WARNING CHIME
DI-87
C
D
E
F
G
H
I
J
L
MA
B
DI
Revision: 2006 November2007 350Z
3. CHECK DRIVER SIDE DOOR SWITCH
Check driver side door switch. Refer to DI-90, "
DRIVER SIDE DOOR SWITCH" .
OK or NG
OK >> Replace BCM. Refer to BCS-17, "Removal and Installation of BCM" .
NG >> Replace driver side door switch.
Key Switch Signal InspectionNKS0026B
1. CHECK FUSE
Check if the key switch 10A fuse [No. 21, located in the fuse block (J/B)] is blown.
OK or NG
OK >> GO TO 2.
NG >> Be sure to repair the cause of malfunction before installing new fuse. Refer to PG-4, "
POWER
SUPPLY ROUTING CIRCUIT" .
2. CHECK BCM INPUT SIGNAL
With CONSULT-llI
1. Select “BCM”.
2. With “DATA MONITOR” of “BUZZER”, confirm “KEY ON SW” when the key switch is operated.
Without CONSULT-llI
Check voltage between BCM harness connector M90 terminal 37
and ground.
OK or NG
OK >> INSPECTION END
NG >> GO TO 3.
3. CHECK KEY SWITCH
Check continuity between key switch. Refer to DI-90, "
Component Inspection" .
OK or NG
OK >> GO TO 4.
NG >> Replace key switch.“KEY ON SW”
When key is inserted to ignition key cylinder : ON
When key is removed from ignition key cylinder : OFF
37 – Ground
When key is inserted to
ignition key cylinder: Approx. 12 V
When key is removed from
ignition key cylinder: Approx. 0 V
SKIA5048E
