2007 PONTIAC GRAND PRIX fuse

Heated Seats
If the vehicle has this
feature, the buttons are
located on the climate
control panel. See
Climate Control System
on page 157for
more information.
Press the button once to activate the high heat
setting. Both indicator lights next to the button will
come on.
Press the button again to select the lower
temperature setting. Only the bottom indicator light
will come on.
Press the button a third time to turn the heat off.
This feature only works when the ignition is on.
Reclining Seatbacks
{CAUTION:
You can lose control of the vehicle if you
try to adjust a manual driver’s seat while
the vehicle is moving. The sudden
movement could startle and confuse you,
or make you push a pedal when you do
not want to. Adjust the driver’s seat only
when the vehicle is not moving.
{CAUTION:
If the seatback is not locked, it could
move forward in a sudden stop or crash.
That could cause injury to the person
sitting there. Always push and pull on the
seatback to be sure it is locked.
10

PASS-Key®III Operation
The vehicle is
equipped with
PASS-Key
®III
(Personalized
Automotive Security
System) theft-deterrent
system. PASS-Key
®III
is a passive
theft-deterrent
system.
This means nothing special needs to be done to
arm or disarm the system. It works when the key is
inserted or removed from the ignition.
PASS-Key
®III uses a transponder in the ignition
key that matches a decoder in the vehicle.
When the PASS-Key
®III system senses that the
wrong key has been inserted into the ignition, it
shuts down the vehicle’s starter and fuel systems.The starter will not work and fuel will stop owing to
the engine. If someone tries to start the vehicle
again with the wrong key, the vehicle will not start.
Anyone using a trial-and-error method to start the
vehicle will be discouraged to do so because of the
high number of electrical key codes.
When trying to start the vehicle, if the engine does
not start and the STARTING DISABLED DUE TO
THEFT SYSTEM warning message on the Driver
Information Center (DIC) comes on, the key may
have a damaged transponder. Turn the ignition off
and try again.
If the engine still does not start, and the key
appears to be undamaged, try another ignition key.
At this time, you may also want to check the fuse.
SeeFuses and Circuit Breakers on page 460.Ifthe
engine still does not start with the other key, the
vehicle needs service. If the vehicle does start, the
rst key may be faulty. See your dealer who can
service the PASS-Key
®III to have a new key made.
In an emergency, contact Roadside Assistance.
SeeRoadside Assistance Program on page 498for
more information.
103

The main components of the instrument panel are the following:
A. Side Window Defogger Outlets. SeeOutlet
Adjustment on page 166.
B. Air Outlets. SeeOutlet Adjustment on page 166.
C. Turn Signal/Multifunction Lever and Cruise
Controls. SeeTurn Signal/Multifunction Lever
on page 135andCruise Control on page 140.
D. TAP-Shift
®Control (If Equipped). See
Automatic Transaxle Operation on page 110.
E. Hazard Warning Flashers Button. See
Hazard Warning Flashers on page 134.
F. Instrument Panel Cluster. SeeInstrument Panel
Cluster on page 169.
G. Windshield Wiper Lever. SeeWindshield Wiper
Lever on page 138.
H. Ignition. SeeIgnition Positions on page 105.
I. Driver Information Center (DIC) (If Equipped).
SeeDriver Information Center (DIC) on
page 186.
J. Audio System. SeeAudio System(s) on
page 233.K. Audio Steering Wheel Controls (If Equipped).
SeeAudio Steering Wheel Controls on
page 277.
L. Hood Release. SeeHood Release on page 345.
M. Tilt Steering Wheel Lever, on Steering Column.
SeeTilt Wheel on page 135.
N. Interior Lamps Brightness Control. SeeInterior
Lamps on page 146.
O. Passenger Air Bag Status Indicator. See
Passenger Airbag Status Indicator on page 173.
P. Climate Controls. SeeClimate Control
System on page 157.
Q. Shift Lever. SeeAutomatic Transaxle Operation
on page 110.
R. Traction Control Button (If Equipped). See
Traction Control System (TCS) on page 292.
S. Head Up Display (HUD) Control (If Equipped).
SeeHead-Up Display (HUD) on page 151.
T. Glove Box. SeeGlove Box on page 126.
U. Instrument Panel Fuse Block. SeeInstrument
Panel Fuse Block on page 460.
133

Flash-to-Pass Feature. SeeFlash-to-Pass on
page 137.
ICruise Control. SeeCruise Control on
page 140.
PExterior Lamps Control. SeeExterior
Lamps on page 144.
Turn and Lane-Change Signals
To signal a turn, move the turn signal lever located
on the left side of the steering column all the
way up or down. The lever returns automatically
when the turn is complete.
An arrow on the
instrument panel cluster
will ash in the
direction of the turn or
lane change.
If the vehicle is equipped with the Head-Up-Display
(HUD), a right or left turn signal will appear in
the HUD area when making turns or lane changes.
SeeHead-Up Display (HUD) on page 151for
more information.Raise or lower the lever until the arrow starts to
ash to signal a lane change. Hold it there until the
lane change is complete. The lever returns to its
original position when it is released.
Arrows that ash rapidly when signaling for a turn
or lane change may be caused by a burned-out
signal bulb. Other drivers will not see the signal.
Replace burned-out bulbs to help avoid possible
accidents. SeeReplacement Bulbs on page 398,
Front Turn Signal, Parking and Fog Lamps on
page 394, andTaillamps, Turn Signal, and
Stoplamps on page 395. Also, check the fuse for
burned-out bulbs if a turn signal arrow fails to
work when signaling a turn. SeeFuses and Circuit
Breakers on page 460for location information.
Turn Signal On Chime
If the turn signal is left on for more than
0.75 of a mile (1.21 km), a warning chime will
sound and the TURN SIGNAL ON warning
message will appear on the Driver Information
Center (DIC) display. See “Turn Signal On” under
DIC Warnings and Messages on page 200.
136

