2008.5 Citroen C3 PICASSO Owner's Manual

LAYOUT
REAR INTERIOR LAYOUT
They are located on the back of the
front seats.
Two boxes are available, located under
the rear passenger footwells.
To open them, lift the lid using the
groove
A . There is a bottle-holder located at the
rear of the central console.
Storage boxes Seat pockets Bottle-holder

!
75
LAYOUT
It is located at the rear of the central
console if the lighter is installed in the
front.
12 volt socket (100 W max)
Lift up the control to release the table
and unfold it.
Aircraft style tables
Reading lamps are built into the back of
the front seats, behind the tables. With
the ignition on, they light up the top of
the table without inconveniencing other
passengers.
They are only accessible if the table is
unfolded.

 Press the button to switch the light
on or off.
Individual reading lamps
Do not place hard or heavy objects
on the table. They could become
dangerous projectiles in the event
of sharp braking or impact.
As a safety precaution, if too much
pressure is exerted the table will
fold back downwards.

LAYOUT Storage tray
Opening

 Lower the storage shelf.

 Press the fl ap opening control.

 Lower the fl ap.

 Load the objects from inside the
boot.
Ski flap
Device for storing and transporting long
objects.
Side blinds may be available on the
sliding side doors.
Pull the side blind by the tab to install
it.
Always guide the blind slowly using the
tab, both when raising and when lower-
ing.
Side blinds
When unfolded, this provides a storage
area split into 2 sections.

!
75
LAYOUT
It is located at the rear of the central
console if the lighter is installed in the
front.
12 volt socket (100 W max)
Lift up the control to release the table
and unfold it.
Aircraft style tables
Reading lamps are built into the back of
the front seats, behind the tables. With
the ignition on, they light up the top of
the table without inconveniencing other
passengers.
They are only accessible if the table is
unfolded.

 Press the button to switch the light
on or off.
Individual reading lamps
Do not place hard or heavy objects
on the table. They could become
dangerous projectiles in the event
of sharp braking or impact.
As a safety precaution, if too much
pressure is exerted the table will
fold back downwards.

LAYOUT Storage tray
Opening

 Lower the storage shelf.

 Press the fl ap opening control.

 Lower the fl ap.

 Load the objects from inside the
boot.
Ski flap
Device for storing and transporting long
objects.
Side blinds may be available on the
sliding side doors.
Pull the side blind by the tab to install
it.
Always guide the blind slowly using the
tab, both when raising and when lower-
ing.
Side blinds
When unfolded, this provides a storage
area split into 2 sections.

77
LAYOUT
BOOT LAYOUT

1. Storage net on left-hand boot trim.

2. Open storage compartments.

3. Torch.

4. Movable boot fl oor.

5. Carrier bag hook

6. Securing rings.

7. Storage area under boot carpet

8. Luggage cover.

i
78
LAYOUT
Movable boot floor
This movable boot fl oor with two posi-
tions allows you to:
- maximise the volume of the boot,
- partition the boot (storing of the rear shelf...),
- obtain a fl at fl oor from the boot opening to the front seats, when the
rear bench seat is in the retracted
position. Placing the movable boot fl oor in
the low position

 Press to release the handle located
at the boot opening.

 Unlock the movable boot fl oor by
lifting the handle.

 Manoeuvre the movable boot fl oor
rearwards, then downwards, using
the handle, following the slides on
the sides.

 Lock it by folding down the handle. Placing the movable boot fl oor in
the high position

 Press to release the handle.

 Unlock the movable boot fl oor by
lifting the handle.

 Use the handle to manoeuvre the
movable boot fl oor rearwards, then
upwards to its high position.

 Lock it by folding down the handle.
In the high position, the movable boot
fl oor permits storing of the rear shelf
and fragile objects.
The movable boot fl oor is fi tted with four
stowing rings to secure your loads using
the net available as an accessory.
Ensure that your boot is empty
before handling the movable boot
fl oor.

79
LAYOUT
Hooks
The hooks permit the securing of shop-
ping bags. Load space cover
This consists of three sections.
The front section is fl exible, and the
central and rear sections are rigid.
The rear section is secured to the tail-
gate by two cords.
To remove it from the boot:

 unhook the two cords,

 gently lift up the cover to remove it
from its fi xings,

 remove the cover.
It can be stored under the movable boot
fl oor, if this is in its high position.