2007 PONTIAC GRAND PRIX instrument cluster

There is an airbag
readiness light on the
instrument panel cluster,
which shows the
airbag symbol.
The system checks the airbag electrical system for
malfunctions. The light tells you if there is an
electrical problem. SeeAirbag Readiness Light on
page 172for more information.Where Are the Airbags?
The driver’s frontal airbag is in the middle of the
steering wheel.
67

{CAUTION:
If the airbag readiness light in the
instrument panel cluster ever comes on
and stays on, it means that something may
be wrong with the airbag system. If this
ever happens, have the vehicle serviced
promptly, because an adult-size person
sitting in the right front passenger’s seat
may not have the protection of the frontal
airbag. SeeAirbag Readiness Light on
page 172for more on this, including
important safety information.
A thick layer of additional material such as a
blanket, or aftermarket equipment such as seat
covers, seat heaters, and seat massagers,
can affect how well the passenger sensing
system operates. Remove any additional
material from the seat cushion before reinstalling
or securing the child restraint and before
a small occupant, including a small adult,
sits in the passenger position.
77

4. Push either paddle once to up-shift to the next
gear. Pull either paddle once to down-shift to
the next gear.
The vehicle will begin moving in rst gear upon
acceleration. For better control in icy or slippery
conditions, the vehicle may start out in
SECOND (2), rather than FIRST (1). This
will only occur if you have “tapped up” to
second gear.
The up-shift light on the
instrument panel cluster,
or the up-shift symbol on
the HUD, if equipped, is
given as a prompt to use
the TAP-Shift
®paddle.
For more information, seeUp-Shift Light on
page 175.
The up-shift light will only appear in the instrument
panel cluster if the HUD is off or if the vehicle
does not have HUD.This prompt to up-shift, as needed, will be given
throughout acceleration. If up-shifting does not
occur when prompted, the vehicle speed will be
limited to protect the engine.
The gear position will display on the DIC and
HUD, if equipped, when in manual mode.
Pressing the accelerator while driving in the
highest gear (FOURTH (4)) between 20 mph
(32 km/h) and 50 mph (80 km/h), will make
the transaxle automatically downshift. As your
speed gets closer to 50 mph (80 km/h), you
will need to increase accelerator pedal travel to
get the vehicle to downshift. At 50 mph (80 km/h),
even with the accelerator fully depressed, the
transaxle will always remain in FOURTH (4). The
transaxle will also automatically downshift as
the vehicle decelerates and comes to a stop.
If a paddle is pushed or pulled and the vehicle
cannot respond to a transaxle gear change,
a chime will sound. The system will not allow either
an up-shift or a down-shift if the vehicle speed
is too fast or too slow, nor will it allow a start from
THIRD (3) or higher gear.
114

Parking Brake
The parking brake is
located to the left of the
brake pedal near the
driver’s door. To set the
parking brake, hold
the regular brake pedal
down with the right
foot. Push down on the
parking brake pedal,
with the left foot.
To release the parking brake, hold the regular
brake pedal down with the right foot and push the
parking brake pedal with the left foot. When the
left foot is lifted, the parking brake pedal will lift to
the released position.
A warning chime will sound if the parking brake is
set, the ignition is on, and the shift lever is not
in PARK (P) or NEUTRAL (N).The brake light will also appear on the instrument
panel cluster when the parking brake is set. It will
stay on if the parking brake does not release fully.
The PARKING BRAKE ON message will also
appear in the Driver Information Center (DIC)
when the parking brake is set. SeeDIC Warnings
and Messages on page 200for more information.
Notice:Driving with the parking brake on
can overheat the brake system and cause
premature wear or damage to brake system
parts. Verify that the parking brake is fully
released and the brake warning light is
off before driving.
If the vehicle is towing a trailer and parked on a
hill, seeTowing a Trailer on page 324. That
section shows what to do rst to keep the trailer
from moving.
115

Instrument Panel Overview........................ 132
Hazard Warning Flashers.......................... 134
Other Warning Devices............................. 134
Horn.......................................................... 134
Tilt Wheel.................................................. 135
Turn Signal/Multifunction Lever.................. 135
Turn and Lane-Change Signals................. 136
Headlamp High/Low-Beam Changer.......... 137
Flash-to-Pass............................................ 137
Windshield Wiper Lever............................. 138
Cruise Control........................................... 140
Exterior Lamps.......................................... 144
Headlamps on Reminder........................... 145
Daytime Running Lamps (DRL)................. 145
Fog Lamps................................................ 146
Exterior Lighting Battery Saver.................. 146
Interior Lamps........................................... 146
Instrument Panel Brightness...................... 147
Courtesy Lamps........................................ 147
Dome Lamp.............................................. 147
Entry Lighting............................................ 148
Delayed Entry Lighting.............................. 148
Delayed Exit Lighting................................. 149
Front Reading Lamps................................ 149
Overhead Console Reading Lamps........... 149Rear Assist Handle Reading Lamps.......... 149
Electric Power Management...................... 150
Battery Run-Down Protection..................... 151
Head-Up Display (HUD)............................ 151
Accessory Power Outlet(s)........................ 156
Ashtray(s) and Cigarette Lighter................ 157
Climate Controls......................................... 157
Climate Control System............................. 157
Dual Automatic Climate Control System.... 162
Outlet Adjustment...................................... 166
Passenger Compartment Air Filter............. 166
Warning Lights, Gages, and Indicators..... 168
Instrument Panel Cluster........................... 169
Speedometer and Odometer...................... 170
Tachometer............................................... 171
Safety Belt Reminder Light........................ 171
Passenger Safety Belt Reminder Light....... 172
Airbag Readiness Light............................. 172
Passenger Airbag Status Indicator............. 173
Up-Shift Light............................................ 175
Brake System Warning Light..................... 176
Anti-Lock Brake System Warning Light...... 177
Low Tire Pressure Warning Light.............. 178
Section 3 Instrument Panel
129

