2007 MERCEDES-BENZ C230 ECU

360 Practical hints
Where will I find ...?
Storing the Minispare wheel
Place Minispare wheel3 in wheel
well.
Place vehicle tool kit storage well
casing4 over the Minispare wheel.
Make sure arrow2 on vehicle tool kit
storage well casing4 points in the
direction of travel.
Place storage well casing (page 356)
over vehicle tool kit storage well
casing4 and turn the retaining screw
(
page 356) clockwise as far it will go
to secure the Minispare wheel.In case of a flat tire, you may temporarily
use the Minispare wheel when observing
the following restrictions:

Do not exceed a vehicle speed of
50 mph (80 km/h).

Drive to the nearest tire repair facility
to have the flat tire repaired or
replaced as appropriate.

Do not operate vehicle with more than
one Minispare wheel mounted.
For more information, see “Rims and Tires”
(
page 403).
Spare wheel bolts
1Wheel bolt for light alloy rims
2Wheel bolt for Minispare wheel (locat-
ed in trunk with spare wheel)
iArrow2 on vehicle tool kit storage well
casing4 must point in the direction of travel.
Otherwise you cannot place the storage well cas-
ing (
page 356) on top and secure the Minis-
pare wheel with the retaining screw
(
page 356).
!To prevent damage, always disengage trunk
floor handle from upper edge of trunk and lower
trunk floor before closing the trunk lid.
Warning!G
The dimensions of the Minispare wheel are
different from those of the road wheels. As
a result, the vehicle handling characteristics
change when driving with a Minispare wheel
mounted.
The Minispare wheel should only be used
temporarily, and should be replaced with a
regular road wheel as quickly as possible.
!Wheel bolts2 must be used when mount-
ing the Minispare wheel. The use of any wheel
bolts other than wheel bolts2 for the Minispare
wheel will physically damage the vehicle’s
brakes.
Warning!G
Make sure to use the original length wheel
bolts when remounting the original wheel
after it has been repaired.

383 Practical hints
Battery
Battery
The battery is located in the engine
compartment on the right hand side.
1Clamps
Removing filter box:
Release clamps1.
Remove filter box.
Installing filter box:
Insert filter box properly.
Secure it with clamps1.
Warning!G
Failure to follow these instructions can
result in severe injury or death.
Observe all safety instructions and
precautions when handling automotive
batteries (
page 279).
Never lean over batteries while connecting,
you might get injured.
Battery fluid contains sulfuric acid. Do not
allow this fluid to come in contact with eyes,
skin or clothing. In case it does, immediately
flush affected area with water and seek
medical help if necessary.
A battery will also produce hydrogen gas,
which is flammable and explosive. Keep
flames or sparks away from battery, avoid
improper connection of jumper cables,
smoking, etc.
Warning!G
Do not place metal objects on the battery as
this could result in a short circuit.
Use leak-proof battery only to avoid the risk
of acid burns in the event of an accident.
!Never loosen or detach battery terminal
clamps while the engine is running or the
SmartKey is in the starter switch. Otherwise the
alternator and other electronic components
could be severely damaged.
Have the battery checked regularly by an autho-
rized Mercedes-Benz Center.
Refer to Maintenance Booklet for maintenance
intervals or contact an authorized
Mercedes-Benz Center for further information.

384 Practical hints
Battery
2Negative terminal
3Positive terminal cover
Disconnecting the battery
Apply the parking brake (page 54).
Make sure the gear selector lever* is
set to positionP (
page 153) (manual
transmission: to Neutral (
page 149)).
Turn off all electrical consumers.
Remove SmartKey from starter switch.
Open the hood (page 274).
Remove the filter box (page 383).
Read and observe safety instructions
and precautions (
page 279) and
(
page 383).
Disconnect the battery negative lead
from negative terminal2.
Remove cover3 from the positive
terminal.
Disconnect the battery positive lead.
Removing the battery
Remove the screw-nuts securing the
battery.
Remove the battery bracket.
Pull out the battery ventilation hose
from the battery (depending on battery
arrangement in your vehicle model, the
ventilation hose is located either on the
left or right side of the battery).
Take out the battery.
Warning!G
With a disconnected battery

you will no longer be able to turn the
SmartKey in the starter switch

automatic transmission*: the gear se-
lector lever will remain locked in
positionP
!Always disconnect the battery in the order
described below. Otherwise the vehicle’s
electronics can be damaged.

