2008 Citroen C2 DAG Owner's Manual

120
V
C H A N G I N G A W H E E L
Removal1. Park the vehicle on stable, fi rm ground that is not slippery. Apply the parking brake.Switch off the ignition and engage fi rst gear or reverse gear, depending on any slope.Ensure that all vehicle occupants have left the vehicle an d are posi-tioned in a safe place.
2. Position the jack at one of the four jacking-points provided on the sub-frame close to the wheels. Using the handle, unwind the jack until it reaches the ground.3. To unclip the wheel embellisher, pull using the end of the wheelbrace as a lever in one of the apertures.For vehicles with aluminium wheel rims:
With a central embellisher, remove the embellisher, using the tool, to access the bolts.With visible wheel bolts, remove the chromed bolt protectors, usi ng the tool, before slackening the bolts.4. Continue to extend the jack until the wheel is a few centimetres off the ground.5. Undo the other bolts, remove the wheel.
-
-
Refi tting1. Fit the wheel on the hub, using the centring guide.2. Screw in the bolts but do not fully tighten them, remove the wheel centring guide in order to screw in the last bolt.3. Lower the jack and remove it.4. Tighten the wheel bolts, using the wheelbrace.5. Refi t the embellisher, taking care to accommodate the tyre valve . Then pressing all round its circumference.6. Have the original wheel repaired and refi tted as soon as possible.7. Make sure that the tyre is at the correct pressure (see "Vehicle Ident ifi cation" and "User Precautions") and have the wheel balancing checked.
Dimension of the spare wheel
If your spare wheel has dimensions different from those of the normal vehicle wheels (identifi ed by a label), it is imperative to use the spare wheel only temporarily, to drive with caution, not to exceed 80 km/h (50 mph) and to have the tyre repaired and the normal wheel refi tted as soon as po ssible.

121
V
Because the aerosol is pressurised, do not expose it to temperatures higher than 50 °C.
After provisionally repairing a tyre using the repair aerosol, you are advised not to drive at over 80 km/h.
If your vehicle has no spare wheel, a repair aerosol is to be found in the boot.
Using the repair aerosol
See also the user instructions on the aerosol.Remove, if possible, the object which has caused the punc-ture.
Orient the wheel so that the valve is at ten o’clock or two o’clock.Shake the aerosol vigorously (in cold weather warm it in your hands for a few minutes).
With one hand hold the valve connector clear of the rim hole, with the other hand press the end of the aerosol nozzle fi rmly onto the connector, keeping it in the line of the valve.Firmly maintain the pressure for one minute.
Rapidly remove the aerosol and immediately drive for around six miles.
Reinfl ate the tyre and check its condition after some ten hours.
After using the repair aerosol, you should have the condition of the tyre, as well as its infl ation pressure, inspected.

122
V
T O W I N G – L I F T I N G
Towing with wheels on the ground
Towing eye fi xings are located at the front and at the rear of the vehicle.
To access them:Carefully lift the access cover.
Release it by pressing on the lower part.
A lug keeps the cover attached to the bumper, so that it do es not become lost.
The ignition key must be in position M to retain steering.
Use a bar with attachments to the towing eyes as above.
Vehicles with manual gearbox (diesel models)
For vehicles with a manual gearbox, the gear lever must be in "n eutral", otherwise some components in the braking system could become damaged and impair braking assistance the next time the engine is started.

