Page 4 of 346

USE OF MATERIALS THAT DO NOT HARM THE ENVIRONMENT
None of the car’s components contain asbestos. Padding and the air conditioning system do not contain CFCs
(Chlorofluorocarbides), the gases considered responsible for the destruction of the ozone layer. None of the
colourings and anti-corrosion coatings of the nuts and bolts contain air- or water-table-polluting cadmium or
chromates, but environmentally-friendly substances.
DEVICES FOR REDUCING EMISSIONS (petrol engines)
Three-way catalytic converter (catalytic exhaust pipe)
The exhaust system is equipped with a catalyst made up of noble metal alloys; it is housed in a stainless steel
container capable of withstanding the very high operating temperatures.
The catalyst converts the unburnt hydrocarbons, the carbon monoxide and the nitric oxides found in the exhaust
gases (though in small amounts, thanks to the electronic-injection ignition systems) into non-polluting substances.
When functioning normally, the catalytic converter reaches high temperatures. For this reason do not park the car
over inflammable material (e.g. paper, fuel oil, grass, dead leaves, etc.).
Lambda sensors
The Lambda sensors detect the oxygen content in the exhaust gas. The signal sent by the oxygen sensor is used by
the injection system electronic control unit to constantly mix air and fuel in the correct proportion.
Evaporation control system
As it is impossible to stop the build-up of petrol fumes, also when the engine is not running, the system traps them
in a special container holding active carbon.
The fumes are sucked in from here and burnt while the engine is running.
Page 12 of 346

11
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
MAIN KEY WITH REMOTE CONTROL
The metal insert (A) of the key is grip-retractable.
The key operates:
❒the ignition switch;
❒driver’s door lock;
❒the fuel filler cap locking/unlocking (versions with fuel filler cap
with keylock)
❒passenger side airbag deactivation switch (where provided);
❒cut-in of door lock device D when the electric system is failing
(e.g. run-down battery);
❒cut-in of child lock safety device E on rear doors.
Button B opens the metal insert A.
To refit the metal insert A into the key grip:
– keep button B pressed
– move the metal insert A
– release button B and then turn the metal insert A until hearing the
click as it locks into place.
Button
Ëunlocks the doors, the tailgate and the fuel cap.
Button
Álocks the doors, the tailgate and the fuel cap.
Button
Runlocks the boot.
Led C (where required) comes on when sending the control to the receiver.
WARNINGButton B should only be pressed when the key is away from the body, in
particular from the eyes and from objects that can be spoilt (e.g. clothes). Make
sure the key can never be touched by others, especially children, who may
inadvertently press the button.
L0D0015m
L0D0246m
Page 18 of 346
17
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
KEY WITHOUT REMOTE CONTROL (SPARE KEY)
According to versions the car can be delivered with retractable key 1
or fixed key 2.
The metal insert A of key 1 retracts into the key grip.
Button B opens the metal insert A.
Keys operate the following:
– keep button B pressed
– move the metal insert A
– release button B and then turn the metal insert A until hearing the
click as it locks into place.
L0D0014m
L0D0340m
WARNINGButton B should only be pressed when the key is away from the body, in
particular from the eyes and from objects that can be spoilt (e.g. clothes).
Make sure the key can never be touched by others, especially children, who may
inadvertently press the button.
Page 41 of 346

40
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
INITIAL CHECK
Turning the ignition key to MAR, the multifunction display shows the message “Checking”: the diagnostic
phase of all the electronic systems on the car has started. This lasts few seconds: if no faults are detected, when
the engine has started, the display shows the “Check OK” message.
See section “Warning lights and messages” if faults are found.
Is the
engine
started?YES
If no failures are
present
The “Service schedule” includes vehicle maintenance every 20,000 km (or 12,000 mi) or every year; this is shown automatically,
with the ignition key at MAR, starting from 2,000 km (or 1,240 mi) or 30 days from this deadline and it is shown again every 200
km (or 124 mi) or 3 days. For 1.3 Multijet versions, see “Care and Maintenance” in section “Service schedule to change engine oil
and filter and air cleaner. When a programmed maintenance interval (coupon) is near to come, turning the ignition key to MAR, will
display the message “Service” followed by the number of km, or days to go before car servicing. “Scheduled servicing” message is
displayed in km, miles or days according to the approaching service interval. Contact a Lancia Dealership to carry out any service
operation provided by the “Service schedule” or “Annual inspection plan”, and to reset the display.
If the display shows a failure
message, see details in section
“Warning lights and messages”.
Standard
screen display or
NO
Page 61 of 346

