2008.5 Citroen C5 DAG battery
[x] Cancel search: batteryPage 62 of 306
76
4
A C C E S S
BOOT (SALOON)
Press upwards on lever 1 and lift
up the boot. With the vehicle stationary, this is
carried out using:
- The remote control.
- The key in a door lock.
- The interior central locking/
unlocking control.
The boot automatically locks when
the vehicle is moving at a speed of
over 6 mph (10 km/h), even if auto-
matic central locking is deactivated.
It is unlocked when a door is opened
or when the central locking button is
pressed (speed lower than 6 mph
(10 km/h)).
Opening
Locking/unlocking Tailgate release
System for mechanical unlocking of
the boot in the event of a battery or
central locking malfunction.
Unlocking
Fold back the rear seats to gain
access to the lock from inside
the boot.
Insert a small screwdriver into
hole A of the lock to unlock the
tailgate.
Push the white part, located in-
side the lock, to the left to unlock
the boot.
Page 65 of 306
79
4
A C C E S S
PANORAMIC SUN ROOF (SALOON)
This sun roof provides optimum light
and visibility in the passenger com-
partment.
Sun roof closed
- Press B t o fi r s t n o t c h : t i l t i n g .
- Press B to second notch: auto-
matic complete tilting.
- Press A t o fi r s t n o t c h : s l i d i n g
towards rear.
- Press A to second notch: auto-
matic total sliding towards rear. Sun roof open
- Press
B t o fi r s t n o t c h : c l o s u r e .
- Press B to second notch: auto-
matic total closure.
Always remove the ignition key
when leaving the vehicle, even if
for a short time.
In the event of anything being
caught by the sun roof closing, you
must reverse the roof movement.
To do that, reverse the position of
the control concerned.
When the driver is operating the sun
roof, he or she must always make
sure that the passengers are not
preventing it from closing properly.
The driver must ensure that pas-
sengers use the sun roof control
correctly.
Pay special attention to where children
are when operating the sun roof.
T h e fi t t i n g o f a s u n r o o f a s a n a c c e s -
sory is prohibited.
Operation
Tilted sun roof
- Press
A t o fi r s t n o t c h : c l o s u r e .
- Press A to second notch: auto-
matic total closure.
Y o u r s u n r o o f i s fi t t e d w i t h a m a n u a l l y -
operated blind.
Anti-pinch
An anti-pinch device stops the sun
roof from closing, whether sliding or
tilting. If it meets an obstacle, it re-
opens. Reinitialisation
After a battery disconnection or if
there has been a malfunction, you
have to re-initialise the anti-pinch
function.
move control B until the roof is in
the complete tilting position,
keep control B pressed down for
a minimum of 1 second.
During these operations, the anti-
pinch function does not operate.
Page 66 of 306
80
4
A C C E S S
GLASS PANORAMIC ROOF (TOURER)
This device comprises a tinted glass
panoramic surface 1 to improve
brightness and vision in the passenger
compartment.
I t i s fi t t e d w i t h a n e l e c t r i c a l b l i n d 2
to help maintain a comfortable tem-
perature and reduce noise. Opening
Press control A .
Pressing to the 1st notch allows you
to open the blind step by step.
Pressing to the 2nd notch allows
you to fully open the blind.
The blind stops in the closest pre-
d e fi n e d p o s i t i o n ( 1 1 p o s i t i o n s ) a s
soon as you release the control.
Closing
Press control B .
Press to the fi r s t n o t c h to close the
blind step by step.
Press to the second notch to close
the blind completely.
The blind stops at the nearest pre-
set position (11 positions) as soon as
you release the control. After a battery disconnection, or if
there has been a malfunction, you
have to re-initialise the anti-pinch
function:
press control B to the 2 nd
notch
(fully closed),
wait until the blind is fully
closed,
press control B for at least 3 seconds.
