2007 Lancia Musa sensor

USE OF MATERIALS THAT DO NOT HARM THE ENVIRONMENT
None of the car’s components contain asbestos. Padding and the air conditioning system do not contain CFCs
(Chlorofluorocarbides), the gases considered responsible for the destruction of the ozone layer. None of the
colourings and anti-corrosion coatings of the nuts and bolts contain air- or water-table-polluting cadmium or
chromates, but environmentally-friendly substances.
DEVICES FOR REDUCING EMISSIONS (petrol engines)
Three-way catalytic converter (catalytic exhaust pipe)
The exhaust system is equipped with a catalyst made up of noble metal alloys; it is housed in a stainless steel
container capable of withstanding the very high operating temperatures.
The catalyst converts the unburnt hydrocarbons, the carbon monoxide and the nitric oxides found in the exhaust
gases (though in small amounts, thanks to the electronic-injection ignition systems) into non-polluting substances.
When functioning normally, the catalytic converter reaches high temperatures. For this reason do not park the car
over inflammable material (e.g. paper, fuel oil, grass, dead leaves, etc.).
Lambda sensors
The Lambda sensors detect the oxygen content in the exhaust gas. The signal sent by the oxygen sensor is used by
the injection system electronic control unit to constantly mix air and fuel in the correct proportion.
Evaporation control system
As it is impossible to stop the build-up of petrol fumes, also when the engine is not running, the system traps them
in a special container holding active carbon.
The fumes are sucked in from here and burnt while the engine is running.

7
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLSSYMBOLS ............................................................ 8
THE LANCIA CODE SYSTEM .............................. 8
KEY KIT AND DOOR LOCKING ......................... 10
IGNITION SWITCH .............................................. 20
DASHBOARD ........................................................ 23
INSTRUMENT PANEL ......................................... 26
INSTRUMENTS .................................................... 27
MULTIFUNCTION DISPLAY
(On two-line mode panel) ..................................... 29
MULTIFUNCTION DISPLAY
(On three-line comfort panel) ............................... 37
STEERING WHEEL ADJUSTMENT .................... 69
SEAT ADJUSTMENT ........................................... 70
HEAD RESTRAINTS ............................................ 77
REARVIEW MIRRORS .......................................... 79
HEATING/CLIMATE CONTROL SYSTEM .......... 81
MANUAL CLIMATE CONTROL SYSTEM ........... 83
AUTOMATIC TWO-ZONE CLIMATE
CONTROL SYSTEM ............................................ 88
EXTERNAL LIGHTS ............................................ 99
WINDOW WASHING ............................................ 104
CRUISE CONTROL ............................................. 109
CEILING LIGHTS ................................................ 112
LIGHT CONTROL BUTTONS .............................. 115INERTIAL FUEL CUT-OFF
SWITCH ................................................................ 117
INTERIOR FITTINGS .......................................... 118
SMOKERS’ KIT ..................................................... 123
SUN VISORS ......................................................... 123
SUNROOF ............................................................. 124
POWER WINDOWS ............................................. 126
REAR WINDOW WINDERS .................................. 129
BOOT .................................................................... 129
BONNET ............................................................... 134
ROOF/SKI RACKS ................................................ 136
HEADLIGHTS ...................................................... 136
ABS SYSTEM ....................................................... 138
ESP SYSTEM ....................................................... 140
ASR SYSTEM ........................................................ 142
EOBD SYSTEM .................................................... 144
TYRE PRESSURE MONITORING
SYSTEM - T.P.M.S................................................. 145
SOUND SYSTEM .................................................. 147
ACCESSORIES PURCHASED BY THE OWNER .. 149
“DUALDRIVE” ELECTRIC POWER
STEERING SYSTEM ............................................ 150
PARKING SENSORS ............................................ 152
AT THE FILLING STATION ................................ 154
PROTECTING THE ENVIRONMENT .................. 156
DASHBOARD AND CONTROLS

39
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
SET-UP MENU
The “Set-up Menu” enables to perform the
following adjustments and/or settings using the
control buttons (see previous pages):
❒SPEED LIMIT
❒AUTOMATIC HEADLIGHT DAYLIGHT
SENSOR (where provided)
❒TRIP B ON/OFF
❒SET CLOCK
❒CLOCK MODE
❒SET DATE
❒SPEEDLOCK
❒INDEPENDENT BOOT
❒DRIVER’S DOOR UNLOCKING❒DISTANCE UNIT
❒CONSUMPTION UNIT
❒TEMPERATURE UNIT (where required)
❒LANGUAGE
❒BUZZER VOLUME
❒BUTTON VOLUME
❒S.B.R. (Seat Belt Reminder) BUZZER
REACTIVATION (*)
❒SERVICE
❒EXIT MENU
(*) This function can be displayed only after Lancia Dealership has deactivated the S.B.R. system.

