SEAT
SE-73
C
D
E
F
G
H
J
K
L
MA
B
SE
Revision: 2006 November2007 350Z
REMOVAL
When removing or installing the seat trim, carefully handle it to keep dirt out and avoid damage.
CAUTION:
Before removing the seat, turn the ignition switch off, disconnect both battery cables and wait at
least 3 minutes.
When checking the power seat circuit for continuity using a circuit tester, do not confuse its con-
nector with the side air bag module connector. Such an error may cause the air bag to deploy.
Do not drop, tilt, or bump the side air bag module installing in the seat. Always handle it with care.
1. Remove the front leg cover and rear leg cover (LH/RH).
2. Slide the seat until the body mounting bolts are visible and a tool can be inserted.
3. Remove mounting bolts from vehicle.
4. Disconnect both battery cables.
5. Disconnect harness connector from under seat cushion.
6. Remove fastening clips under seat cushion, and remove seats
from vehicle.
INSTALLATION
Install in the reverse order of removal.
7. Seatback garnish 8. Seat cushion trim 9. Seat cushion pad
10. Seatback frame 11. Seat cushion inner finisher 12. Reclining inner device
13. Power seat switch 14. Inner cover inner device 15. Seat cushion frame
16. Reclining device rod 17. Reclining outer device 18. Inner cover outer device
19. Side air bag module harness 20. Seat cushion outer finisher 21. Lifter dial
22. Seat belt buckle 23. Power seat harness 24. Sliding inner assembly
25. Flexible wire 26. Seat thigh support adjuster assem-
bly27. Sliding outer assembly
PIIA2517E