60
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
The “Service schedule” includes vehicle maintenance every 20,000 km (or 12,000 mi) or every year; this is shown automatically,
with the ignition key at MAR, starting from 2,000 km (or 1,240 miles) or 30 days from this deadline and it is shown again every
200 km (or 124 mi) or 3 days. For 1.3 Multijet versions, see “Care and Maintenance” in section “Service schedule” to change engine
oil and filter and air cleaner. When a programmed maintenance interval (coupon) is near to come, turning the ignition key to MAR,
will display the message “Service” followed by the number of km or days to go before car servicing. “Service” message is displayed
in km or mi or days according to the approaching service interval. Contact Lancia Dealership to carry out any service operation
provided by the “Service schedule” or “Annual inspection plan” and to reset the display.
Return to menu
screen Return to
previously
displayed
screen, e.g.:
continued from
previous page
R
Q
Q= Press “MODE” button for less than two seconds
R= Press “MODE” button for over two seconds
Page 125 of 346

124
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
SUNROOF (where provided)
The sunroof is fitted with a safety anti-crushing system able to detect
the presence of an obstacle during the window winding up; should it
happen, the system stops and lowers the window.
The sunroof is fitted with a “skydome” consisting of two glass panels
- one fixed and one moving - with sun visors operated manually in
two positions (open/closed).
The sunroof will only work when the ignition key is at MAR. The
button, next to the front ceiling light, controls opening and closing.
To open
Press and keep button B pressed so that the sunroof front glass panel
reaches the “spoiler” position; press again button (B) and operate it
for more than half a second, so that the sunroof glass reaches the
travel end; the sunroof glass can be stopped in an intermediate
position by operating the button again.
To close
From the complete opening position, press button A and operate it for
more than half a second so that the sunroof front glass panel reaches
the “spoiler” position; operate again the button to stop the sunroof
glass in an intermediate position; press again button A and keep it
pressed until complete closing.
L0D0098m
Page 126 of 346

125
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
L0D0099m
WARNING
Always remove the ignition key when you get out of the car to prevent the sunroof
being operated accidentally and constituting a danger to the people left in the car.
The improper use of the sunroof can be dangerous. Before and during its
operation ensure that any passengers are not at risk from the moving roof either
by personal objects getting caught in the mechanism or by being injured by it
directly. Do not open the sunroof if there is snow or ice on it: it could be damaged.
In case of cross roof rack, you are suggested to use the sunroof only in “spoiler” position.
EMERGENCY OPERATION
If the switch does not work, the sunroof can be operated manually as
follows:
❒remove the protective cover between the two sun visors
❒take the provided Allen wrench
❒insert the provided wrench into the seat A and turn it:
– clockwise to open the sunroof
– counter-clockwise to close the sunroof.
Page 131 of 346

130
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND
CONTROLS
TAILGATE CLOSING
First lower the tailgate using the appropriate handles, as shown in the
figure, and then push the tailgate until it clicks into place.
IMPORTANT If option “Independent boot” is on, before closing the
boot check whether you have with you the ignition key since the boot
will be locked automatically.
L0D0105m
The addition of objects (speakers, spoilers, etc.) on the rear shelf or boot lid, except those
envisaged by the manufacturer, may prevent the gas filled struts at the sides of the boot from
working properly.
WARNING
WARNING
When using the boot, make sure the loads do not exceed the permitted weight (see
“Technical specifications” chapter). Also make sure the items in the boot are
arranged properly to prevent them being thrown forwards and injuring
passengers should you brake sharply.
Never travel with objects on the rear shelf to prevent them being thrown forwards
and injuring passengers in case of accident or sharp braking.