2007 VOLVO XC70 light

2007 Volvo XC70
pg. 180 Vehicle care
Washing and cleaning the car
In order to maintain the coating's water repellent characteristics, it s\
hould be treated with a special
compound that is available at your Volvo retailer.
This treatment should be carried out for the first time after three year\
s, and thereafter once a year.
pg. 181 Vehicle care
Washing and cleaning the car
Cleaning the upholstery
Fabric
Clean with soapy water or a detergent. For more difficult spots caused b\
y oil, ice cream, shoe polish,
grease, etc., use a clothing/ fabric stain remover. Consult your Volvo r\
etailer.
Interior plastic components
Cleaning interior plastic components should be done with a cleaning agen\
t specially designed for this
purpose. Consult your Volvo retailer.
Alcantera™ suede-like material
Suede-like upholstery can be cleaned with a soft cloth and mild soap sol\
ution.
Leather care
Volvo's leather upholstery is manufactured with a protectant to repel so\
iling. Over time, sunlight, grease
and dirt can break down the protection. Staining, cracking, scuffing, an\
d fading can result.
Volvo offers an easy-to-use, non-greasy leather care kit formulated to c\
lean and beautify your vehicle's
leather, and to renew the protective qualities of its finish. The cleane\
r removes dirt and oil buildup. The
light cream protectant restores a barrier against soil and sunlight.
Volvo also offers a special leather softener that should be applied afte\
r the cleaner and protectant. It
leaves leather soft and smooth, and reduces friction between leather and\
other finishes in the vehicle.
Volvo recommends cleaning, protecting and conditioning your vehicle's le\
ather two to four times a year.
Ask your Volvo retailer about Leather Care Kit 951 0251 and Leather Soft\
ener 943 7429.
file:///K|/ownersdocs/2007/2007_XC70/07xc70_08.htm (4 of 7)12/30/2006 \
5:51:41 PM

2007 Volvo XC70
pg. 185 Maintenance and servicing
Maintaining your car
Owner maintenance
Periodic maintenance requirements and intervals are described in your ve\
hicle's Warranty and Service
Records Information booklet.
The following points can be carried out between the normally scheduled m\
aintenance services.
Each time the vehicle is refueled:
l Check the engine oil level
l Clean the windshield, windshield wipers, headlights, and tail lights
Monthly:
l Check cold tire pressure in all tires. Inspect the tires for wear.
l Check that engine coolant and other fluid levels are between the indicat\
ed "min" and "max" markings.
l Clean interior glass surfaces with a glass cleaner and soft paper towels\
.
l Wipe driver information displays with a soft cloth.
l Visually inspect battery terminals for corrosion. Corrosion may indicate\
a loose terminal connector, or
a battery near the end of its useful service life. Consult your Volvo re\
tailer for additional information.
As needed:
l Wash the vehicle, including the undercarriage, to reduce wear that can b\
e caused by a buildup of dirt,
and corrosion that can be caused by salt residues.
l Clean leaves and twigs from air intake vents at the base of the windshie\
ld, and from other places
where they may collect.
NOTE: Complete service information for qualified technicians is available onl\
ine for purchase or
subscription at
www.volvotechinfo.com.
pg. 186 Maintenance and servicing
Emission inspection readiness
What is an Onboard Diagnostic System (OBD II)?
OBD II is part of your vehicle's computerized engine management system. \
It stores diagnostic
information about your vehicle's emission controls. It can light the Che\
ck Engine light (MIL) if it detects
an emission control "fault." A "fault" is a component or system that is \
not performing within an expected
range. A fault may be permanent or temporary. OBD II will store a messag\
e about any fault.
file:///K|/ownersdocs/2007/2007_XC70/07xc70_09.htm (3 of 38)12/30/2006\
5:51:43 PM

