properly closed.
The lamp on the control B can signal any of 3 statuses:
- I t fl a s h e s i f t h e d o o r s a r e o p e n when the vehicle is stationary, engine stopped.
- It lights up if the doors are locked and the ignition is switched on.
- It goes out if the doors are not locked.
DOORSNote: Control B is inactive if the vehicle has been locked with the remote control or with the key.
Personal security
When the vehicle is started, the system automatically locks the doors and tailgate as soon as you reach a speed of approx. 10 km/h (6 mph).
Note: If a door is opened, this door will automatically relock as soon as the vehicle reaches approx. 6 mph.
Activation/Deactivation of the function
After switching on the ignition, give a long press on the central unlocking button until a message is displayed.
This allows from the front, deactivation of the opening of the rear doors and the use of the rear windows.
It is activated by means of a press on control A located on the electric windows control panel. The warning lamp in the instrument panel lights up for approx. 10 seconds.
Each time the ignition is switched on, the warning lamp comes on for approx. 10 seconds.
Opening of the doors from the outside and operation of the rear electric windows remain possible from the front of the vehicle.
Electric child safety
Page 64 of 257
63
IV
A C C E S S
If you decide to drive with the doors locked, remem-ber that in the event of an accident this renders a c c e s s m o r e d i f fi c u l t f o r t h e emergency services.
Locking the doors from the inside
With the doors closed, press button B once to operate the electric central locking and unlocking.
The doors can still be opened from inside.
The central locking will not operate if a door is open, or not properly closed.
The lamp on the control B can signal any of 3 statuses:
- I t fl a s h e s i f t h e d o o r s a r e o p e n when the vehicle is stationary, engine stopped.
- It lights up if the doors are locked and the ignition is switched on.
- It goes out if the doors are not locked.
DOORSNote: Control B is inactive if the vehicle has been locked with the remote control or with the key.
Personal security
When the vehicle is started, the system automatically locks the doors and tailgate as soon as you reach a speed of approx. 10 km/h (6 mph).
Note: If a door is opened, this door will automatically relock as soon as the vehicle reaches approx. 6 mph.
Activation/Deactivation of the function
After switching on the ignition, give a long press on the central unlocking button until a message is displayed.
This allows from the front, deactivation of the opening of the rear doors and the use of the rear windows.
It is activated by means of a press on control A located on the electric windows control panel. The warning lamp in the instrument panel lights up for approx. 10 seconds.
Each time the ignition is switched on, the warning lamp comes on for approx. 10 seconds.
Opening of the doors from the outside and operation of the rear electric windows remain possible from the front of the vehicle.
Electric child safety
Page 74 of 257
70
V
V I S I B I L I T Y
A - Windscreen washer
To operate the windscreen wash, pull the wiper stalk towards you.
Screen wash is accompanied by a timed screen wipe, the headlamp wash also operates if dipped beams are switched on.
Always check that the windscreen and rear screen wipers can operate f r e e l y , f o r e x a m p l e i f fi t t i n g a b i c y c l e c a r r i e r , or in freezing temperatures.
Remove any accumulation of snow from the base of the windscreen.
B - Rear screen wiper
To deactivate.
Intermittent rear wipe.
Timed rear screen wash/wipe.
Changing the wiper blades
The wipers should be stopped in themaintenance position (during re-placement).
Switch off the ignition and action the wipe stalk within one minute. The wipers will position themselves in the middle of the windscreen.
For this, switch off the ignition then, within one minute, action the wiper stalk. The wipers will posi-tion themselves to the centre of the windscreen.
For optimum wiping performance, replace the wiper blades as soon as they leave traces on the screen; oth-erwise change them once or twice per year (in spring and autumn, for example).
Reversing
On engaging reverse gear, if the front wiper is on, the rear wiper starts.
Activation/deactivation of this func-tion is possible in the menu "Person- a l i s a t i o n - C o n fi g u r a t i o n " o f t h e " M a i n menu".
Deactivation of this function is nec-essary when a bicycle carrier is in-stalled on the tailgate.
Page 112 of 257
1 0 2
IX
D R I V I N G
Starting the vehicle
- T o s t a r t t h e e n g i n e , t h e g e a r l e v e r has to be in position N.
- F u l l y d e p r e s s t h e b r a k e p e d a l .
- A c t i o n t h e s t a r t e r .
- W i t h t h e e n g i n e r u n n i n g , d e p e n d i n g on your preference place the lever on R, A or M.
- C h e c k t h e p o s i t i o n e n g a g e d o n t h e rev counter.
- R e l e a s e t h e h a n d b r a k e .
- R e l e a s e t h e b r a k e p e d a l a n d accelerate.
If the lever is not in position N, the warning lamp "N" fl a s h e s o n t h e r e v counter.
If the brake pedal is not pressed down, the warning lamp "Foot on brake" fl a s h e s i n t h e i n s t r u m e n t panel.
In both cases, the engine does not start; recommence the above procedure.
Note: If the vehicle has been stationary for a long time, or if you have pressed the brake pedal a number of times while stationary, it will be necessary to press the brake pedal hard down in order to authorise the engine to start.
Stopping the engine
Before switching the engine off, you can choose:
- t o l e a v e t h e v e h i c l e i n n e u t r a l ; f o r that, place the lever in position N,
- t o l e a v e t h e v e h i c l e w i t h a g e a r engaged (R, A or M); for that, place the lever in the position chosen. In this case, the vehicle cannot be moved.
In all cases, it is essential to apply the handbrake.
Before undertaking any operation in the engine compartment, make absolutely sure that the gearbox is in neutral and that the handbrake is on.
Do not hold the vehicle stationary using only the accelerator.
If you are stopped on an incline, use the handbrake to hold the vehicle.
Acceleration
To obtain optimum acceleration (for example to overtake another vehicle), you have only to press the pedal hard down to go beyond the e n d - o f - t r a v e l s w i t c h .
Page 188 of 257
176
XIII
A U D I O
Swapping a call
During a telephone conversation, the system is able to tell you of a second call incoming. To accept it, validate. To change from one call to the other, select this choice.
End a call
This choice enables you to end a telephone conversation, for example if there is another call incoming.
Secret mode
Selecting this choice allows you not to be heard by the other person. To restore sound to the other person, select deactivation of Secret mode in the menu "Call Management".
Note:
If you wish to transfer a call from the audio system to the mobile telephone (for example when leaving your vehicle), refer to the user instructions for the latter.
Voice recognition
A short press on button 12 starts voice recognition for the telephone.Voice recognition allows you to make a call to a number for which you have recorded a label on the mobile telephone that is twinned and connected.
Remark:
It is possible to stop the call as long as the dialling has not commenced, by means of a short press on button 12.
Remarks:
- While you are on a call, the audio source currently being listened to is paused.
- Some ring tones on your mobile telephone may not be recognised by the Bluetooth® system on your ®
vehicle. A different ring tone will be chosen by the system.
Displays
Press the "MODE" button to display telephone information in the right hand part of the display.
A "Telephone" symbol appears on your display when you connect a mobile telephone.A "Battery" symbol appears at the bottom of the display to indicate the range of the mobile telephone connected.An "Envelope" symbol appears at the bottom of the display to indicate the presence of an unread SMS on the mobile telephone connected.A "Sound track" symbol appears at the bottom of the display to indicate the presence of a message on the mobile telephone connected.