2007 ISUZU KB P190 battery

1-108 HEATER AND AIR CONDITIONING


YES
• Disconnect the A/C switch.
• Is there battery voltage between the chassis side
harness connector terminal No. 6 (B-57) and ground?
Open circuit between the engine room
harness connector terminal No. 1 (C-55) or
(cooler only) the short connector No. 3 (B-
79) and ground (C-109).
NO YES
• Is there continuity between the engine room harness
connector (cooler only) terminal No. 4 (C-55) and the
chassis side harness connector terminal No. 11 (B-57)?
Open circuit between the engine room
harness connector (cooler only) terminal
No. 4 (C-55) and the chassis side harness
connector terminal No. 11 (B-57).
NO YES
• Is there battery voltage between the chassis side
harness connector terminal No. 10 (B-57) and ground?
Open circuit between the chassis side
harness connector No. 1 (B-79) and the
chassis side harness connector terminal
No. 10 (B-57).
NO
YES
• Is the electronic thermostat OK? Open circuit between the No. EB-13 fuse
and the chassis side harness connector
No. 6 (B-57).
NO
YES
• Defective ECM Replace electronic thermostat
NO




BACK TO CHAPTER INDEX
TO MODEL INDEX
ISUZU KB P190 2007

1-110 HEATER AND AIR CONDITIONING
MAGNETIC CLUTCH DOES NOT RUN (4JJ1-TC Standard Output, 4JJ1-TC
High Output, 4JK1-TC High Output LHD MODEL)



Replace
YES
• Are the A/C thermo (X-15), heater & A/C (X-11) and
A/C compressor (X-14) relay OK?
• Are the No. SBF-6 fuse (30A) and the No. EB-13
(10A) fuses OK?
YES
• Is the pressure switch (C-24) OK?
YES
• Are the A/C switch (B-57) and the fan switch (B-13)
OK?
NO
YES
• Is there continuity between the engine harness
connector terminal No.1 (E-3) and the engine room
harness connector terminal No.2 (X-14)?
• Disconnect the A/C compressor relay.
• Turn the ignition switch "ON" (Engine is running)
• A/C switch and fan control knob (fan switch) "ON"
NO
Replace
NO
Defective switch or insufficient
refrigerant
NO
NO
Does the magnetic clutch
operate?
YES
Replace
• Disconnect the magnetic clutch connector.
• Is there battery voltage between the engine room
harness connector terminal No.1 (E-3) and ground?
Defective compressor
YESNO
Defective magnetic clutch
• Is the electronic thermostat (C-55) OK?
YES
Replace
NO


BACK TO CHAPTER INDEX
TO MODEL INDEX
ISUZU KB P190 2007

HEATER AND AIR CONDITIONING 1-111




Open circuit between the engine
harness connector terminal No.1 (E-3)
and the engine room harness
connector terminal No.2 (X-14).
YES
• Is there battery voltage between the engine room
harness connector terminal No.1 (X-14) and
ground?
YES
• Disconnect the A/C thermo relay.
YES
• Is there continuity between the ECM harness
connector terminal No.55 (C-58) and the engine
room harness connector terminal No.5 (X-14)?
NO
Open circuit between the No. EB-13
fuse and the engine room harness
connector terminal No.1 (X-14).
NO
Open circuit between the engine room
harness connector terminal No.3 (X-
14) and the engine room harness
connector terminal No. 1 (X-15).
NO
• Is there continuity between the engine room
harness connector terminal No.3 (X-14) and the
engine room harness connector terminal No.1 (X-
15)?
YES
• Is there continuity between the ECM harness
connector terminal No.4 (C-58) and the engine
room harness connector terminal No.1 (X-15)? Open circuit between the ECM
harness connector terminal No.55 (X-
58) and the engine room harness
connector terminal No. 5 (X-14).
NO
YES
• Is there battery voltage between the engine room
harness connector terminal No.2 (X-15) and
ground? Open circuit between the ECM
harness connector terminal No. 4 (C-
58) and the engine room harness
connector terminal No. 1 (X-15).
NO
YES
• Is there continuity between the engine room
harness connector terminal No. 5 (X-15) and the
engine room harness connector terminal No. 1 (C-
24)?
Open circuit between the No. EB-13
fuse and the engine room harness
connector terminal No. 2 (X-15).
NO
• Disconnect the ECM harness connector.
• Disconnect the pressure switch.



BACK TO CHAPTER INDEX
TO MODEL INDEX
ISUZU KB P190 2007

1-112 HEATER AND AIR CONDITIONING



YES
• Disconnect the condenser fan relay.
YES
• Is there battery voltage between the engine
room harness connector terminal NO.3 (C-
24) and ground? Open circuit between the condenser
fan relay No.3 (X-9) and the engine
room harness connector terminal No.
4 (C-24).
NO
• Is there continuity between the relay terminal
No. 3 (X-9) and engine room harness connector
terminal No.4 (C-24)?
YES
Open circuit between the No. EB-13
fuse and engine room harness
connector terminal No. 3 (C-24).
NO
YES
• Is there battery voltage between the engine
room harness connector terminal No.3 (C-55)
and ground? Open circuit between the engine room
harness connector terminal No. 2 (C-
24) and the engine room harness
connector terminal No. 2 (C-55).
NO
YES
• Is there continuity between the engine room
harness connector terminal No.1 (C-55) and
ground (C-109)? Open circuit between the No. EB-13
fuse and the engine room harness
connector terminal No. 3 (C-55).
NO
• connect the A/C thermo relay connector.
• Disconnect the electronic thermostat.
• Is there continuity between the engine room
harness connector terminal No. 2 (C-55) and the
engine room harness connector terminal No. 2
(C-24)?
Open circuit between the engine room
harness connector terminal No. 5 (X-
15) and the engine room harness
connector terminal No. 1 (C-24).
NO