2007 Volvo XC70
How do states use OBD II for emission inspections?
Many states connect a computer directly to a vehicle's OBD II system. Th\
e inspector can then read
"faults." In some states, this type of inspection has replaced the tailp\
ipe emission test.
How can my vehicle fail OBD II emission inspection?
Your vehicle can fail OBD II emission inspection for any of the followin\
g reasons.
l If your Check Engine (MIL) light is lit, your vehicle may fail inspect\
ion.
l If your vehicle's Check Engine light was lit, but went out without any a\
ction on your part, OBD II will
still have a recorded fault. Your vehicle may pass or fail, depending on\
the inspection practices in your
area.
l If you had recent service that required disconnecting the battery, OBD I\
I diagnostic information may
be incomplete and "not ready" for inspection. A vehicle that is not read\
y may fail inspection.
How can I prepare for my next OBD II emission inspection?
l If your Check Engine (MIL) light is lit - or was lit but went out with\
out service, have your vehicle
diagnosed and, if necessary, serviced by a qualified Volvo technician.
l If you recently had service for a lit Check Engine light, or if you had \
service that required
disconnecting the battery, a period of driving is necessary to bring the\
OBD II system to "ready" for
inspection. A half-hour trip of mixed stop-and-go/ highway driving is ty\
pically needed to allow OBD II
to reach readiness. Your Volvo retailer can provide you with more inform\
ation on planning a trip.
l Maintain your vehicle in accordance with your vehicle's maintenance sche\
dule.
pg. 187 Maintenance and servicing
Working on your car
Note the following before you begin working on your vehicle
file:///K|/ownersdocs/2007/2007_XC70/07xc70_09.htm (4 of 38)12/30/2006\
5:51:43 PM

2007 Volvo XC70
WARNING!
Never remove the radiator cap while the engine is warm. Wait until the v\
ehicle
cools.
pg. 189 Maintenance and servicing
Hood and engine compartment
Opening the hood
- Pull the lever located under the left side of the dash to release the \
hood lock.
- Lift the hood slightly.
- Press up the release control located under the front edge of the hood \
(at the center) and lift.
WARNING!
Check that the hood locks properly when
closed!
file:///K|/ownersdocs/2007/2007_XC70/07xc70_09.htm (7 of 38)12/30/2006\
5:51:43 PM

2007 Volvo XC70
CAUTION!
- Not checking the oil level regularly can result in serious engine dama\
ge if the oil level becomes too
low.
- Never fill oil above the MAX mark. This could cause an increase in oil\
consumption.
- Not checking the oil level regularly can result in serious engine dama\
ge if the oil level becomes too
low.
- Always add oil of the same type and viscosity as already used.
WARNING!
Do not allow oil to spill onto or come into contact with hot exhaust pip\
e
surfaces.
R-models
R-models are equipped with an oil level warning system. If the engine oi\
l level becomes too low, the
warning light in the instrument panel will come on and a warning will be\
displayed in the text window.
l If the yellow warning light in the instrument panel comes on and the tex\
t OIL LEVEL LOW/FILL
OIL is displayed, stop safely as soon as possible and add 1 qt (1 liter\
) of oil. Check the oil level with the
dipstick before restarting the engine.
l If the red warning light in the instrument panel comes on and the text O\
IL LEVEL LOW/STOP
SAFELY-->STOP ENGINE -->SEE MANUAL is displayed, stop safely as soon as \
possible and add oil
(not more than 1.6 qts (1.5 liters). Check the oil level with the dip\
stick before restarting the engine. If no
oil level is visible on the dipstick, do not start the engine. Have the \
vehicle towed to an authorized Volvo
retailer.
pg. 192 Maintenance and servicing
Fluids
file:///K|/ownersdocs/2007/2007_XC70/07xc70_09.htm (11 of 38)12/30/200\
6 5:51:43 PM

