2008 CHEVROLET IMPALA Owners Manual

Page 177 of 400

CHEVROLET IMPALA 2008 9.G Owners Manual CHECK TIRE PRESSURE
This message displays when the pressure in one or
more of the vehicle’s tires needs to be checked.
This message also displays LEFT FRONT, RIGHT
FRONT, LEFT REAR, or RIGHT REAR to

Page 178 of 400

CHEVROLET IMPALA 2008 9.G Owners Manual ENGINE OVERHEATED STOP ENGINE
Notice:If you drive your vehicle while the engine
is overheating, severe engine damage may
occur. If an overheat warning appears on the
instrument panel cluster and/or DI

Page 179 of 400

CHEVROLET IMPALA 2008 9.G Owners Manual LEFT REAR DOOR OPEN
This message displays when the driver side rear door is
not closed properly. Make sure that the door is closed
completely.
OIL PRESSURE LOW STOP ENGINE
Notice:If you drive your veh

Page 180 of 400

CHEVROLET IMPALA 2008 9.G Owners Manual SERVICE A/C (Air Conditioning)
SYSTEM
This message displays when the electronic sensors that
control the air conditioning and heating systems are
no longer working. Have the climate control system
ser

Page 181 of 400

CHEVROLET IMPALA 2008 9.G Owners Manual If this message still stays on or turns back on again while
you are driving, your vehicle needs service. Have the
system inspected by your dealer/retailer as soon as
possible.
SERVICE THEFT SYSTEM
Thi

Page 182 of 400

CHEVROLET IMPALA 2008 9.G Owners Manual STARTING DISABLED SERVICE
THROTTLE
This message displays if the starting of the engine is
disabled due to the electronic throttle control system.
Have your vehicle serviced by your dealer/retailer
imm

Page 183 of 400

CHEVROLET IMPALA 2008 9.G Owners Manual Any of the following conditions may cause the TCS to
turn off:
The TCS is turned off by pressing the traction
control button. SeeTraction Control System (TCS)
on page 4-6for more information.
The batt

Page 184 of 400

CHEVROLET IMPALA 2008 9.G Owners Manual DIC Vehicle Customization
Your vehicle has customization capabilities that allow
you to program certain features to one preferred setting.
Customization features can only be programmed to
one setting