Wheels and Tyres
200
Ty re l i fe
The life of your tyres very much depends on the following points:
Tyre pressure
The working life of tyres will be shortened considerably if the tyres are insufficiently
or over-inflated and this will have an advers e effect on the handling of your vehicle.
Correctly inflated tyres are of particular importance when travelling at high speeds .
It is therefore good to check the pressure at least once a month and also before
setting off on a long trip. Please do not forget the spare wheel when checking the
tyres. The tyre inflation pressures for summer tyres are indicated on the inside of the fuel
filler flap
⇒fig. 183 . The inflation pressures for winter tyres are 20 kPa (0.2 bar)
higher than those for summer tyres ⇒page 203.
The tyre pressure should be at the highest pressure specified for your vehicle at all
times.
On cars with full wheel trim, valve extensions are fitted in place of dust caps
⇒ fig. 184 . It is not nece ssary to unscrew the valve extensions in order to check and
alter the inflation pressure of the tyre.
Always check the inflation pressure of ty res when cold. Do not reduce the higher
pressure of warm tyres. Adapt the inflation pressure of the tyres accordingly if your
vehicle is carrying a signi ficantly higher payload.
Driving style
Fast cornering, sharp acceleration and brak ing (squealing tyres) increase wear-and-
tear on your tyres.
Balancing wheels
The wheels of a new vehicle are balanced. There are a wide range of influences
when driving which may result in an imbalance and which makes themselves felt
through vibration in the steering.
You should have the wheels rebalanced since any imbalance increases wear-and-
tear on the steering, the suspension and tyres. A wheel must also be rebalanced
when a new tyre is fitted and each time a tyre is repaired.
Wheel alignment errors
Incorrect wheel alignment at the front and rear will not only increase wear-and-tear
on the tyres but will also has an adverse effect on vehicle safety. Contact your
specialist garage if you no tice any unusual tyre wear.
WARNING
•If the inflation pressure is too low, the tyre must perform a greater flexing
work. At higher speeds the tyre will warm up as a result of this. This can
result in tread separation and even a tyre blowout.
•Immediately replace the damaged rims or tyres.
B1Z-0042HB1Z-0042H
Fig. 183 An opened fuel
filler flap with the tyre
inflation pressure table
Fig. 184 Wheel with full
trim and extended valve
NKO B5 20.book Page 200 Friday, March 2, 2007 1:46 PM