If the blind opens randomly during a
closing operation, and straight after
the blind stops:
Press control B until the blind
closes fully.
During these operations, the anti-
pinch function does not operate.
In the event of anything being
caught when the blind is moving,
you must reverse the movement of
the blind. To do so, reverse the po-
sition of the control.
When the driver is operating the
blind, he or she must always make
sure that the passengers are not
preventing it from closing properly.
The driver must ensure that his pas-
sengers are using the blind correctly.
Pay special attention to children
when operating the blind.
Anti-pinch
If the blind meets an obstacle whilst
closing, it stops and opens partially
again.
You must re-initialise the anti-pinch
function within 5 seconds of the
blind stopping:
press control B until the blind is
fully closed (closing in steps of a
few centimetres).
SEQUENTIAL ELECTRICAL BLIND
Page 70 of 306
84
V I S I B I L I T Y
5
C. fog lamps selection ring.
The fog lamps operate with the side
lights and the dipped and main beam
headlamps.
- 1 st turn forwards: lighting of rear foglamps.
- 1 st turn rearwards: extinction of rear foglamps. - 1 st turn forwards: lighting of front
foglamps.
- 2 nd turn forwards: lighting of rear foglamps.
- 1 st turn rearwards: extinction of rear foglamps.
- 2 nd turn rearwards: extinction of front foglamps.
Model with rear foglamps
only
Model with front and rear
foglamps In good or rainy weather, both day
and night, the front fog lamps and
the rear fog lamps are prohibited.
In these situations, the power of
their beams may dazzle other driv-
ers. They should only be used in
fog or snow.
In these weather conditions, it is
your responsibility to switch on the
fog lamps and dipped headlamps
manually as the brightness sensor
m a y d e t e c t s u f fi c i e n t l i g h t .
Do not forget to switch off the front
fog lamps and the rear fog lamps
when they are no longer neces-
sary.
Lights on buzzer
The triggering of an audible signal
when a front door is opened warns
the driver that he has forgotten to
switch off his vehicle's lights, with
the ignition off and in manual lights
mode.
In this case, switching off the lights
stops the audible signal.
With the ignition off, if the dipped
headlamps remain on, they will
switch off automatically after thirty
minutes to prevent discharging of
the battery.
Page 94 of 306
98
6
L A Y O U T
BOOT LAYOUT (SALOON)
1. Battery for vehicles with V6 HDi
engine.
2. Pull strap (spare wheel storage).
3. Boot lamp.
4. 6 CD changer. Luggage securing rings
Use the 4 securing rings on the
b o o t fl o o r t o s e c u r e y o u r l u g g a g e .
F o r s a f e t y r e a s o n s , i n c a s e o f t h e
n e e d f o r s h a r p b r a k i n g , y o u a r e
a d v i s e d t o p l a c e h e a v y o b j e c t s a s
f a r f o r w a r d i n t h e b o o t a s p o s s i b l e .
Page 95 of 306
99
6
L A Y O U T
BOOT LAYOUT (TOURER)
1. Hook
A l l o w s y o u t o h o o k s h o p p i n g b a g s .
2. Torch
T o r e c h a r g e , r e t u r n i t t o i t s s t o r - age position.
3.
Storage net or Battery compart-
ment (for vehicles with V6 2.7 HDi
engine).
T h i s p r o v i d e s a c c e s s t o t h e b a t t e r y .
1. Luggage-cover blind
(see details on following page)
2. Luggage securing rings
Use the 4 stowing rings provided o n t h e b o o t fl o o r t o s e c u r e y o u r
loads.
For safety reasons in the event o f s h a r p b r a k i n g , y o u a r e a d -
v i s e d t o p l a c e h e a v y o b j e c t s a s
f a r f o r w a r d s a s p o s s i b l e .
3. Hooks
T h e s e a l l o w a c a r g o n e t t o b e fi t t e d (see details on following page).