The main components of the instrument panel are the following:
A. Side Window Defogger Outlets. SeeOutlet
Adjustment on page 166.
B. Air Outlets. SeeOutlet Adjustment on page 166.
C. Turn Signal/Multifunction Lever and Cruise
Controls. SeeTurn Signal/Multifunction Lever
on page 135andCruise Control on page 140.
D. TAP-Shift
®Control (If Equipped). See
Automatic Transaxle Operation on page 110.
E. Hazard Warning Flashers Button. See
Hazard Warning Flashers on page 134.
F. Instrument Panel Cluster. SeeInstrument Panel
Cluster on page 169.
G. Windshield Wiper Lever. SeeWindshield Wiper
Lever on page 138.
H. Ignition. SeeIgnition Positions on page 105.
I. Driver Information Center (DIC) (If Equipped).
SeeDriver Information Center (DIC) on
page 186.
J. Audio System. SeeAudio System(s) on
page 233.K. Audio Steering Wheel Controls (If Equipped).
SeeAudio Steering Wheel Controls on
page 277.
L. Hood Release. SeeHood Release on page 345.
M. Tilt Steering Wheel Lever, on Steering Column.
SeeTilt Wheel on page 135.
N. Interior Lamps Brightness Control. SeeInterior
Lamps on page 146.
O. Passenger Air Bag Status Indicator. See
Passenger Airbag Status Indicator on page 173.
P. Climate Controls. SeeClimate Control
System on page 157.
Q. Shift Lever. SeeAutomatic Transaxle Operation
on page 110.
R. Traction Control Button (If Equipped). See
Traction Control System (TCS) on page 292.
S. Head Up Display (HUD) Control (If Equipped).
SeeHead-Up Display (HUD) on page 151.
T. Glove Box. SeeGlove Box on page 126.
U. Instrument Panel Fuse Block. SeeInstrument
Panel Fuse Block on page 460.
133

Flash-to-Pass Feature. SeeFlash-to-Pass on
page 137.
ICruise Control. SeeCruise Control on
page 140.
PExterior Lamps Control. SeeExterior
Lamps on page 144.
Turn and Lane-Change Signals
To signal a turn, move the turn signal lever located
on the left side of the steering column all the
way up or down. The lever returns automatically
when the turn is complete.
An arrow on the
instrument panel cluster
will ash in the
direction of the turn or
lane change.
If the vehicle is equipped with the Head-Up-Display
(HUD), a right or left turn signal will appear in
the HUD area when making turns or lane changes.
SeeHead-Up Display (HUD) on page 151for
more information.Raise or lower the lever until the arrow starts to
ash to signal a lane change. Hold it there until the
lane change is complete. The lever returns to its
original position when it is released.
Arrows that ash rapidly when signaling for a turn
or lane change may be caused by a burned-out
signal bulb. Other drivers will not see the signal.
Replace burned-out bulbs to help avoid possible
accidents. SeeReplacement Bulbs on page 398,
Front Turn Signal, Parking and Fog Lamps on
page 394, andTaillamps, Turn Signal, and
Stoplamps on page 395. Also, check the fuse for
burned-out bulbs if a turn signal arrow fails to
work when signaling a turn. SeeFuses and Circuit
Breakers on page 460for location information.
Turn Signal On Chime
If the turn signal is left on for more than
0.75 of a mile (1.21 km), a warning chime will
sound and the TURN SIGNAL ON warning
message will appear on the Driver Information
Center (DIC) display. See “Turn Signal On” under
DIC Warnings and Messages on page 200.
136

Headlamp High/Low-Beam Changer
Push forward on the exterior lamps control
lever to change the headlamps from low to
high-beam. Pull the lever back and then release it
to change from high to low-beam.
This symbol appears on
the instrument panel
cluster when the
high-beam headlamps
are on.
When the high-beam headlamps are on, the fog
lamps will not be on. If the vehicle is equipped with
the Head-Up-Display (HUD) an arrow will appear
in the HUD area indicating that the high-beams
are on. SeeHead-Up Display (HUD) on page 151
for more information.
Flash-to-Pass
This feature allows the use of the high-beam
headlamps to signal the driver in front of you that
you want to pass.
Pull and hold the exterior lamps control lever to
use this feature. When this is done, the following
will occur:
The high-beam headlamps will turn on, while
the headlamps are off, in low-beam, or in
Daytime Running Lamps (DRL) mode. They
will stay on as long as the lever is held in this
position. Release the lever to turn them off.
The headlamps will switch to low beam if the
headlamps had been in the high-beam
mode. To return to high-beam, push the lever.
If the vehicle is equipped with the Head-Up Display
(HUD), an arrow will appear on the display to
indicate that the high beams are on.
137