2008.5 Citroen BERLINGO MULTISPACE Owner's Manual

Practical information
67
33
Overhead storage unit
This is located above the sun visors
and can accommodate various objects
(a jumper, fi le, gloves...).
The openings concealed by the sun
visors allow you to see and access the
objects stored in the overhead storage
unit.
The maximum weight permitted in the
overhead storage unit is 5 Kg.
Do not place objects in this storage
unit which could present a risk to the
occupants.
Central storage console
This console offers an appreciable
additional storage area: it can be
removed and clips onto a base which
also incorporates two cup holders at
the rear.
Ensure that the object (bottle, can...)
placed in the cup holder is retained
securely and does not risk being
dislodged while driving.
Any liquid which could spill presents
a risk of damage on contact with the
instrument panel and centre console
controls.
Take care. Sun visor
To prevent dazzle from ahead, fold the
sun visor down.
A pocket is provided in the driver’s sun
visor for storing toll cards, tickets, ...

68
Practical information
Drawers under seats
Your vehicle may be fi tted with a
drawer, under each front seat. Storage compartment under
seats
Storage compartments are available,
with or without lid, in the fl oor under the
front seats.
To gain access to them, move the seat
forward. The lid must be lifted from the
rear of the seat.
MODUBOX
To use the modubox, unhook the strap
then unfold the modubox unclipping on
each side.
To store the modubox, lift the base
before folding the sides.

Practical information
69
ERGONOMICS and COMFORT
33
SEATING AREA LAYOUT
Floor boxes
Two boxes are available, located under
the rear passenger footwells.
To open them, slide your fi ngers into
the recess and lift the lid. Aircraft style tables
To put the table in place, pull it
upwards and fold it down.
As a safety precaution, above a high
pressure, the table is designed to
unhook.
To put it back in place, with the table
vertical, engage one side then the
other, forcing slightly.
Do not place hard or heavy objects
on the table. They could become
dangerous projectiles in the event of
sharp braking or impact.
A bag hook is provided on the side of
each table. Side blinds
Side blinds may be available on the
sliding side doors.
Pull the side blind by the tab to install it.
To avoid damaging the blind when
opening the door, check that the tab is
hooked securely.
Always guide the blind slowly
using the tab, both when raising
and when lowering.

70
Practical information
MODUTOP
The multifunction roof extends the
overhead storage unit. It consists of
the following components: Storage compartments
Storage compartments are provided
on each side of the roof. The maximum
weight is 6 Kg.
The translucent base assists with
fi nding objects stored inside.
Do not store objects which could
present a risk to the occupants.
Courtesy light
The operation of the courtesy light is
identical to that of the front courtesy light.
Refer to the "Comfort and Safety"
section of chapter 3, "Courtesy
lights" part.

Practical information
71
ERGONOMICS and COMFORT
33
From inside From outside
Rear box
This roof box can be accessed from
the rear seats and the boot.
From the rear seats, slide the fl aps to
open. Vents
A 3-position control allows you to
adjust the quantity of air discharged.
The temperature of the air diffused by
these vents is identical to that selected
for the front vents.
These vents are also fi tted with a
fragrance diffuser.
From the boot, place your thumb on
the recess then pull the handle to
open.
Open carefully to prevent objects
stored in this interior roof box from
falling out.
The maximum authorised weight is 10 Kg.

72
Practical information
The fragrance diffuser diffuses
a fragrance in the passenger
compartment from the roof console
vents.
Adjusting the flow
Turn the chromed button to adjust the
diffusion:
- to the left to decrease,
- to the right to increase.
To stop the diffusion, turn the chromed
button fully to the left. Removing the fragrance diffuser
- Press the button down while turning
it a quarter of a turn to the left to
the stop.
- Remove the fragrance diffuser from the roof console.
- Replace the cartridge.

Practical information
73
33
Replacing a cartridge
The fragrance diffuser refi ll consists of
a cartridge B and its sealing case C .
- Remove the protective fi lm D .
- Place the head of the cartridge B
on the button A of the fragrance
diffuser.
- Turn it a quarter of a turn to lock it on the button and remove the case.
- Insert the fragrance diffuser in its location.
You can change the cartridges at any
time and store cartridges which have
already been started in their original
case.
The fragrance diffuser button A is
independent of the cartridge.
The cartridges are supplied without the
button A . Inserting the fragrance diffuser
After fi tting or changing the cartridge:
- Put the fragrance diffuser back in
place in its location.
- Turn it a quarter of a turn to the right. Good practice
As a safety precaution, only use the
cartridges provided for this purpose.
Do not dismantle the cartridges.
Keep the cartridge sealing cases
which are used as packaging when the
cartridges are not in use.
Never try to refi ll the cartridges
with fragrances other than those
recommended by the CITROËN
network.
Keep out of reach of children and
animals. Avoid contact with the skin
and eyes. If swallowed, consult a
doctor and show him the packaging or
product label.
The fragrance diffuser button
A can
only be fi xed on the multifunction roof
console with a cartridge.
Therefore, always retain button A and
a cartridge.
The cartridges are available from
CITROËN dealers.

74
Practical information
MODUTOP ROOF BARS
These two longitudinal Modutop roof
bars can be removed. The maximum authorised weight on
each bar is 35 kg.
In all cases, the load must rest on
the non-slip bands provided for this
purpose and must not touch the roof or
the glazing of the roof.

Recommendations for loading on
the roof:
- Open the protective covers.
- Use the screwdriver (stored in the tool kit under the right-hand seat) to
remove the 4 bolts.
- Turn the bars 90° placing the hollow parts towards the front.
- Tighten the 4 bolts.
- Close the protective covers.
- Use the strap passages A only to
secure the load fi rmly.