2008 CHRYSLER SEBRING CONVERTIBLE trunk

CAUTION!
²Do not operate the Power Top when the vehicle is in motion.
²Do not operate the Power Top with the hydraulic pump
valve open.
²Do not allow the top to remain in the suspended position.
After approximately 10 minutes in the suspended position,
the hydraulic pressure will release, which will allow the top
and the trunk lid to lower. Pressing the Power Top switch
will cancel this operation.
²Always use a normal ice scraper to remove snow or ice from
the rear window. Use of a sharp object or other tools could
scratch the fabric or panels when removing snow or ice.
²Always close the top when leaving your vehicle so as not to
leave the interior exposed to potentially damaging outdoor
conditions.
²Do not leave the top lowered for several weeks at a time.
Close it occasionally to prevent discoloration in the folds of
the fabric and to allow the creases to smooth out. This is
especially important if the top was stowed when not com-
pletely dry.
Failure to follow these cautions can cause damage to the convert-
ible top components, trunk contents, and the vehicle interior.
WARNING!
²Before operating the Power Top, make sure that no moving
parts of the convertible top can injure a person or animal.
²Never place any extremities (hands, feet, etc.) near the
convertible top components, the upper windshield area, the
shelf area behind the rear seats, or the convertible top
stowage area while raising or lowering the convertible top.
²When using the Power Top button on RKE transmitter, if
potential danger exists while lowering the top, release the
button immediately to interrupt the operation.
²When using the Power Top switch on the instrument panel,
if potential danger exists while lowering the top, press and
release the switch immediately to interrupt the operation.
²When using the Power Top switch on the instrument panel,
if potential danger exists while raising the top, release the
switch immediately to interrupt the operation.
²
Only drive the vehicle with the convertible top completely closed
and latched or fully lowered into its stowage compartment.
²Do not operate the Power Top when the vehicle is in motion.
Failure to follow these warnings can result in injuries that are
serious or fatal to you, your passengers, and others around you. 84 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Cargo Protector
The cargo protector is located in the trunk. Before low-
ering the convertible top, you must unfold the cargo
protector and seat the tabs at each end of the cargo
protector in the V slots in the trunk liner. Doing so closes
a switch that allows top operation. If the switch is not
closed, a warning message displays in the instrument
cluster to notify the driver.
Positioning the Cargo Protector for Top Operation
Pull the cargo protector toward you to begin unfolding
the panels. Grasp the handle in the center of the outer-
most (top) panel and raise the cargo protector. Then,
align and seat the tabs at each end of the cargo protector
in the V slots in the trunk liner as shown in the illustra-
tion.
Cargo Protector
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 85
3

Press and hold the switch in the Top Up
position until the operation of raising the top
and latching it is complete, which is indicated
by the system raising the windows and dis-
playing ªTOP DONEº in the odometer or ªCONVERT-
IBLE TOP COMPLETEº in the EVIC (if equipped).
Using the Remote Keyless Entry (RKE) Transmitter
You cannot use the Power Top button on the RKE
transmitter to raise the power convertible top. You must
use the Power Top switch inside the vehicle to perform
this operation.
Manually
Closing the power convertible top manually is a compli-
cated and physically demanding procedure, and it re-
quires a special tool to do so. In the event that you
experience a malfunction when operating the power
convertible top:1. Read all of the Notes, Cautions, and Warning found
under ªPower Convertible Top Usage Precautionsº to
verify all operating conditions are met.
2. Check for Operation and Warning Messages as de-
scribed under ªPower Convertible Top Operation &
Warning Messages.º If applicable, perform the related
action to correct the condition present.
3. If Steps 1 and 2 do not resolve the problem, see your
authorized dealer for service.
Wind Stop
The Wind Stop installs in the backseat area of the vehicle.
The Wind Stop will not interfere with power top opera-
tion. Therefore, it can remain installed when the top is up.
However, when not in use, the Wind Stop folds to allow
for convenient storage underneath the cargo protector in
the trunk.
88 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

NOTE:It is recommended that you lower the convert-
ible top before installing or removing the Wind Stop.
Installing the Wind Stop
1. Remove the Wind Stop from the trunk.
2. Unfold the Wind Stop framework.
3. Lay the small frame (1) flat on top of the large frame
(2) and snap the two frames together by engaging the
frame lock (3).
NOTE:The frames must lie flat on each other in order to
snap them together.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 89
3