385 Practical hints
Battery
Charging and reinstalling the batteryCharge battery in accordance with the
instructions of the battery charger
manufacturer.
Reinstall the charged battery. Follow
the previously described steps in
reverse order.
Reconnecting the battery
Turn off all electrical consumers.
Remove SmartKey from starter switch.
Connect the battery positive lead and
fasten its cover3 (
page 384).
Connect the battery negative lead2
(
page 384).
Reinstall the filter box (page 383).Batteries contain materials that can harm
the environment if disposed of improperly.
Large 12 volt storage batteries contain
lead. Recycling of batteries is the preferred
method of disposal. Many states require
sellers of batteries to accept old batteries
for recycling.
Warning!G
Never charge a battery while still installed in
the vehicle unless the accessory battery
charge unit approved by Mercedes-Benz is
being used. Gases may escape during charg-
ing and cause explosions that may result in
paint damage, corrosion or personal injury.
An accessory battery charge unit specially
adapted for Mercedes-Benz vehicles and
tested and approved by Mercedes-Benz is
available, permitting the charging of the bat-
tery in its installed position. Contact an au-
thorized Mercedes-Benz Center for
information and availability. Charge battery
in accordance with the separate instruc-
tions for the accessory battery charger.
!The battery, its filler caps and the battery
ventilation hose must always be securely in-
stalled when the vehicle is in operation.
!Always connect the battery in the order de-
scribed below. Otherwise the vehicle’s electron-
ics can be damaged.
!Never invert the terminal connections!
iThe following procedures must be carried
out following any interruption of battery power
(e.g. due to reconnection):

Set the clock (page 136).
Vehicles with COMAND*:
See COMAND operator’s manual.

Synchronize side windows (page 222).

Synchronize tilt/sliding sunroof*
(
page 226).

391 Practical hints
Fuses
Fuses
The electrical fuses in your vehicle serve to
switch off malfunctioning power circuits.
If a fuse is blown, the components and sys-
tems secured by that fuse will stop operat-
ing.If a newly inserted fuse blows again, have
the cause determined and rectified by an
authorized Mercedes-Benz Center.
The following aids are available to help you
replace fuses.

Fuse chart
The fuse chart is located in the main
fuse box in the passenger compart-
ment (
page 392). The fuse chart ex-
plains the fuse allocation and fuse
amperages.

Spare fuses
Spare fuses are located in the vehicle
tool kit in the spare wheel well
(
page 356).

Fuse extractor
The fuse extractor is located in the cov-
er of the auxiliary fuse box in the trunk
(
page 394).The electrical fuses are located in different
fuse boxes:

in the passenger compartment on the
driver’s side (
page 392)

on the driver’s side of the engine com-
partment (
page 392)

in the trunk (page 394)
Before replacing fuses:
Apply the parking brake (page 54).
Make sure the gear selector lever* is
set to positionP (
page 153) (manual
transmission: to Neutral (
page 149)).
Turn off all electrical consumers.
Turn off the engine (page 55).
Remove the SmartKey from the starter
switch.
Warning!G
Only use fuses approved by Mercedes-Benz
with the specified amperage for the system
in question and do not attempt to repair or
bridge a blown fuse. Using other than ap-
proved fuses or using repaired or bridged
fuses may cause an overload leading to a
fire, and/or cause damage to electrical
components and/or systems. Have the
cause determined and remedied by an
authorized Mercedes-Benz Center
iA blown fuse must be replaced by an appro-
priate spare fuse (recognizable by its color or the
fuse rating given on the fuse) of the amperage
recommended in the fuse chart.
Any Mercedes-Benz Center will be glad to advise
you on this subject.

