2007 Lancia Musa stop start

HOW TO WARM UP THE ENGINE AFTER IT
HAS JUST STARTED (petrol and Multijet versions)
Proceed as follows:
❒Drive off slowly, letting the engine turn at
medium revs. Do not accelerate abruptly;
❒Do not drive at full performance for the initial
kilometres. Wait until the coolant temperature
gauge starts moving.
EMERGENCY START-UP
If the instrument panel warning light
Ystays on
with fixed light, the emergency start-up can be
performed by using the CODE card code
(see section “In an emergency”).STOPPING THE ENGINE
Turn the ignition to STOP while the engine is idling.
IMPORTANT After a taxing drive, you should allow
the engine to “catch its breath” before turning it off
by letting it idle to allow the temperature in the
engine compartment to fall.
186
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
Never bump start the engine by pushing, towing or coasting downhill. This could cause fuel to
flow into the catalytic exhaust system and damage it beyond repair.
A quick burst on the accelerator before turning off the engine serves absolutely no practical
purpose, it wastes fuel and is damaging especially to turbocharged engines.
Remember that the servobrake and power steering are not operational until the
engine has been started, therefore much effort than usual is required on the brake
pedal and steering wheel.
WARNING

214
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
Warning
light on
dialMessage on
multifunction
display
red
red
w
v
LOW BATTERY CHARGE
Turning the key to MAR the warning light on the dial turns on, but it
should go out as soon as the engine is started (with the engine running
at idle speed a brief delay in going out is allowed).
If it stays on contact immediately Lancia Dealership.
LOW ENGINE OIL PRESSURE
Turning the key to MAR the warning light on the dial turns on, but it
should go off as soon as the engine is started.
If the vwarning light turns on when the car is travelling (on certain versions together with the
message on the display), stop the engine immediately and contact a Lancia Dealership.

215
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
ENGINE COOLANT FLUID HIGH TEMPERATURE
Turning the ignition key to MAR the warning light on the dial turns
on, but it should go off after few seconds.
The warning light turns on (together with the message on the display)
when the engine is overheated. If the warning light comes on when
driving, proceed as follows:
❒normal driving conditions: stop the car, switch off the engine and
check whether the water level in the reservoir is not below the MIN
mark. Otherwise wait for few seconds to allow engine cooling, then
open slowly and carefully the cap, top up coolant and check
whether its level is falling between MIN and MAX marks in the
reservoir. Check visually any leak. If when restarting the warning
light comes on again, contact a Lancia Dealership;
ç
continues on next page
red
Warning
light on
dial Message on
multifunction
display

253
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
IN AN
EMERGENCY
ENGINE STARTING
EMERGENCY START-UP
If the Lancia CODE cannot deactivate the engine
immobilising system, the
YandUwarning lights
stay on and the engine will not start.
To start the engine the emergency start-up can be
performed.
Read the whole procedure carefully before trying to
carry it out. If you make a mistake, you must turn
the ignition key back to STOP and repeat the whole
operation from beginning.
Proceed as follows:
❒Read the 5-figure electronic code given on the
CODE card;
❒Turn the ignition key to MAR;
❒Press and hold down the accelerator pedal. The
instrument panel warning light
Uwill come on
for about 8 seconds and then go out;
❒Release the accelerator pedal and get ready to
count the flashes of the
Uwarning light;
❒Count the number of flashes that corresponds to
the first figure of the code on the CODE card,
then press the accelerator pedal and keep it there
until the
Uwarning light comes on for four
seconds and then goes out; release the
accelerator pedal;
❒TheUwarning light will start flashing again:
after it has flashed the number of times that
corresponds to the second figure on the CODE
card, press the accelerator pedal to the floor and
keep it there;
❒Do the same for the remaining figures on the
CODE card;
❒Once the final figure has been entered, keep the
accelerator pedal pressed. The
Uwarning light
will light up for four seconds and then go out;
release the accelerator pedal;
❒Rapid flashing of the warning light U(for
about 4 seconds) confirms the operation has
been carried out successfully;
❒Start the engine by turning the ignition key from
MAR to AVV.
If however the warning light
Ustays on, turn the
ignition key to STOP and repeat the procedure from
step one
IMPORTANT After an emergency start-up, you
should contact a Lancia Dealership otherwise you
will have to repeat the procedure described each
time you want to start the engine.