1. Boot lamp
2. 12 V accessories socket
(100 W maximum)
C i g a r - l i g h t e r t y p e 1 2 v o l t s s o c k e t . It is located on the rear right-hand
t r i m , a n d i s s u p p l i e d f r o m t h e i g n i -
tion position.
3. Loading assistance
You can change the height of the v e h i c l e i n o r d e r t o m a k e l o a d i n g
or unloading easier.
4. Hook
A l l o w s y o u t o h o o k s h o p p i n g b a g s .
5. Storage net or 6 CD changer
Page 124 of 306
125
9
D R I V I N G
Release
With the ignition on or the engine
running, to release the parking
brake, press on the brake pedal,
push then release control A .
The full application of the parking
b r a k e i s c o n fi r m e d b y : - the extinction of the warn-ing lamp on control A and
of warning lamp P on the
instrument panel,
- the display of a message "park- ing brake released" on the instru-
ment panel display.
If you push control A without press-
ing the brake pedal, the parking
brake will not be released and the
message "Foot on brake necessary"
will be displayed on the instrument
panel.
When stationary, with the
engine running, do not
press the accelerator pedal
unnecessarily, as you may
release the parking brake. Maximum application
If necessary, you can utilise
maxi-
mum application of the parking
brake. It is obtained by means of a
long pull on control A , until you see
the message "Max application of the
parking brake" and a beep is heard.
Maximum application is essential:
- in the case of a vehicle towing a caravan or a trailer, if the au-
tomatic functions are activated
but you are applying the parking
brake manually,
- when the gradient you are parked on is variable in its effect (e.g. on
a ferry, in a lorry, during towing).
- In the case of towing, a loaded vehicle or parking on a gradient,
turn the front wheels towards the
pavement and engage a gear
when you park.
- After a maximum application, the release time will be longer. Particular situations
In certain situations (starting the
engine...), the parking brake can
automatically alter its force. This is
normal operation.
To advance your vehicle a few cen-
timetres without starting the engine,
but with the ignition on, press on the
brake pedal and release the parking
brake
by pushing then releasing
control A .
The full release of the parking brake
i s c o n fi r m e d b y t h e e x t i n c t i o n o f
warning lamp P (red) on the instru-
ment panel and the display of a
message "parking brake released"
on the instrument panel display.
If the parking brake malfunctions
while applied or if the battery
r u n s fl a t , an emergency release is
always possible.
To guarantee correct operation of
the parking brake and therefore
your safety, the number of succes-
sive application/release operations
is limited to eight.
If this number is exceeded, you are
warned by the message "Parking
brake faulty" and a warning lamp
fl a s h e s .
Page 125 of 306
126
9
D R I V I N G
Dynamic emergency braking
In the event of a failure of the vehi-
cle’s main braking system or in an
exceptional situation (e.g. driver tak-
en ill, under instruction, etc) pull and
hold control A to stop the vehicle.
The electronic stability programme
(ESP) provides stability during dy-
namic emergency braking.
If the dynamic emergency braking
malfunctions, one of the following
messages will be displayed on the
instrument panel display:
- "Parking brake faulty".
- "Parking brake control faulty". If a failure of the ESP sys-
tem is signalled by the light-
ing of this warning lamp,
then braking stability is not
guaranteed. In this event, stability
must be assured by the driver by
repeating alternate "pull release" ac-
tions on control A .
The dynamic emergency
braking must only be used
in exceptional circum-
stances. Emergency unlocking
In the event of the electronic parking
brake malfunctioning or the battery
r u n n i n g fl a t , a n e m e r g e n c y m a n -
ual device can unlock the parking
brake.
Immobilise the vehicle, with the
e n g i n e r u n n i n g , b y e n g a g i n g fi r s t
gear (manual gearbox) or posi-
tion P (automatic gearbox), then
switch off the engine.
If it is impossible to immobilise the vehicle, do not action the
control and urgently contact a
CITROËN dealer.