2008 CADILLAC SRX buttons

5. After entering all of the switch positions, again,
rmly press and release all three buttons at the
same time. The indicator lights will turn on.
6. Press and hold the button you would like to use
to control the garage door until the garage door
moves. The indicator light above the selected
button should slowly blink. You may need to
hold the button from ve to 55 seconds.
7. Immediately release the button when the garage
door moves. The indicator light will blink rapidly
until programming is complete.
8. Press and release the same button again.
The garage door should move, conrming
that programming is successful and complete.
To program another Fixed Code device such as an
additional garage door opener, a security device,
or home automation device, repeat Steps 1-8,
choosing a different button in Step 6 than what
you used for the garage door opener.Using Universal Home Remote
Press and hold the appropriate button for at least
half of a second. The indicator light will come on
while the signal is being transmitted.
Reprogramming Universal Home
Remote Buttons
You can reprogram any of the three buttons by
repeating the instructions.
Erasing Universal Home
Remote Buttons
You should erase the programmed buttons when
you sell or terminate your lease.
2-56

To erase either Rolling Code or Fixed Code on the
Universal Home Remote device:
1. Press and hold the two outside buttons at the
same time for approximately 20 seconds, until
the indicator lights, located directly above the
buttons, begin to blink rapidly.
2. Once the indicator lights begin to blink, release
both buttons. The codes from all buttons will
be erased.
For help or information on the Universal Home
Remote System, call the customer assistance
phone number underCustomer Assistance Offices
on page 7-6.Storage Areas
Glove Box
To open, lift the handle up. Use the key to lock
and unlock.
Cupholder(s)
Your vehicle has cupholders located between the front
seats. Slide the cover back to expose them. There
are also cupholders in the armrest of the second row
seat. Press the panel on the front of the armrest
to expose the cupholders. On the outboard sides of
the third row there may also be cupholders.
Center Console Storage
Your vehicle has a center console storage area
located between the front seats. It includes storage
areas, and accessory power outlet(s) on the rear
of the console.
2-57

The sunroof/sunshade
switches are located
in the headliner between
the driver and front
passenger.
One switch operates the sunroof and the other switch
operates the sunshade.
Press the back of the sunroof switch to open the sunroof.
When the switch is pressed to the rst stop the sunroof
will open to a desired position. Press the switch to the
second stop to express open the sunroof to a preset
comfort position. Press the second stop again to fully
express open the sunroof. Press the front of the switch
to close the sunroof. The rst stop will close the sunroof
at a desired position at normal speed, and the second
stop will express close the roof.
Press the back of the sunshade switch to open the
sunshade. Press the front of the switch to the rst stop
to close the sunshade to a desired position at a normal
speed. Press the switch forward to the second stop to
express close the sunshade.Anti-Pinch Feature
If an object is in the path of the sunroof when it is
closing, the anti-pinch feature will detect the object
and stop the sunroof from closing at the point of
the obstruction. The sunroof will then reverse.
To close the sunroof once it has re-opened, remove
the obstruction and press the front of the sunroof switch.
Resynchronization
To resynchronize the sunroof and sunshade, do the
following.
1. With the engine running, press and hold both the
sunroof switch in the open position and the sunshade
switch in the closed position for six seconds.
2. Release both buttons.
3. When the sunroof reaches the fully closed position,
the sunshade will close.
4. After the sunroof and sunshade have fully closed,
continue to hold the sunroof switch in the closed
position for an additional three or four seconds
to complete the resynchronization process.
2-60

The main components of the instrument panel are the following:
A. Air Outlets. SeeOutlet Adjustment on page 3-29.
B. Turn Signal/Multifunction Lever. SeeTurn
Signal/Multifunction Lever on page 3-7.
C. Instrument Panel Cluster. SeeInstrument Panel
Cluster on page 3-32.
D. Windshield Wiper Lever. SeeWindshield Wipers on
page 3-9.
E. Analog Clock. SeeAnalog Clock on page 3-22.
F. Driver Information Center Controls (DIC). SeeDIC
Operation and Displays on page 3-48.
G. Hood Release. SeeHood Release on page 5-11.
Parking Brake Release. SeeParking Brake on
page 2-34.
H. Instrument Panel Brightness Control. SeeInstrument
Panel Brightness on page 3-19.
I. Cruise Control Buttons. SeeCruise Control on
page 3-12.
J. Tilt Wheel Lever. SeeTilt Wheel on page 3-6.K. Adjustable Pedal Button (If Equipped). See
Adjustable Throttle and Brake Pedal on page 2-28.
L. Horn. SeeHorn on page 3-6.
M. Audio Steering Wheel Controls. SeeAudio Steering
Wheel Controls on page 3-92.
N. Ashtray (If Equipped). SeeAshtray(s) and Cigarette
Lighter on page 3-21.
O. Traction Control Button. SeeTraction Control
System (TCS) on page 4-5.
P. Tow/Haul Selector Button (If Equipped).
SeeTow/Haul Mode on page 2-33.
Q. Hazard Warning Flasher Button. SeeHazard
Warning Flashers on page 3-6.
R. Dual Climate Control System. SeeDual Climate
Control System on page 3-23.
S. Audio System. SeeAudio System(s) on page 3-70.
T. Glove Box. SeeGlove Box on page 2-57.
3-5

