2007 NISSAN 350Z tow

SOFT TOP
RF-99
C
D
E
F
G
H
J
K
L
MA
B
RF
Revision: 2006 November2007 350Z
5. Replace retainers under 5th bow finisher with a new part.
NOTE:

Put new retainers under 5th bow finisher with rivet.

Apply nonwoven fabric to retainer lower edge.
6. Remove remains of soft top cover mounting rivet from 5th bow
and C link.
NOTE:
Put a steel plate between a rivet and harnesses on 5th bow for
harness protection, when removing the remaining rivets by drill.
CAUTION:
Take out the remains of rivets completely from 5th bow, other wise the remains cause noise.
NOTE:

Blow remains of rivet toward both ends of 5th bow with com-
pressed air if they are in 5th bow.

Remove the remains drawn to both ends by the air blow from
the gap.
PIIB1308E
PIIB1597E
PIIB1014E
PIIB1015E

SOFT TOP
RF-111
C
D
E
F
G
H
J
K
L
MA
B
RF
Revision: 2006 November2007 350Z
18. Remove 5th bow drive unit and rails together from 5th bow by removing screws.
NOTE:

After removing drive unit and rails, not to pull rails. Otherwise, the wire in the rail may be damaged.

The screws are not reusable.
INSTALLATION
Preparation Work
1. Blow remains of rivet toward both ends of 5th bow with com-
pressed air if they are entering into 5th bow.
2. Remove the remains drawn to both ends by the air blow from
the gap.
PIIA9856E
PIIB1014E
PIIB1015E

RF-124
STORAGE LID
Revision: 2006 November2007 350Z
Removal and Installation of Storage Lid Inside UnitNIS00080
REMOVAL
NOTE:
After installing Storage lid on the vehicle, an adjustment of Storage lid position is required in both closed and
opened condition.
Put the removed storage lid on the floor or a work bench covered by waste clothes to prevent any scratches.
1. Remove storage lid inspection cover on the front side of Storage lid. (a in the figure)
2. Disconnect a wire from a lock assembly by pulling out a connection pin. (b in the figure)
NOTE:
The pin should be taken off by a small pliers not to fell into Stor-
age lid. If the pin fell into Storage lid, then it is very difficult to
take the pin out from the lid. And if the pin is left inside the lid, it
may make an uncomfortable noise.
3. Remove closure mounting bolt from back of storage lid. (c in the figure)
4. Move closure toward outside of vehicle (because it interferes with unlock). (d in the figure)
5. Disconnect unlock actuator connector. (e in the figure)
6. Disconnect actuator side of unlock cable. (g in the figure)
7. Remove unlock actuator mounting bolt from back of storage lid, and then remove unlock actuator from
inspection cover. (f in the figure)
8. Remove lock mounting bolt from back of storage lid, and then move entire lock toward rear of storage lid.
(h in the figure)
PIIB1439E
PIIB1440E