2007 Lancia Musa check engine light

247
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
❒flashing- indicates the possibility of damage to the catalyst (see
“EOBD system” in section “Dashboard and controls”).
If the light flashes, it is necessary to release the accelerator pedal to
lower the speed of the engine until the warning light stops flashing;
continue the journey at moderate speed, trying to avoid driving
conditions that may cause further flashing and contact Lancia
Dealership as soon as possible.U
amber
amber
8:30
continued from previous page
If with ignition key at MAR, the
Uwarning light does not turn on or if it turns on with fixed light
or flashing when the car is travelling (on certain versions together with the message on the display),
contact Lancia Dealership as soon as possible. Warning light
Uoperation can by checked by traf-
fic agents by proper equipment therefore, comply with laws and regulations in force in the country
where you are driving.
GENERIC FAILURE INDICATION
The warning light on the dial comes on when the engine oil pressure
sensor is faulty and, for Multijet versions with modal instrument
panel, also when a failure is detected in diesel fuel sensor. Contact
Lancia Dealership as soon as possible.
è
Warning
light on
dial Message on
multifunction
display

248
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
t
Warning
light on
dialMessage on
multifunction
display
“DUAL FUNCTION SYSTEM” TRANSMIS. FAIL.
(red) (where provided)
Turning the ignition key to MAR the warning light on the cluster shall
come on, but it should go off as soon as the engine is started.
The warning light comes on flashing on the cluster (together with the
message on the multifunction display and the buzzer) to indicate a
gearbox failure.
WARNING
In the case of a gearbox fault, contact Lancia Dealership as soon as possible to
have the system checked. red

259
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
IN AN
EMERGENCY
❒make sure the compressor switch D is set to 0 (off), start the engine
and fit plug A into the nearest current outlet and then turn on the com-
pressor by setting switch D to I (on). Inflate the tyre to the pressure
specified in paragraph “Inflation pressure” in section “Technical Spec-
ifications”.
Check tyre pressure on gauge F with compressor off to obtain pre-
cise reading;
❒if after 5 minutes it is still impossible to reach at least 1.5 bar, disen-
gage compressor from valve and current outlet, then move the car forth
for approx. ten metres in order to distribute the sealing fluid inside the
tyre evenly, then repeat the inflation operation;
❒if after this operation it is still impossible after 5 minutes to reach at
least 1.8 bar, do not start driving since the tyre is excessively damaged
and the quick tyre repair kit cannot guarantee suitable sealing, con-
tact Lancia Dealership;
L0D0364m
L0D0177m
L0D0366m
WARNINGApply the sticker in a visible position for
the driver to indicate that the tyre has
been treated with the quick tyre repair
kit. Drive carefully especially when
cornering. Do not exceed 80 km/h. Avoid
heavy braking and accelerating.
WARNINGIf the pressure falls below 1.8 bars, do not
drive any further: the quick tyre repair
kit Fix & Go automatic cannot guarantee
proper hold because the tyre is too much
damaged. Contact Lancia Dealership.

260
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
IN AN
EMERGENCY
It is of vital importance to communicate that the tyre has been repaired using the
quick tyre repair kit. Hand the instruction brochure to the personnel charged with
treating the tyre repaired with the kit.WARNING
❒if reaching the tyre pressure specified in paragraph “Inflation pressure”
in section “Technical Specifications”, start driving immediately;
❒after driving for about 10 minutes stop and check again the tyre pres-
sure; pull up the handbrake;
❒if at least 1.8 bar pressure is read, restore proper pressure (with engine
running and handbrake on) and restart;
❒drive with the utmost care to the nearest Lancia Dealership.
FOR CHECKING AND RESTORING PRESSURE ONLY
The compressor can be also used just for restoring pressure.
Disconnect the quick connection and connect it directly to the tyre
valve; in this way the cylinder is not connected to compressor and the
sealing fluid will not flow into the tyre.
CYLINDER REPLACEMENT PROCEDURE
To replace the cylinder proceed as follows:
❒disconnect connection A;
❒turn counter-clockwise the cylinder to replace and raise it;
❒fit the new cylinder and turn it clockwise;
❒connect connection A to the cylinder and fit the transparent tube B in-
to the proper space.
L0D0367m
L0D0368m

