2008 CHEVROLET TRAIL BLAZER light

[x] Cancel search: light

Page 177 of 472

CHEVROLET TRAIL BLAZER 2008 1.G Owners Manual Highbeam On Light
This light comes on when
the high-beam headlamps
are in use.
SeeHeadlamp High/Low-Beam Changer on page 3-8
for more information.
Service Four-Wheel Drive
Warning Light
This light sho

Page 178 of 472

CHEVROLET TRAIL BLAZER 2008 1.G Owners Manual Fuel Gage
When the ignition is on, the fuel gage tells you about
how much fuel you have remaining.
Here are four things that some owners ask about.
None of these show a problem with your fuel gage:
A

Page 183 of 472

CHEVROLET TRAIL BLAZER 2008 1.G Owners Manual Select Button
r
(Select):Press the select button to reset certain
DIC functions, turn off or acknowledge messages on
the DIC display, and set your customization settings.
For example, this button will

Page 184 of 472

CHEVROLET TRAIL BLAZER 2008 1.G Owners Manual CHECK WASHER FLUID
This message displays if the washer �uid level is low.
Adding washer �uid to the windshield washer �uid
reservoir clears this message. SeeWindshield Washer
Fluid on page 5-39. This

Page 185 of 472

CHEVROLET TRAIL BLAZER 2008 1.G Owners Manual LEFT REAR DOOR AJAR
This message displays and a chime sounds if the driver
side rear door is not fully closed. Stop and turn off
the vehicle, check the door for obstructions, and close
the door again.

Page 186 of 472

CHEVROLET TRAIL BLAZER 2008 1.G Owners Manual SERVICE CHARGING SYS (System)
This message displays if there is a problem with
the battery charging system. Under certain conditions,
the charging system light may also turn on in the
instrument panel

Page 187 of 472

CHEVROLET TRAIL BLAZER 2008 1.G Owners Manual if your vehicle gets stuck in sand, mud, ice, or snow and
you want to rock your vehicle to attempt to free it, or if you
are driving in extreme off-road conditions and require
more wheel spin. SeeIf Y

Page 191 of 472

CHEVROLET TRAIL BLAZER 2008 1.G Owners Manual Perimeter Lights
Press the customization button until PERIMETER
LIGHTS: ON appears in the display. To select your
preference for perimeter lighting, press the select button
while PERIMETER LIGHTS: ON