The HUD image displayed on the windshield will
automatically dim and brighten to compensate
for outside lighting.
The HUD image can temporarily light up
depending on the angle and position of the
sunlight on the HUD display. This is normal and
will change when the angle of the sunlight on
the HUD display changes.
Polarized sunglasses could make the HUD image
harder to see.
Care of the HUD
Clean the inside of the windshield as needed to
remove any dirt or lm that could reduce the
sharpness or clarity of the HUD image.
To clean the HUD lens, use a soft, clean cloth that
has household glass cleaner sprayed on it.
Wipe the HUD lens gently, then dry it. Do not
spray cleaner directly on the lens because
the cleaner could leak into the unit.
If You Cannot See the HUD Image
When the Ignition Is On
Is anything covering the HUD lens?
Is the HUD dimmer setting bright enough?
Is the HUD image adjusted to the proper
height?
Are you wearing polarized sunglasses?
Still no HUD image? Check the fuse in the
instrument panel fuse block. SeeInstrument
Panel Fuse Block on page 460.
If the HUD Image Is Not Clear
Is the HUD image too bright?
Are the windshield and HUD lens clean?
If the HUD image is not correct, contact your
dealer.
Keep in mind that the windshield is part of the
HUD system. SeeWindshield Replacement
on page 399.
155

Accessory Power Outlet(s)
The vehicle has two
12-volt outlets which
can be used to plug in
electrical equipment.
One accessory power outlet is located on the
center console, below the front edge of the storage
console. The other is located inside the console.
Remove the tethered cap to use the outlet.
When not using the outlet, be sure to cover it with
the protective cap.
Notice:Leaving electrical equipment plugged
in for an extended period of time while the
vehicle is off will drain the battery. Power is
always supplied to the outlets. Always unplug
electrical equipment when not in use and
do not plug in equipment that exceeds
the maximum 20 ampere rating.Certain electrical accessories may not be
compatible with the accessory power outlet and
could result in blown vehicle or adapter fuses. See
your dealer for additional information on
accessory power outlets.
Notice:Adding any electrical equipment to
your vehicle may damage it or keep other
components from working as they should. The
repairs would not be covered by your
warranty. Do not use equipment exceeding
maximum amperage rating of 20 amperes.
Check with your dealer before adding electrical
equipment.
When adding electrical equipment, be sure to
follow the proper installation instructions included
with it.
Notice:Improper use of the power outlet can
cause damage not covered by your warranty.
Do not hang any type of accessory or
accessory bracket from the plug because the
power outlets are designed for accessory
power plugs only.
156

Ashtray(s) and Cigarette Lighter
Your vehicle may have a removable muffin
tin ashtray and cigarette lighter. The muffin tin
ashtray can be placed into the front center console
cupholder. To use the lighter, located on the
center console, push it in all the way and let go.
When it is ready, it will pop back out by itself.
Notice:Holding a cigarette lighter in while it
is heating will not allow the lighter to back
away from the heating element when it is hot.
Damage from overheating may occur to the
lighter or heating element, or a fuse could be
blown. Do not hold a cigarette lighter in
while it is heating.
Notice:If you put papers, pins, or other
ammable items in the ashtray, hot cigarettes
or other smoking materials could ignite
them and possibly damage your vehicle. Never
put ammable items in the ashtray.
Climate Controls
Climate Control System
The climate control system allows manual control
of the heating, cooling, and ventilation in the
vehicle.
157

Oil Pressure Light
If there is a problem
with the vehicle’s oil
pressure, this light may
stay on when the
engine is started.
It may also come on while the vehicle is being
driven. This indicates that the engine could be low
on oil or could have some other oil problem.
Have it xed right away.
The oil light could also come on in two other
situations:
When the ignition is on but the engine is not
running, the light will come on as a test to
indicate it is working. The light will go out when
the ignition is turned to RUN. If it does not come
on while the ignition is in the on position, there
may be a problem with the fuse or bulb. See
Fuses and Circuit Breakers on page 460.
If the brakes are applied quickly and the vehicle
makes a hard stop, the light may come on for a
moment. This is normal.
{CAUTION:
Do not keep driving if the oil pressure is
low. If you do, your engine can become so
hot that it catches re. You or others
could be burned. Check your oil as soon
as possible and have your vehicle
serviced.
Notice:Lack of proper engine oil maintenance
may damage the engine. The repairs would
not be covered by your warranty. Always follow
the maintenance schedule in this manual for
changing engine oil.
184