123
VI
F U E L C O N S U M P T I O N
( I N L I T R E S / 1 0 0 K M ( M I L E S P E R G A L L O N ) )
These consumption fi gures are established according to Directive 80/1268/CEE. Fuel consumption can vary depend-ing on style of driving, traffi c conditions, weather conditions, vehicle load, how the vehicle has been maintained and on use of accessories.
Engine type1.1i61 hp1.4i75 hp1.4i75 hp1.4i 16V90 hp1.6i 16V110 hp1.6i 16V125 hpHDi 70HDi 701.6 HDi 110 hp FAP
SaloonEntrepriseBVMBVMBVMPBVMP
Stop & StartBVMPBVMBVMBVMPBVM
UrbanCO2 emissions (g/km)
7.5(37.7)178
7.9(35.8)190
7.5(37.7)181
6.8(41.5)162
8.3(34.0)199
9.3(30.4)223
5.3(53.3)141
4.9(57.6)130
5.7(49.6)151
Extra urbanCO2 emissions (g/km)
4.8(58.9)114
4.9(57.6)117
4.8(58.9)116
4.8(58.9)116
5.2(54.3)124
5.4(52.3)129
3.7(76.3)96
3.8(74.3)99
3.7(76.3)98
CombinedCO2 emissions (g/km)
5.8(48.7)138
6.0(47.1)143
5.8(48.7)138
5.6(50.4)133
6.3(44.8)151
6.9(40.9)163
4.3(65.7)113
4.2(67.3)111
4.4(64.2)119
The fuel consumption fi gures quoted are correct at time of going to press.
BVM: Manual gearbox.
BVMP: Electronic Gearbox System.
FAP: Diesel particulate fi lter system.

124
VI
G E N E R A L
Saloon
Engine type1.1iBVM1.4iBVM1.4iBVMP1.4i 16V90 hpBVMP
1.6i 16V110 hpBVMP
1.6i 16V125 hpBVM
Fuel tank capacityApproximately 41 litres
Fuels to be usedUnleaded petrol RON 95 - RON 98
Turning circle between walls (in metres)9.69.610.79.610.710.710.710.7
French fi scal rating455567
Calculated maximum speed in km/h (mph)(In the highest gear)158(98)169(105)169(105)181(112)195(121)202(125)
Weights (kg)
Unladen weight (MAV)9569909951 0131 0711 084
Gross vehicle weight (MTAC)1 3361 3621 3911 4101 4251 415
Maximum weight on rear axle (CMAE AR)710
Gross train weight (MTRA)1 7861 8121 8411 8601 8751 865
Gross trailer weight (with brakes) (Within the Gross Train Weight limit)520530530540560620
Gross trailer weight (without brakes)450
Trailer nose weight25
Maximum roof rack load60
Dimensions of chainable tyres175/65 R14 - 185/55 R15 - 195/45 R16

125
VI
G E N E R A L
SaloonEntreprise
HDi 70BVMHDi 70BVMP1.6 HDi 110 hpBVM FAP
HDi 70BVM1.1iBVM
Approximately 41 litres
Diesel fuelUnleaded petrolRON 95 - RON 98
9.610.79.610.710.79.610.79.6
44644
166(103)167(104)193(120)166(103)158(98)
1 0031 0411 130978939
1 3911 4211 4751 3741 340
710
1 8411 8711 9251 8241 790
540540625540520
450
25
60
175/65 R14 - 185/55 R15 - 195/45 R16
MAV: Unladen weight.
MTAC: Gross vehicle weight.
CMAE AR: Maximum weight on rear axle.
MTRA: Gross train weight.
Weights: Refer to the manufactur-er's plate.
BVM: Manual gearbox.
BVMP: Electronic Gearbox System.
FAP: Diesel particulate fi lter system.
Observe your vehicle's towing limits.
It is essential to comply with the max. Gross Trailer Weights and speed limits as specifi ed by legis-lation in each country.
For further information about the towing capacity of your vehicle and its max. authorised Gross Train Weight, contact a CITROËN dealer.

B
ADC
I
FE
G
H
126
VI
D I M E N S I O N S
( I N M E T R E S )
A2.315
B3.666
C0.760
D0.591
E1.439
F1.439
G1.659
H1.461
I1.898

A
H
D
C
G
E
FB
127
VI
D I M E N S I O N S
( I N M E T R E S )
A0.892
B0.606
C0.334 MIN.
0.434 MAX.
D1.033
E0.990
F0.993
G0.530
H0.678