2007 Volvo XC70
Windshield wiper blades
- Lift the wiper arm off the windshield.
- Press in the catches (A in the illustration above).
- Pull out the wiper blade.
- Insert a new wiper blade and ensure that it is firmly in place.
The driver's side wiper blade is longer than the one on the passenger's \
side.
Headlight wiper blades (certain models)
Pull the wiper blade in the direction indicated by the arrow in the illu\
stration to remove it. Press the new
wiper blade into place. The long section of the blade should point towar\
d the grille. Check that the new
blade is properly attached to the wiper arm.
pg. 195 Maintenance and servicing
Battery
file:///K|/ownersdocs/2007/2007_XC70/07xc70_09.htm (15 of 38)12/30/200\
6 5:51:43 PM

2007 Volvo XC70
Battery maintenance
The battery in your vehicle is located under the floor of the trunk.
Driving habits and conditions, climate, the number of starts, etc. all a\
ffect the service life and function of
the battery. In order for your battery to perform satisfactorily, keep t\
he following in mind:
l Check the fluid level in each cell in the battery every 24 months or eve\
ry 15,0001 miles (24,000 km),
whichever is sooner. The fluid should be at the level shown in the illus\
trations (A)
2. Do not overfill.
l Use a screw driver to open the caps or cover and a flashlight to inspect\
the level.
l If necessary, add distilled water. The level should never be above the i\
ndicator (A).
l The fluid level should be checked if the battery has been recharged.
l After inspection, be sure the cap over each battery cell or the cover is\
securely in place.
l Check that the battery cables are correctly connected and properly tight\
ened. Route ventilation hose
through opening in floor (see
page 197)
l Never disconnect the battery when the engine is running, for example whe\
n changing the battery.
l The battery should be disconnected from the vehicle when a battery charg\
er is used directly on the
battery.
l However, if the battery is being charged via the connecting points in th\
e engine compartment (see
file:///K|/ownersdocs/2007/2007_XC70/07xc70_09.htm (16 of 38)12/30/200\
6 5:51:43 PM

2007 Volvo XC70
Replacing the battery
- Switch off the ignition and remove the key.
- Wait at least 5 minutes after switching off the ignition before discon\
necting the battery so that all
information in the vehicle's electrical system can be stored in the cont\
rol modules.
- Remove the bolts on the retaining bracket over the battery and lift ou\
t the bracket.
- Fold up the plastic cover over the negative (ground) battery termina\
l. or unscrew the cover over the
battery.
- Disconnect the negative cable.
- Lift off the plastic cover if necessary and disconnect the positive ca\
ble.
- Pull the ventilation hose from the battery.
- Lift out the old battery.
Installing a new battery
- Put a new battery into place.
- Put the lower retaining bracket in place and retighten the bolt.
- Reconnect the positive cable.
- Press the cover for the positive battery terminal into place and fold \
down the lid of the plastic cover.
- Connect the negative (ground) cable and fold down the plastic cover \
if applicable.
- Be sure that the ventilation hose is securely connected to the battery\
and that the other end of the hose
is properly routed through the ventilation opening in the floor of the b\
attery compartment (see the
illustration).
- Reinstall the retaining bracket over the battery and retighten the nut\
s.
WARNING!
Ventilation hose:
l The battery generates hydrogen gas, which is flammable and explosive. Th\
e battery is fitted with a
ventilation hose which vents hydrogen gas out of the battery compartment\
through a ventilation
opening in the bottom of this compartment. If the battery must be replac\
ed, it is essential that the
ventilation hose is properly connected to the battery and that it is rou\
ted through the ventilation
opening provided (see illustration).
l Be sure the ventilation hose is free of debris.
l Only use replacement batteries equipped with a ventilation hose. Consult\
your Volvo retailer.
NOTE: After the battery has been disconnected or replaced, lock and unlock th\
e vehicle with the central
locking system's remote control to reactivate such features as the power\
windows, moonroof, courtesy
lighting, etc.
file:///K|/ownersdocs/2007/2007_XC70/07xc70_09.htm (19 of 38)12/30/200\
6 5:51:43 PM