393 Practical hints
Fuses
Opening fuse box
4Fuse box cover
5Clamps
With a dry cloth, remove any moisture
from the fuse box.
Release clamps5.
Remove fuse box cover4.Closing fuse box
Make sure that the sealing rubber is
properly positioned.
Press fuse box cover4 down and
secure with clamps5.Installing cover
Insert cover1 sideways into
retainer3.
Twist screws2 90° clockwise.
!The fuse box cover4 must be properly po-
sitioned as described to prevent moisture or dirt
from entering the fuse box and possibly impair-
ing fuse operation.

429 Index
MOE tires* see MOExtended system*
MOE* see MOExtended system*
MOExtended system* 382
MOExtended tires* 403
Multicontour seats* (Canada only) 105
Multifunction display 121
Changing settings see
Control system menus and
Control system submenus
Multifunction display messages
ABS 335
Brake fluid 344
Brake lamps 349
Brake pads 344
Coolant 345–347
Engine coolant 345–347
Engine oil 348
ESP
®335
Fog lamps 350, 352
Front passenger
front air bag 337, 340
Fuel cap 326, 349
Headlamps 350, 351
Key, SmartKey 349
Lamps, exterior 349–353
Parking brake 344Parking lamp 351
SRS 342
Steering gear oil 354
Tele Aid* 355
Telephone* 355
Turn signals 353
Windshield washer fluid 355
Multifunction steering wheel 26, 122
Button operation 122
N
Navigation system* 129
See separate COMAND*
operating instructions
Net, parcel 239
Neutral gear position,
Automatic transmission 151, 153
Neutral gear position,
Manual transmission 150
New vehicle break-in 260
Night security illumination 112
Setting 141
Normal occupant weight 305
Number, paintwork code 398
Number,
vehicle identification (VIN) 398, 399O
Occupant Classification System see OCS
Occupant distribution 305
Occupant safety 58
Air bags 59
Children and air bags 60
Children in the vehicle 74
Fastening the seat belt 43
Front passenger front
air bag off indicator lamp 68, 331
Infant and child restraint systems 74
LATCH-type child seat anchors 79
Seat belts 43, 62
OCS 64
Self-test 68
Odometer 121
Oil level see Engine oil level,
Checking oil level
Oil see Engine oil
One-touch gearshifting
Automatic transmission 158
Gear selector lever 158
Operating safety 187
Ornamental moldings, Cleaning 316
Outside temperature see Displays
Overhead control panel 29

432 Index
S
Safety
Driving safety systems 82
Occupant 58
Reporting defects 18
Safety belts see Seat belts
Satellite radio* 197
Seat belt force limiter 72
Seat belts 69
Children in the vehicle 74
Cleaning 319
Fastening 43
Height adjustment 45
Proper use of 45, 70
Safety guidelines 62
Telltale 25
Seat heating* 106
Seating capacity 285Seats, 34, 101
Heating* 106
Lumbar support* 105
Manual 35, 101
Memory function*
(Power seats*) 107
Multicontour seat*
(Canada only) 105
Power* 37, 101
Rear bench seat* 233
Securing cargo 236
Selector lever see Gear selector lever
Selector lever see gear selector lever
Self-test
OCS 68
Tele Aid* 248
Service and Warranty Booklet
Loss of 397
Service and warranty information 10
Service intervals see
Maintenance service indicator 310
Service life (tires) 282
Service see Maintenance Service system
see FSS (Canada vehicles)
Service, Parts 396Settings
Control system menus
and submenus 124, 125
Date 138
Factory, SmartKey 93
Individual, SmartKey 94
Individual, Vehicle 131
Lighting (control system) 139
Memory function* 107
Menus and submenus 123
Resetting all (control system) 131
Selective, SmartKey 94
Time 136, 137
Shelf below rear window, cleaning 319
Shift lever position indicator 121
Shift program mode,
Automatic transmission* 121
Shifting
Automatic transmission* 47
Into reverse
(manual transmission) 150
Manual transmission 46, 150
Shifting, Automatic transmission* 151
Side impact air bags (front and rear*) 64