Page 16 of 27
- 16-
NOTE:
Repositioningthe power seats and operating the power trunk release must be done prior to12 volt battery
disconnection.
Extrication
1. Immobilize the vehicle
a.Move the shift lever to the P (Park) position.
b.Shut the vehicle OFF by pressing the push-button ignition
switch.
c.Chock the wheels.
d.Set the parking brake.
2. Remove the Intelligent Key (1) from the key port (located on the lower
LH corner of the instrument panel). Keep it at least 3.3 feet (1 meter)
away from the vehicle.
3. Stabilize the vehicle
a.Crib at four points directly under the front and rear pillars. Do
not place cribbing under the high voltage harness, exhaust
system or fuel system.
Page 26 of 27
- 26-
3.If the booster battery is in another vehicle, position the vehicles(E) and (F) shown in the illustration
below, to bring the batteries near each other.
Do not allow the two vehicles to touch.
4.Apply the parking brake. Move the shift lever to P (Park). Switch off all unnecessary electrical systems
(lights, heater, air conditioner, etc.).
5.Removethevent caps(if so equipped)on theboosterbattery andcover the battery with an old cloth
(G) to reducetheexplosion hazard.
6.Connect jumper cables in the sequence illustrated (A), (B), (C), (D).
7.Start the engine of the booster vehicle and let it run for a few minutes.
CAUTION:
Page 27 of 27
- 27-
8.Hold down the brake pedal and press the START button. The
vehicle instrument cluster will light up, and theREADYoperation
indicatorlight(green) will come ON.
9.After theREADYoperation indicatorlight(green)in the instrument
cluster comes ON, carefully disconnect the negative cable and
then the positive (+) cable.
10.Replace the vent caps (if so equipped). Be sure to dispose of the cloth used to cover the vent holes, as
it may be contaminated with corrosive acid.
The high voltagebatteryCANNOT be jump started.
CAUTION:
