2007 MERCEDES-BENZ SLK55AMG ignition

181 Controls in detail
Climate control
Set air volume control2 (page 177)
to position5.
The ventilation operates with maximum
blower speed.
Turn temperature controls1and4
(
page 174) completely counterclock-
wise to their end stops.
The lowest temperature for both sides
is set.
Residual engine heat utilization
With the engine switched off, it is possible
to continue to heat or ventilate the interior
for up to 30 minutes. This feature makes
use of the residual heat produced by the
engine.
Activating
Switch off the ignition (page 37).
Press button9 (page 174).
The indicator lamp on the button
comes on.Deactivating
Press button9 (page 174) again.
The indicator lamp on the button goes
out.
iWhen the vehicle’s interior has cooled down
enough, reduce the air volume and increase the
air temperature to comfortable settings if
desired.
iHow long the system will provide heating
depends on

the coolant temperature

the temperature set by the operator
The blower will run at speed setting1 regardless
of the air distribution control setting.
iThe residual heat is automatically turned off

when the ignition is switched on (page 37)

after about 30 minutes

if the battery voltage drops

186 Controls in detail
Automatic climate control*
Reactivating
Switch on the ignition (page 37).
Press button´ (page 184) again.
The previous settings are once again in
effect.
or
Press buttonU (page 184).
The indicator lamp on the button
comes on. Air volume and air dis-
tribution are adjusted automatically.
Operating the climate control system
in automatic modeActivating
Press buttonU (page 184) while
the engine is running.
The indicator lamp on the button
comes on. The air volume and air dis-
tribution are adjusted automatically.
Use temperature controls4and6
orbandc (
page 184) to sepa-
rately adjust the air temperature on
each side of the passenger com-
partment.
The temperature of the vehicle interior
is adjusted automatically.
Deactivating
Press buttonU (page 184) again.
The indicator lamp on the button goes
out. The air volume changes to level2
and the air distribution changes
tob. Automatic control of air
volume and air distribution is switched
off.
Setting the temperature
Use temperature controls4andc for
the driver’s side or6andb for the
passenger side (
page 184) to separately
adjust the air temperature on each side of
the passenger compartment. You should
raise or lower the temperature setting in
small increments, preferably starting
at 72°F (22°C). The automatic climate
control will adjust to the set temperature
as fast as possible.
iWhen operating the automatic climate
control system in automatic mode, you will only
rarely need to adjust the temperature, air volume
and air distribution.
In automatic mode, cooling with dehumidify is
switched on. This function can be switched off if
necessary.

192 Controls in detail
Automatic climate control*
Deactivating
It is possible to deactivate the air condi-
tioning (cooling) function of the automatic
climate control system. The air in the
vehicle will then no longer be cooled or
dehumidified.
Press buttonœ (page 184).
The indicator lamp on the button goes
out.
Activating
Moist air can fog up the windows. You
can dehumidify the air with the air
conditioning.
Press buttonœ (page 184).
The indicator lamp on the button
comes on.
Residual heat and ventilation
With the engine switched off, it is possible
to continue to heat or ventilate the interior
for up to 30 minutes. This feature makes
use of the residual heat produced by the
engine.Activating
Switch off the ignition (page 37).
Press buttonT (page 184).
The indicator lamp on the button
comes on. The display in the automatic
climate control panel remains switched
off.
Deactivating
Press buttonT (page 184) again.
The indicator lamp on the button goes
out.
iHow long the system will provide heating
depends on

the coolant temperature

the temperature set by the operator
The blower will run at speed setting1 regardless
of the air volume control setting.
iThe residual heat is automatically turned off:

when the ignition is switched on (page 37)

after about 30 minutes

if the battery voltage drops

236 Controls in detail
Power windows
Switch on the ignition (page 37).Opening the door windows
Press and hold switch1or2 at the
symbolk to the resistance point.
The corresponding window will move
downwards until you release the
switch.
Closing the door windows
Press and hold switch1or2 at the
symbolj to the resistance point.
The corresponding window will move
upwards until you release the switch.Fully opening the door windows
(Express-open)
Press switch1or2 at the
symbolk past the resistance point
and release.
The corresponding window opens
completely.
Fully closing the door windows
(Express-close)
Press switch1or2 at the
symbolj past the resistance point
and release.
The corresponding window closes
completely.
iYou can also open or close the windows
using the SmartKey* (
page 238) or the
retractable hardtop switch (
page 237).
You can close and open the windows using the
air recirculation switch, in the control panel
of the climate control (
page 178) or the
automatic climate control* (
page 189).
iAfter switching off the ignition (page 37)
or removing the SmartKey from the starter
switch, the door windows can be operated:

until you open a door

for at least 5 minutes if no door was opened
Warning!G
If you press and hold the switch when clos-
ing the window, and upward movement of
the window is blocked by some obstruction
including but not limited to arms, hands,
fingers, etc., the automatic reversal will not
operate.
Warning!G
Driver’s door only:
If the switch is pressed again past the resis-
tance point and released within 5 seconds,
the automatic reversal will not operate.