255
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
IN AN
EMERGENCY
BUMP STARTING
Never bump start the engine (by pushing, towing,
or coasting downhill) as this could cause fuel to
flow into the catalytic exhaust system and damage
it beyond repair.IMPORTANT Remember that until the engine has
started the brake booster and electrical power
steering systems will not work and a greater effort
will therefore be required to press the brake pedal
or turn the steering wheel.
WARNING
Alert other drivers that the car is stationary in compliance with local regulations:
hazard warning lights, warning triangle etc. Any passengers on board should
leave the car, especially if it is heavily laden. Passengers should stay away from
oncoming traffic while the wheel is being changed on. If the wheel is being
changed on a steep or badly surfaced road, place the wedges or other suitable
material under the wheel to stop the car.

260
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
IN AN
EMERGENCY
It is of vital importance to communicate that the tyre has been repaired using the
quick tyre repair kit. Hand the instruction brochure to the personnel charged with
treating the tyre repaired with the kit.WARNING
❒if reaching the tyre pressure specified in paragraph “Inflation pressure”
in section “Technical Specifications”, start driving immediately;
❒after driving for about 10 minutes stop and check again the tyre pres-
sure; pull up the handbrake;
❒if at least 1.8 bar pressure is read, restore proper pressure (with engine
running and handbrake on) and restart;
❒drive with the utmost care to the nearest Lancia Dealership.
FOR CHECKING AND RESTORING PRESSURE ONLY
The compressor can be also used just for restoring pressure.
Disconnect the quick connection and connect it directly to the tyre
valve; in this way the cylinder is not connected to compressor and the
sealing fluid will not flow into the tyre.
CYLINDER REPLACEMENT PROCEDURE
To replace the cylinder proceed as follows:
❒disconnect connection A;
❒turn counter-clockwise the cylinder to replace and raise it;
❒fit the new cylinder and turn it clockwise;
❒connect connection A to the cylinder and fit the transparent tube B in-
to the proper space.
L0D0367m
L0D0368m

289
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
IN AN
EMERGENCY
WARNING
WARNING
Do not start the engine when towing the car.
WARNING
While the car is being towed with the
engine off, remember that the brake pedal
and steering will require more effort as
you no longer have the benefit of the brake
booster and the electrical power steering.
Do not use flexible cables to tow. Avoid
jerking. Whilst towing, ensure that the
coupling to the car does not damage the
surrounding components. When towing the
car, you must comply with the specific
traffic regulations regarding the tow hitch
and how to tow on the road. TOW RING HOOKING
Proceed as follows:
❒take the tow ring B from its support;
❒tighten the ring on the rear or front threaded pin.
Before starting to tow, turn the ignition
key to MAR and then to STOP. Do not
remove the key. If the key is removed, the
steering lock engages automatically which
prevents the wheels being turned.
L0D0204m
L0D0205m

339
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
DASHBOARDAND CONTROLS
INDEX
– flashing .......................... 100
Manual climate control
system .............................. 83
Mechanical gearbox (use) .... 188
Multifunction display .......... 37
– controls........................... 38
Number plate light
– bulb replacement ........... 277
Oddment compartments ..... 119
– upper .............................. 118
Outlets ................................ 122
Parking ............................. 187
Parking sensors ................... 152
Performance ........................ 330
Plates ................................. 319
Power windows ................... 126
Pretensioners ....................... 162
Prolonged car inactivity ...... 208
Protecting the environment.. 156
Radio transmitters and
cellular telephones ............. 148
Rain sensor ......................... 106Rear fog lights
– bulb replacement ............ 276
– control button ................. 116
Rear window washer
– control ........................... 108
– fluid level ...................... 302
Rear window wipers
– blades ............................ 311
– control ........................... 104
– nozzles ............................ 313
– smart washing ................ 105
Rearview mirrors ................. 79
Rev counter ......................... 27
Reversing light
– bulb replacement ............ 275
Rims and tyres .................... 325
Roof racks ......................... 136
Rubber tubing ..................... 311
Safety devices................... 157
Seat belts
– general instructions ....... 163
– height adjustment .......... 160
– maintenance .................. 165
– S.B.R. system .................. 159
– use ............................ 158-160Seats ................................... 70
Side bags ............................ 178
Side/taillights
– bulb replacement ....... 274-275
– control ........................... 99
Smart washing .................... 105
Snow chains ....................... 207
Sound system
– installation .................... 147
– preset system ................. 147
Spark plugs ......................... 322
Speedometer........................ 27
Starting the engine
– bump starting ................. 255
– emergency start-up ......... 253
– ignition switch ............... 22
– jump starting ................. 254
– JTD engines .................... 184
– petrol engines ................ 184
– stopping the engine ......... 186
– warming up the engine .. 186
Steering ............................... 324
Steering lock ...................... 22
Steering wheel (adjustment) 69
Sunroof ............................... 124
Sun visors ........................... 123