When the brakes are applied, the cruise control
shuts off.
If your vehicle has the StabiliTrak
®system and begins to
limit wheel spin while using cruise control, the cruise
control automatically disengages. SeeStabiliTrak
®
System on page 4-7. Turn the cruise control back on,
when road conditions allow safe usage.The cruise control buttons are located on the outboard
side of the steering wheel.
T(On/Off):Press this button to turn the system
on and off. The indicator light on the button turns
on when cruise control is on and turns off when
cruise control is off.
+ RES (Resume/Accelerate):Press this button to
make the vehicle accelerate or resume to a previously
set speed.
SET−(Set/Coast):Press this button to set the speed
or make the vehicle slow down.
[(Cancel):Press this button to cancel cruise control
without erasing the set speed from memory.
Cruise Control
Cruise Control w/Heated
Steering Wheel
3-13

«ª(Driver’s Temperature Controls):Press the up
or down buttons closest to the driver to manually increase
or decrease the temperature inside the vehicle.
«ª(Passenger’s Temperature Controls):Press
the up or down buttons closest to the passenger to
manually increase or decrease the temperature for
the front passenger. If the passenger’s climate control
system is off, pressing either of these buttons turns it on.
Manual Operation
9(Fan):Turn the left control to adjust the fan speed
manually if the automatic setting is higher or lower than
desired. The fan speed remains at this level until you
return to AUTO or adjust to a different level. In the
automatic position, the blower might go to a lower speed
during an OnStar
®session to limit the background noise.
To change the current mode, select one of the following
positions using the right control:
AUTO:Turn the control to this position to turn on the
automatic delivery mode operation.
F(Vent):Turn the control to this position so that air is
directed to the instrument panel outlets.
*(Bi-Level):Turn the control to this position so
that the air is directed to the instrument panel outlets
and the oor outlets. The temperature of the air to
the oor will be warmer than the air to the upper outlets.
7(Floor):Turn the control to this position so that most
of the air is directed to the oor outlets with some air
directed to the outboard outlets, side window outlets,
and defroster outlet.
W(Defog):Turn the control to this position so that air
is directed between the windshield and oor outlets,
with some air going to the outboard outlets and
side window outlets. More information of defogging
can be found later in this section.
0(Defrost):Turn the control to this position so
that most of the air is directed to the windshield with
some air going to the side window outlets. More
information on defrosting can be found later in this
section.
O(On/Off):Press this button to turn the climate
control system on or off. While off, adjusting any button or
control, except recirculation and rear window defog turns
the system back on. The air inlets default to outside air
when the climate control system is turned off.
3-24

PASS (Passenger’s Climate Control):Press this
button to turn the passenger’s climate control system on
or off. Then press the up or down buttons to choose the
desired setting. Pressing the button again automatically
sets the passengers temperature to the drivers setting.
Turning the passenger’s temperature display off does not
turn off the climate control system for the passenger.
Recirculation Operation
There are three options for bringing air into the
climate control system. They are controlled by
pressing the center button on the climate control panel.
The climate control display indicates one of the following
three modes:
9(Auto Air Inlet):This mode lets the automatic
climate control system choose the best air inlet position
for cooling or warming the vehicle. To have full automatic
climate control, the fan and mode controls must be set to
the AUTO position. Generally, recirculation will only
automatically be selected on hot days.Your vehicle may have an optional Air Quality Sensor.
To activate the air quality sensor, the auto air inlet setting
must be used. For more information, see Air Quality
Sensor found later in this section.
?(Recirculation):This mode recirculates air inside
the vehicle and keeps outside air from coming into
the vehicle. It can be used to help cool the vehicle more
quickly or to prevent odors from entering the vehicle.
Recirculation is not available in the defrost mode.
It is also cancelled when oor or defog mode is selected.
In some conditions using recirculation for long periods
of time can cause the air inside the vehicle to become
too dry or stuffy. To prevent this from happening,
after the air in the vehicle has cooled, select auto
air inlet or outside air.
:(Outside Air):This mode pulls fresh air from
outside the vehicle. Outside air is always selected
in defrost mode to prevent fogging.
3-25

Fuel Gage
The fuel gage shows
approximately how much
fuel is in the fuel tank.
It works only when
the engine is on.
If the fuel supply gets low, the FUEL LEVEL LOW
message will appear on the Driver Information Center
(DIC) and a single chime will sound. SeeDIC Warnings
and Messages on page 3-53for more information.
All of the following situations are normal and do
not indicate that anything is wrong with the fuel gage:
At the gas station the gas pump shuts off before
the gage reads full.
The gage may change when you turn, stop quickly
or accelerate quickly.
It takes a little more or less fuel to ll the tank than
the gage indicated. For example, the gage may
have indicated that the tank was half full, but
it actually took a little more or less than half the
tank’s capacity to ll the tank.
Driver Information Center (DIC)
The Driver Information Center (DIC) gives you the status
of many of your vehicle’s systems. The DIC is also used
to display warning/status messages. All messages will
appear in the DIC display located at the bottom of the
instrument panel cluster, below the tachometer and
speedometer. The DIC buttons are located on the
instrument panel, to the left of the steering wheel.
The DIC comes on when the ignition is on. After a short
delay, the DIC will display the information that was
last displayed before the engine was turned off.
The top line of the DIC display shows the vehicle system
information and the warning/status messages. The
bottom line of the DIC display shows the odometer on
the left side, the outside air temperature on the right side,
and the shift position indicator in the center. For more
information on the shift position indicator, seeAutomatic
Transmission Operation on page 2-30.
3-47