Page 35 of 90
Features and functions
28
The current display will continue to operate
for 25 seconds after the engine stops.
EJU31460Tachometer
The engine speed (r/min) is displayed by seg-
ments. Each segment indicates a 250 r/min
increment.
EJU31500Speedometer
The meter shows the watercraft speed
against water.
NOTE:
To switch the speedometer display between
kilometers and miles, push the select button
for at least 1 second, within 10 seconds after
the meter is displayed.
EJU31510Fuel level meter
The fuel level meter is provided for convenient
fuel level checking while riding.The fuel level meter has eight segments
which show the amount of fuel remaining in
the fuel tank.
NOTE:
The fuel level is most accurate when the wa-
tercraft is sitting level on a trailer or in the wa-
ter.
EJU31530Hour meter/voltmeter
NOTE:
To switch the display between the hour meter
and the voltmeter, push the select button for
at least 1 second after the meter is displayed
for more than 10 seconds.
Hour meter
The hour meter is provided to make it easy to
follow the maintenance schedule.
1Select button
1Select button
UF1G74E0.book Page 28 Monday, July 31, 2006 10:10 AM
Page 53 of 90
Operation
46
(1) Launch the watercraft and start the en-
gine. (See page 46 for engine starting
procedures.)
(2) Run the engine at trolling speed for 5 min-
utes.
(3) Gradually apply throttle and run the en-
gine at 5000 r/min or less.
(4) Operate the watercraft at 5000 r/min or
less for the first tankful of fuel.
(5) Fill the fuel tank with straight gasoline,
and then proceed with normal operation.
CAUTION:
ECJ00430
Failure to follow the engine break-in pro-
cedure could result in reduced engine life
or even severe engine damage.
EJU32820Launching the watercraft
When launching the watercraft, make sure
that there are no obstacles around you.
After the watercraft is in the water, turn it
around so that the bow faces the direction you
wish to go. Start the engine, and then slowly
move away from the launching area. If there
are waves, someone should make sure that
the watercraft is not pushed into the trailer af-
ter launching the watercraft.
EJU32840Starting the engine
WARNING
EWJ00560
Never start the engine or let it run for any
length of time in an enclosed area. Ex-
haust fumes contain carbon monoxide, a
colorless, odorless gas that may cause
loss of consciousness and death within a
short time. Always operate the watercraft
in an open area.
(1) Launch the watercraft in water free from
weeds and debris and at least 60 cm (2 ft)
deep.
WARNING
EWJ00570
Never operate in water that is less than 60
cm (2 ft) deep, otherwise you increase
your chance of hitting a submerged ob-
ject, which could result in injury.
CAUTION:
ECJ00470
Never operate in water that is less than 60
cm (2 ft) deep, otherwise pebbles or sand
could be sucked into the jet intake, caus-
ing impeller damage and engine overheat-
ing.
UF1G74E0.book Page 46 Monday, July 31, 2006 10:10 AM
Page 66 of 90
Operation
59
(12) Allow the engine compartment to air dry
completely before installing the seat.
NOTE:
Cover the watercraft after the engine and cat-
alytic converter have cooled down.
EJU33430
Transporting
When transporting the watercraft on a trailer,
secure the tie downs to the trailer through the
bow eye and stern rope holes.
CAUTION:
ECJ00610
Do not route ropes or tie downs over the
seat, as they may leave permanent marks
on the seat’s surface. Also, wrap the ropes
or tie downs with towels or rags where
they touch the body of the watercraft to
avoid scratching or damage.
UF1G74E0.book Page 59 Monday, July 31, 2006 10:10 AM