EVIC
MessageLEVIC
Message
Display
TimeLOdometer
Message
(< 5 mph
[8 km/h])LLOdometer
Message
Display
TimeLLOdometer
Message
(> 5 mph
[8 km/h])LLOdometer
Message
Display
TimeLLChime ConditionOperator
Action
Required
CONVERT-
IBLE TOP IN
OPERATIONUntil Op-
eration is
CompleteTOP Until Opera-
tion is Com-
pleteÐ Ð Ð The System is
Lowering or
Raising the TopÐ
CONVERT-
IBLE TOP
COMPLETE9 Seconds TOP DONE Display Scrolls
for 6 SecondsÐ Ð Single
ChimeThe System
Completes Op-
eration of Low-
ering or Raising
the TopÐ
SECURE
CARGO
SHIELD9 Seconds SET CARGO
SHIELDDisplay Scrolls
for 9 SecondsÐ Ð Single
ChimeThe Top Fails to
Move When Op-
erating the
Power Top Con-
trolPosition the
Cargo Protec-
tor in the
Trunk to Allow
Top Operation
CONVERT-
IBLE TOP IN
OPERATIONUntil Op-
eration is
CompleteTOP Until Opera-
tion is Com-
pleteTOP Until Op-
eration is
CompleteSingle
ChimeThe System Fails
to Complete Op-
eration of Low-
ering or Raising
the TopCycle Power
Top Control
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 93
3

EVIC
MessageLEVIC
Message
Display
TimeLOdometer
Message
(< 5 mph
[8 km/h])LLOdometer
Message
Display
TimeLLOdometer
Message
(> 5 mph
[8 km/h])LLOdometer
Message
Display
TimeLLChime ConditionOperator
Action
Required
SPEED TOO
HIGH9 Seconds SPEED TOO
HIGHDisplay Scrolls
for 9 SecondsTOP 6 Seconds Single
ChimeYou Are Operat-
ing the Power
Top at a Vehicle
Speed Greater
Than 0 mph (0
km/h)The Top Will
Not Operate
Unless the Ve-
hicle is Station-
ary.
TRUNK
AJARContinu-
ousDECK Continuous DECK Continuous Single
ChimeThe Trunk Lid is
Unlatched or
OpenThe Top Will
Not Operate
Unless the
Trunk Lid is
Closed
CONVERT-
IBLE TOP
MALFUNC-
TION6 Seconds TOP FAIL Display Scrolls
for 6 SecondsTOP 6 Seconds Single
ChimeThe PTCM Acti-
vated the System
LOCKOUT Fea-
tureRefer to Foot
NoteLLL
CONVERT-
IBLE TOP
MALFUNC-
TIONUntil Fault
is No
Longer De-
tected or
RepairedTOP FAIL Display Scrolls
until Fault is
No Longer De-
tected or Re-
pairedTOP Display
Flashes un-
til Fault is
No Longer
Detected or
RepairedSingle
ChimeThe PTCM Acti-
vated the System
LOCKOUT Fea-
tureSee your au-
thorized dealer
for service
94 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

INSTRUMENT PANEL FEATURES
1 Ð Air Outlet 6 Ð Radio 11 Ð Hazard Switch
2 Ð Side Window Demister Outlet 7 Ð Passenger Airbag 12 Ð Storage Compartment
3 Ð Instrument Cluster 8 Ð Glove Box 13 Ð Climate Control
4 Ð Ignition Switch 9 Ð Heated Seat Switch* 14 Ð Trunk Release Switch
5 Ð Analog Clock 10 Ð Electronic Stability Program Off Button* 15 Ð Power Top Switch
* If Equipped UNDERSTANDING YOUR INSTRUMENT PANEL 173
4

The two trip odometers show individual trip mileage. To
switch from odometer to trip odometers, press and
release the Trip Odometer button. To reset a trip odom-
eter, display the desired trip odometer to be reset then
push and hold the button until the display resets (ap-
proximately 2 seconds). Refer to ªTrip Odometer Buttonº
for additional information.
Vehicle Warning Messages
When the appropriate conditions exist, ªDOOR AJAR,º
ªTRUNK AJAR,º or ªgASCAPº will display in the odom-
eter.
NOTE:If the instrument cluster is equipped with the
optional Electronic Vehicle Information Center (EVIC),
then all warnings including ªDOOR AJARº and
ªTRUNK AJARº will only display in the EVIC. (Refer to
ªElectronic Vehicle Information Center (EVIC)º in this
section for specific messages).gASCAP
If the vehicle diagnostic system detects a leak or change
in the evaporative system, or the fuel filler cap is loose,
improperly installed, or damaged, the words ªgASCAPº
will display in the odometer. If this occurs, tighten the
fuel filler cap properly and press the odometer reset
button to turn off the ªgASCAPº message. (Refer to
ªOnboard Diagnostic System Ð OBDIIº in Section 7 of
this manual for more information). If the problem con-
tinues, the message will appear the next time the vehicle
is started. See your authorized dealer service center as
soon as possible.
Change Oil
Your vehicle is equipped with an engine oil change
indicator system. The ªChange Oilº message will flash in
the instrument cluster odometer for approximately 12
seconds after a single chime has sounded to indicate the
next scheduled oil change interval. The engine oil change
UNDERSTANDING YOUR INSTRUMENT PANEL 179
4