237 Controls in detail
Power windows
Stopping windows during
Express-operation
Briefly press the respective switch at
the symbolkorj again.Opening and closing the windows with
the retractable hardtop switch
All windows can be opened or closed with
the retractable hardtop switch.
The retractable hardtop switch is located
on the lower part of the center console.
Retractable hardtop switch
1Opening all side windows
2Closing all side windows
Switch on the ignition (page 37).
!If the upward movement of the window is
blocked during the closing procedure, the win-
dow will stop and open slightly.
Remove the obstruction, press the respective
switch at the symbolj again past the resis-
tance point and release.
If the window still does not close when there is
no obstruction, press and hold the respective
switch at the symbolj. The window will then
close without the obstruction sensor function.Warning!G
Never operate the windows if there is the
possibility of anyone being harmed by the
opening or closing procedure.
In case the procedure causes potential
danger, the procedure can be immediately
halted by releasing the retractable hardtop
switch.
If a door window encounters an obstruction
that blocks its path in a circumstance where
you are closing the windows using the
retractable hardtop switch, the automatic
reversal function will not operate.

239 Controls in detail
Power windows
Synchronizing power windows
The power windows must be synchronized

after the battery has been disconnect-
ed or discharged.

if the power windows cannot be fully
opened (Express-open) or closed
(Express-close).
Each power window must be synchronized.
Close all doors.
Switch on the ignition (page 37).
Press and hold both switches1
and2 (
page 235) at the
symbolj until the windows are
completely closed.
Hold on to switches1and2 for
approximately 1 second.
The power windows are synchronized.
Warning!G
When closing the side windows and retract-
able hardtop, make sure that there is no
danger of anyone being harmed by the
closing procedure.
If potential danger exists, proceed as fol-
lows:

Release button‹to stop the closing
procedure. To open, press and hold
buttonŒ. To continue the closing
procedure after making sure that there
is no danger of anyone being harmed by
the closing procedure, press and hold
button‹.
Warning!G
If the retractable hardtop does not com-
pletely open or close, the roof hydraulics will
lose pressure and the retractable hardtop is
lowered

after approximately 7 minutes when the
ignition is switched on.

after approximately 15 seconds when
the ignition is switched off.
Shortly before the hardtop is lowered, a
warning will sound. In the multifunction dis-
play you will seeK and the message
Retractable roof being opened.
Properly lock the retractable hardtop
(
page 242) before continuing to drive.

241 Controls in detail
Retractable hardtop
Luggage cover
The luggage cover is located in the trunk.
Luggage cover
Closing
Pull the luggage cover at the handle in
direction of the arrow until it engages
on both sides at the trunk sill.Opening
Press the release handle on the lug-
gage cover.
Guide the luggage cover forward to its
end stop.Retractable hardtop
!To prevent damage to the retractable hard-
top or luggage/cargo when lowering the roof:

Load trunk only to the height of the luggage
cover.

Do not permit luggage/cargo to push up the
closed luggage cover.

Do not place anything on top or in front of
the luggage cover.

Do not place anything on the shelf behind
the roll bar.
Warning!G
To prevent possible accidents, drive the ve-
hicle only with the retractable hardtop either
completely closed and locked, or fully low-
ered into its storage compartment.
iFor safety reasons, the retractable hardtop
cannot be opened or closed while driving.
Make sure the retractable hardtop and the rear
window are dry before you open it. Otherwise
water may enter the interior and/or trunk.
iBefore operating the retractable hardtop via
the retractable hardtop switch, do the following
first:

Engage the parking brake (page 59).

Close the luggage cover.

Close the trunk lid.

Switch on the ignition (page 37).

243 Controls in detail
Retractable hardtop
If the retractable hardtop is not properly
locked, lock it as described below.Unlocked status noticed when stopped
Switch on the ignition (page 37).
To lock the retractable hardtop in its
fully closed position, push the retract-
able hardtop switch forward until the
retractable hardtop is fully closed.
or:
To lock the retractable hardtop in its
fully opened position, push the retract-
able hardtop switch rearward until the
retractable hardtop is fully open.
Warning!G
If the retractable hardtop does not com-
pletely open or close, the roof hydraulics will
lose pressure and the retractable hardtop is
lowered

after approximately 7 minutes when the
ignition is switched on.

after approximately 15 seconds when
the ignition is switched off.
Shortly before the hardtop is lowered, a
warning will sound. In the multifunction dis-
play you will seeK and the message
Retractable roof being opened.

Properly lock the retractable hardtop
before continuing to drive (
page 243).
Warning!G
The hardtop is not fully closed and locked or
not fully opened and locked if:

the message Retractable roof in
operation
is shown in the multifunc-
tion display

a warning sounds for 10 seconds when
driving and a message in the multifunc-
tion display appears (
page 374).