2007 Mercury Mariner Hybrid light

[x] Cancel search: light

Page 214 of 336

Mercury Mariner Hybrid 2007  Owners Manuals Vehicles with a higher center of gravity such as utility and
four-wheel drive vehicles handle differently than vehicles with a
lower center of gravity. Utility and four-wheel drive vehicles arenot
des

Page 215 of 336

Mercury Mariner Hybrid 2007  Owners Manuals spinning your wheels. If the vehicle does slide, steer in the direction of
the slide until you regain control of the vehicle.
If the transmission, transfer case or front axle are submerged in water,
t

Page 217 of 336

Mercury Mariner Hybrid 2007  Owners Manuals as adding or removing parts (such as lift kits or stabilizer bars) or using
replacement parts not equivalent to the original factory equipment.
Any modifications to a vehicle that raise the center of

Page 224 of 336

Mercury Mariner Hybrid 2007  Owners Manuals Fuse/Relay
LocationFuse Amp
RatingPassenger Compartment Fuse
Panel Description
1 — Not used
2 — Not used
3 15A* Front and rear park lamps
4 10A* Ignition switch
5 2A* Powertrain Control Module (PC

Page 226 of 336

Mercury Mariner Hybrid 2007  Owners Manuals The fuses are coded as follows.
Fuse/Relay
LocationFuse Amp
RatingPower Distribution Box
Description
1 5A* Brake module
2 10A* Climate control
3 5A* Transaxle Control Module (TCM)
4 7.5A* Traction (hi

Page 231 of 336

Mercury Mariner Hybrid 2007  Owners Manuals •Winter weather driving capability
•Wet weather driving capability
•All-Wheel driving capability (if applicable)
•Load leveling adjustment (if applicable)
When driving with the full-size dissi

Page 241 of 336

Mercury Mariner Hybrid 2007  Owners Manuals 1.Use only a 12–volt supply to start your vehicle.
2. Do not disconnect the battery of the disabled vehicle as this could
damage the vehicle’s electrical system.
3. Park the booster vehicle close

Page 243 of 336

Mercury Mariner Hybrid 2007  Owners Manuals 2. Start the engine of the disabled vehicle.
3. Once the disabled vehicle has been started, run both engines for an
additional three minutes before disconnecting the jumper cables.
Removing the jumper