292
WARNING
LIGHTS AND
MESSAGES
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
SERVICE SCHEDULE
Thousands of km
Check tyre conditions/wear and
adjust pressure if required
Check light system operation
(headlights, direction indicators, hazard lights, boot lights,
passenger compartment lights, dashboard warning lights, etc.)
Check windscreen/washer
(nozzles/and blade position regulation)
Check front disk brake pad conditions and wear
Check rear drum brake lining conditions
and wear
Sight inspect the conditions of: body external parts, underbody
protection pipes and hoses (exhaust, fuel, brakes),
rubber parts (boots, sleeves, bushes, etc.)
Check for bonnet and boot lock cleanness, lever cleanness
and lubrication
Check tension and adjust accessory drive belts
(excluding engines with automatic belt tighteners)
Check tension and adjust accessory drive belts
Check and adjust tappet clearance
(1.48V(where provided)-1.9 Multijet versions)
20 40 60 80 100 120 140 160 180
●●●●● ●●●●
●●●●● ●●●●
●●●●● ●●●●
●●●●● ●●●●
●●●
●●●●● ●●●●
●●●●● ●●●●
●
●● ● ●
●● ● ●

293
WARNING
LIGHTS AND
MESSAGES
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
Thousands of km
Check and adjust handbrake lever stroke
Check exhaust emissions/smoke
(1.3 Multijet and 1.9 Multijet versions)
Check exhaust emissions (petrol versions)
Check antievaporation system (petrol versions)
Change fuel filter cartridge (“green filter”) (diesel versions)
Change air cleaner cartridge (petrol versions)
Change air cleaner cartridge (1.9 Multijet versions) (❏)
Top up fluids
(engine coolant, brakes, windscreen washer, battery, DFN etc.)
Check timing belt conditions (■)
Replace timing belt (*) (■)
Change spark plugs (petrol versions)
Check engine control system operation
(through diagnosis socket)
Change engine oil and oil filter (❏)
Change engine oil and oil filter (Multijet version with DPF) (**)
Change brake fluid (or every 2 years)
Change pollen filter (or every year)
(*) Or every 4 years for particularly demanding use:
- cold/hot climates;
- driving in the city idling for a long time;
- dusty roads or roads covered with sand and/or salt
Or every 5 years, regardless of the km covered and conditions of use.
(**) Engine oil and oil filter shall be changed when the corresponding warning light turns on (see section “Warning lights and Messages”),
or in any case every 2 years.
(
❏) Every 30.000 km for 1.3 Multijet versions
(
■) Excluding 1.3 Multijet versions
20 40 60 80 100 120 140 160 180
●● ● ●
●● ● ●
●● ● ●
●●
●●●
●●●
●●●●● ●●●●
●●●●● ●●●●
●●
●
●● ● ●
●● ● ●
●●●●● ●●●●
(●)(●)(●)(●)(●)(●)(●)(●)(●)
●●●
●●●●● ●●●●

ANNUAL INSPECTION SCHEDULE
For cars with an annual mileage of below 20,000
km (for example about 15,000 km) the following
yearly inspection programme is provided:
❒check tyre conditions/wear and adjust pressure if
required (including the spare wheel);
❒check lighting system operation (headlights,
direction indicators, hazard lights, boot lights,
passenger compartment lights, warning lights,
etc.);
❒check windscreen/washer
(nozzles/and blade position regulation)
❒check front disk brake pad conditions and wear;
❒sight inspect the conditions of: engine, gearbox,
transmission, pipes and hoses (exhaust - fuel -
brakes), rubber parts (boots, sleeves, bushes, etc;
❒check for bonnet and boot lock cleanness, lever
cleanness and lubrication;
❒check battery charge;
❒visual check on various drive belt conditions;
❒top up fluid levels (engine coolant, brakes,
windscreen washer, battery, etc.);
❒change engine oil;
❒change engine oil filter;
❒replace pollen filter (where provided).
ADDITIONAL CHECKS
Every 1,000 km or before long journeys, check and
top up if required:
❒engine coolant fluid level;
❒brake fluid level;
❒windscreen washer fluid level;
❒tyre pressure and conditions.
Every 3,000 km check and top up if required:
engine oil level.
You are recommended to use FL Selenia products,
designed and produced specifically for Lancia cars
(see table “Capacities” in section “Technical
specifications”).
294
WARNING
LIGHTS AND
MESSAGES
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE

297
WARNING
LIGHTS AND
MESSAGES
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
CHECKING FLUID
LEVELS
IMPORTANT When topping up
take care not to confuse the
various types of fluids: they are
all incompatible with one
another and could seriously
damage the car.
IMPORTANT Never smoke
while working in the engine
compartment: gas and
inflammable vapours may be
present, with the risk of fire.
L0D0206m
L0D0259m
1.416Vversions
1.48Vversions (where provided)
1 Engine coolant - 2 Engine
oil- 3 Brake fluid - 4 Battery -
5 Windscreen/rear window