2007 MERCEDES-BENZ E-Class port

84 Telephone*
Important notes
A brief disconnection from the cellular
network is not a malfunction, as this
can occur when the network switches
areas. The phone automatically at-
tempts to again sign on with a network.
If the message Enter unlock code is dis-
played, enter the unlock code
(
page 88). Only then will you be able
to use all the telephone functions.
You will still be able to make 911 emer-
gency calls (
page 85) if the tele-
phone is locked. The telephone cannot, or not yet, be used
in the following situations:
The telephone is already unlocked, but
it is not yet registered with the net-
work.
The message
NO SERV. appears in the
status bar. The telephone automatical-
ly attempts to register with a network.
If there is no network available, “911”
emergency calls can NOT be placed.
If you try to place an outgoing call, the
message
Call not possible is displayed
temporarily.
If the message Telephone being
activated, please wait
is displayed,
If the message Please insert phone is dis-
played.
Insert the cellular phone into the
telephone cradle.

103 Navigation*
Important notes
Navigation main menu
Destination entry
Route guidance
During route guidance
Last destinations and destination memory
POIs (Points of Interest)

104 Navigation*
Important notes
Safety Instructions
WarningG
For safety reasons, you should only enter a
destination when the vehicle is stationary.
When the vehicle is in motion, a passenger
should enter the destination. Study manual
and select route before driving.
Do not watch display screen or operate but-
tons while the vehicle is in motion - let navi-
gation announcements guide you. Stop at a
safe location before using buttons or mak-
ing corrections.
Traffic regulations always have priority over
any route recommendations given.
Bear in mind that at a speed of just 30 mph
(approximately 50 km/h), your vehicle is
covering a distance of 44 feet (approximate-
ly 14 m) every second.
The route calculated by COMAND is a rec-
ommendation on how to best reach your se-
lected destination.
During route guidance, you will not receive
any information on
Traffic lights
Stop and yield signs
Parking or stopping zones
One-way streets
Narrow bridges
Similar traffic regulation data
You should therefore always strictly observe
traffic regulations while driving. Drive care-
fully and always obey traffic laws and road
signs even if they contradict COMAND in-
structions.
WarningG
The Navigation DVD module contains a
Class 1 laser product. There is a danger of
invisible laser radiation if the cover is
opened or damaged.
Do not remove the cover. The Navigation
DVD module does not contain any parts
which can be serviced by the user. For safe-
ty reasons, have any service work which
may be necessary performed only by quali-
fied personnel.

105 Navigation*
Important notes
COMAND calculates the route with the
help of data that is stored on the naviga-
tion DVD.
Only use Mercedes-Benz navigation DVDs
designed for the E-Class (211) COMAND
system. No other CDs or DVDs will work.
Using other navigation CDs or DVDs might
lead to malfunctions.
Because of changes in local traffic patterns
(e.g. road works) and/or incomplete data,
errors in calculation may occur.
As a result, the recommended route may
deviate from the ideal route. The data
stored on the DVD only reflects local con-
ditions at the time of DVD production. DVD
maps do not cover all areas nor all routes
within an area.The DVD is loaded into (and ejected from)
the navigation module.
The navigation module is mounted on the
left-hand side of the trunk.
1Ejecting DVDs
2DVD slotLoading Insert the DVD into the DVD slot 2
with the label facing up.
Th e n a v i g a t i o n c o m p u t e r p u l l s t h e D V D
in.
Ejecting
Press: and wait until the navigation
computer ejects the DVD.
The navigation DVD covers the continental
U.S., Hawaii and Canada.
Contact your Mercedes-Benz Center or the
Customer Assistance Center in the U.S. at
1-800-FOR-MERCedes (1-800-367-6372)
or in Canada at 1-800-387-0100 for other
DVDs that may be available.
Change the navigation DVD
(
page 105).
Navigation DVDLoading/ejecting the DVD
i
Your Navigation DVD drive has been
designed to play DVDs which corre-
spond to the IEC 60908 standard.
If you insert thicker data carriers, e.g.
ones that have data on both sides (one
side with DVD data, the other side with
audio data), they cannot be ejected
and will damage the drive.
Travelling abroad