41
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
ACCESS TO MENU SCREEN
After the “Initial check”, it is possible to access the menu screen pressing the button
Q.
To surf the menu press buttons +or–.
IMPORTANT If after entering the menu no setting/adjustment is performed within 60 seconds, the system exits
the menu automatically and returns to previously displayed screen.
In this case the last selected but not confirmed setting (through button
Q) is not stored and therefore the
operation shall be repeated.
When the car is running, it is possible to access only the reduced menu (for setting “Speed limit” and “Daylight
sensor automatic headlights”).
When the car is stationary access to the whole menu is enabled.
The following diagram shows the cases described.
Q= Press “MODE” button for less than two seconds
R= Press “MODE” button for over two seconds

43
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
Is the car
moving? See
“Initial check”
Extended menu screen
only with the car
at a standstill Example of
standard screen
Menu screen
Q
NO
YES
Speed Lim.
Day Sens.
Exit MenuSpeed Lim.
Light Sensor
Trip B
Clock Adjust.
Clock Mode
Date Adjustm.
Door Lock
Indep. Boot On
Unlock Fda. On
Dist. Unit
Cons.
Temp. Unit
Lang.
Buzzer Vol.
Keys volume
Serv.
Exit Menu
Q= Press “MODE” button for less than two seconds
R= Press “MODE” button for over two seconds

45
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
DAYLIGHT SENSOR AUTOMATIC HEADLIGHTS (Light Sensor) (where provided)
With this function it is possible to adjust the light sensor sensitivity according to 3 levels (level 1 = min. level,
level 2 = average level, level 3 = max. level); the higher the sensitivity is, the lower is the external light intensity
required to switch on the lights. This operation can be performed also with the car moving. The car is delivered
with this setting on level “2”. To set the light level required, proceed as follows:
R
Q
Q
– +
R
– +
See “Initial check”
and “Access to
menu screen”
Menu screen
Return to menu
screen Use the + or – buttons to set the light
sensor sensitivity.
Set selection flashes.
Return to previously
displayed
screen, e.g.:
Q= Press “MODE” button for less than two seconds
R= Press “MODE” button for over two seconds
QR

88
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
AUTOMATIC TWO-ZONE CLIMATE CONTROL SYSTEM (where provided)
GENERAL
The car is fitted with a two-zone climate control
system which makes it possible to separately adjust
the air temperature on the driver’s side and on the
passenger’s side. Temperature control is based on
the “equivalent temperature” logic, i.e.: the system
continuously works to keep constant the comfort
inside the passenger compartment and to
compensate any variation of the outside climate
conditions, including sunshine detected by a proper
sensor provided for the purpose.
The climate control system automatically controls
and adjusts the following parameters and
functions:
❒air temperature at driver/front passenger vents;
❒air distribution at driver/front passenger vents;
❒fan speed (continuous air flow variation);❒compressor switching on (to cool/dehumidify
air);
❒air recirculation.
All the above functions can be changed manually at
any time, i.e.: you can always modify one or more
function settings. In this event, the system will no
longer implement the automatic control of the
functions changed manually (except for safety
reasons, e.g.: risk of window misting).
Manual selections prevail over automatic ones and
remain in storage until the user decides to resume
automatic control, except when the system cuts in
for particular safety conditions.
The control of functions not changed manually
remains automatic.
The amount of air admitted to the passenger
compartment does not depend on the car speed,
since it is electronically controlled by the fan.
In any case, the temperature of the air admitted to
the passenger compartment is controlled
automatically (except when the system is off)
according to the temperatures set on the driver’s
and front passenger’s displays or under certain
climatic conditions if the compressor is off).

103
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
AUTOMATIC HEADLIGHTS SENSOR (daylight sensor)
(where provided)
It detects the changes of the external light intensity of the car
according to the light sensitivity set: greater is the sensitivity, smaller
is the amount of external light necessary to control the switching-on
of the exterior headlights. The daylight sensor sensitivity can be
adjusted with the “Set-up menu” of “multifunction display”.
Activation
Turn the knurled ring to
2A: in this way, the automatic activation of
the side/taillights and dipped beam headlights is simultaneously
enabled according to the external luminosity.
When the daylight sensor is on, the display shows the preset
sensitivity level. During displaying, the sensitivity level can be
adjusted using buttons +and–.
Deactivation
As a result of the sensor control, the dipped beam headlights will
switch off and, after about 10 seconds, sidelights will switch off too.
If during automatic light activation,
main beam headlights have been switched on (manually), they will go
off at automatic light switching off.
IMPORTANT The light sensor is not able to detect the fog presence,
lights shall therefore be switched on manually.
L0D0072m
L0D0025m