2007 NISSAN ALTIMA warning light

[x] Cancel search: warning light

Page 272 of 344

NISSAN ALTIMA 2007 L32A / 4.G Owners Manual CAUTION
Be careful not to burn yourself. The engine
oil may be hot.
5. Wipe the engine oil filter sealing surface with
a clean rag.
Be sure to remove any old gasket material
remaining on the sealing s

Page 273 of 344

NISSAN ALTIMA 2007 L32A / 4.G Owners Manual The fluid level should be checked using the HOT
MAX range on the power steering fluid reservoir
at fluid temperatures of 122° - 176°F (50° -
80°C) or using the COLD MAX range on the
power steering

Page 274 of 344

NISSAN ALTIMA 2007 L32A / 4.G Owners Manual CLUTCH FLUID
Check the clutch fluid level in the reservoir
(manual transmissions only) . If the fluid level is
below the MIN line, add Genuine NISSAN Super
Heavy Duty Brake Fluid or equivalentDOT 3flu

Page 281 of 344

NISSAN ALTIMA 2007 L32A / 4.G Owners Manual If the brakes do not operate properly, have the
brakes checked by a NISSAN dealer.
SELF-ADJUSTING BRAKES
Your vehicle is equipped with self-adjusting
brakes.
The front and rear disc-type brakes self-a

Page 286 of 344

NISSAN ALTIMA 2007 L32A / 4.G Owners Manual HEADLIGHTS
Replacing the xenon headlight bulb (if
so equipped)
WARNING
cHIGH VOLTAGE
When xenon headlights are on, they pro-
duce a high voltage. To prevent an electric
shock, never attempt to modify

Page 291 of 344

NISSAN ALTIMA 2007 L32A / 4.G Owners Manual If you have a flat tire, see the “In case of
emergency” section of this manual.
TIRE PRESSURE
Tire Pressure Monitoring System
(TPMS)
This vehicle is equipped with the Tire
Pressure Monitoring Syst

Page 300 of 344

NISSAN ALTIMA 2007 L32A / 4.G Owners Manual cThe original tires have built-in
tread wear indicators. When the
wear indicators are visible, the
tire(s) should be replaced.
cTires degrade with age and use.
Have tires, including the spare,
over 6

Page 314 of 344

NISSAN ALTIMA 2007 L32A / 4.G Owners Manual Use the following steps to mount the front license
plate:
s1Make a shallow hole in each plastic finisher
at the location mark (small dimple) using a
0.31 in (8 mm) drill. To avoid damaging the
threads