106 Navigation*
Important notes
T
If your vehicle has been transported by a
car, train or ferry, COMAND may require
some time to find its exact position.COMAND may issue navigation announce-
ments not suited to your actual position.
Moving the vehicle a few yards is typically
enough to remedy the situation.
While determining the exact position ,
route guidance is subject to the following
restrictions:
COMAND does not output navigation
announcements.
The display OFF ROAD and an arrow indi-
cating the direction of the destination
appear instead of the detailed naviga-
tion displays.
Once the system is correctly repositioned,
route guidance continues with navigation
announcements and detailed navigation
displays. The following instructions have to be fol-
lowed when interrupting a trip during route
guidance, and later continuation:
Continuation of the trip within 2 hours
after interruption:
The system automatically resumes
route guidance.
Continuation of the trip between
2 and 12 hours after interruption:
Continue route guidance manually
in the Navigation main menu
(
page 108).
Route guidance with GPS
i
GPS (Global Positioning System) sig-
nals received make it possible to deter-
mine the current vehicle position.
i
Deviations from the actual position
may occur
if the reception of GPS signals is
disturbed e. g. in parking garages
and tunnels
if road conditions are bad
depending on the vehicle’s condi-
tion
Route guidance after vehicle trans-
port
i
The navigation DVD must be loaded in
the navigation computer (
page 105).
Trip interruption during route guid-
ance
i
Trip interruption means parking the ve-
hicle and switching COMAND OFF.
Trip continuation means trip continua-
tion with COMAND switched ON.

107 Navigation*
Important notes
Continuation of the trip more than 12
hours after interruption:
Route guidance must be restarted.
Select the destination from the Last
destinations
memory (page 148),
or
Re-enter the destination
(
page 114).
Some menus provide lists from which you
can select an item.
Example: Menu to select a streetYou can select a list item using% or &.
If, as shown in the example, you can see
the
Page soft keys, then you can use the
soft keys to scroll up or down the list, page
by page.
As soon as you reach the beginning or end
of a list, the appropriate soft key is deacti-
vated.
Selection lists

108 Navigation*
Navigation main menu
Press 5.
The Navigation main menu appears, if
no route guidance is active.
Use% or & to select a menu item
and press';
or
Press one of the soft keys.
The selected menu or the selected soft
key function appears.
Selectable menu items
Continue route guidance
Continues a cancelled route guidance,
Destination memory
Destinations can be selected from the
Destination memory (page 149),
Destination entry
Provides access to the Destination en-
try menu (
page 114),
Last destinations
You can select from the list of last des-
tinations (
page 148),
POIs
(Points of Interest)
Provides access to POIs input
(
page 152). POIs include stops at
gas stations, airports, rest areas, hospi-
tals, etc.
Calling up the Navigation main menu
i
If route guidance is active, a prompt is
displayed instead, asking if route guid-
ance is to be cancelled (
page 132).
i
This menu item only appears:
if the route guidance had previously
been interrupted (
page 132), and
less than 30 minutes have expired
since the interruption,
or
if the trip was interrupted and is to
be continued 2 - 12 hours after in-
terruption (
page 106).
i
Destination memory and Last destinations
can only selected only if destinations
are already stored in the system.

114 Navigation*
Destination entry
Selectable menu items
Destination memory
You can select destinations from the
Destination memory (page 149) only if
destinations have alreday been stored.
Destination entry
You can enter a destination manually
via the Destination entry menu
(
page 114).
Last destinations
You can select from the list of last des-
tinations (
page 148) only if the sys-
tem has already stored destinations.
POIs
You can input POIs (points of interest),
for example gas stations, airports or
hospitals.
Current location
Provides access to store the current lo-
cation as home address (
page 114)
or select a home address using the
map (
page 114).Storing current location as home
address
Use % or & to select the
Current location menu item and
press'.
To store the displayed address as
home address, press '.
Select a home address using the map
Use % or & to select the
Current location menu item and
press'.
Press the Map soft key.
Proceed as described under “Moving
the map and selecting a destination”
(
page 124).
Or, to store the selected destination as
home adress, press'.
Call up the Navigation main menu
(
page 108).
Use % or & to select the
Destination entry menu item and
press'.
The Destination entry menu appears.
Destination entry menu