BACK TO CHAPTER INDEX
TO MODEL INDEX
ISUZU KB P190 2007

HEATER AND AIR CONDITIONING 1-113


YES
• Is the electronic thermostat OK?
Open circuit between the engine room
harness connector terminal No. 1 (C-55)
and ground (C-109).
NO YES
• Disconnect the A/C switch.
• Is there battery voltage between the chassis side
harness connector terminal No. 6 (B-57) and ground?
Open circuit between the No. EB-13 fuse
and the chassis side harness connector
No. 6 (B-57)
NO
YES
• Defective ECM Replace electronic thermostat
NO



BACK TO CHAPTER INDEX
TO MODEL INDEX
ISUZU KB P190 2007

HEATER AND AIR CONDITIONING 1-115
MAGNETIC CLUTCH DOES NOT RUN (C24SE)

Replace
YES
• Are the A/C thermo (X-15), heater & A/C (X-11)
and A/C compressor (X-14) relay OK?
• Are the No. SBF 8 fuse (30A) and the No. EB-13
(10A) fuses OK?
YES
• Is the pressure switch (C-24) OK?
YES
• Are the A/C switch (B-57) and the fan switch (B-13)
OK?
NO
YES
• Is there continuity between the engine harness
connector terminal No.1 (E-2) and the engine room
harness connector terminal No.2 (X-14)?
• Disconnect the A/C compressor relay.
• Turn the ignition switch "ON" (Engine is running)
• A/C switch and fan control knob (fan switch "ON")
NO
Replace
NO
Defective switch or insufficient
refrigerant
NO
NO
Does the magnetic clutch
operate?
YES
Replace
• Disconnect the magnetic clutch connector.
• Is there battery voltage between the engine room
harness connector terminal No.1 (E-2) and ground?
Defective compressor
YESNO
Defective magnetic clutch
• Is the electronic thermostat (C-55) OK?
Replace
NOYES


BACK TO CHAPTER INDEX
TO MODEL INDEX
ISUZU KB P190 2007

1-116 HEATER AND AIR CONDITIONING


Open circuit between the No. EB-13
fuse and the engine room harness
connector terminal No.1 (X-14).
NO
YES
• Is there battery voltage between the engine room
harness connector terminal No.1 (X-14) and
ground?
YES
• Disconnect the A/C thermo relay.
YES
• Is there continuity between the ECM harness
connector terminal C24SE No. 14 (C-56) and the
engine room harness connector terminal No.4
(X-14)?
Open circuit between the No. EB-13
fuse and the engine room harness
connector terminal No. 3 (X-14).
NO
• Is there battery voltage the engine room harness
connector terminal No.3 (X-14) and ground?
YES
• Is there continuity between the ECM harness
connector terminal C24SE No. 26 (C-56) and the
engine room harness connector terminal No. 1
(X-15)? Open circuit between the ECM
harness connector terminal C24SE
No.14 (C-56) and the engine room
harness connector terminal No. 4 (X-
14).
NO
YES
• Is there battery voltage between the engine room
harness connector terminal No. 2 (X-15) and
ground? Open circuit between the ECM
harness connector terminal C24SE
No. 26 (C-56) and the engine room
harness connector terminal No. 1 (X-
15).
NO
YES
• Is there continuity between the engine room
harness connector terminal No. 3 (X-15) and the
engine room harness connector terminal No. 1 (C-
24).
Open circuit between the No. EB-13
fuse and engine room harness
connector terminal No. 2 (X-15).
NO
• Disconnect the ECM harness connector.
• Disconnect the pressure switch?
Open circuit between the engine harness
connector terminal No.1 (E-2) and the
engine room harness connector terminal
No.2 (X-14).
NO


BACK TO CHAPTER INDEX
TO MODEL INDEX
ISUZU KB P190 2007

HEATER AND AIR CONDITIONING 1-117


YES
• Disconnect the condenser fan relay connector condenser
fan.
YES
• Is there battery voltage between the engine room
harness connector terminal NO. 3 (C-24) and ground?Open circuit between the condenser fan
relay No.3 (X-10) and engine room harness
connector terminal No. 4 (C-24).
NO
• Is there continuity between the relay terminal No. 3 (X-
10) and engine room harness connector terminal No.4
(C-24)?
YES
Open circuit between the No. EB-13 fuse
and engine room harness connector
terminal No. 3 (C-24).
NO
YES
• Is there continuity between the engine room harness
connector terminal No. 2 (C-55) and the engine room
harness connector terminal No. 2 (C-24)?
Open circuit between the engine room
harness connector terminal No. 4 (X-15)
and the engine room harness connector
terminal No. 1 (C-24).
NO
• Disconnect the pressure switch.
• Is there continuity between the engine room harness
connector terminal No. 4 (X-15) and the engine room
harness connector terminal No. 1 (C-24).
Open circuit between the No. EB-13 fuse
and the engine room harness connector
terminal No. 2 (X-15).
NO
• Connect the A/C thermo relay connector.
• Disconnect the electronic thermostat.
Open circuit between the engine room
harness connector terminal No.3 (X-15)
and the engine room harness connector
terminal No. 1 (C-24).
NO





BACK TO CHAPTER INDEX
TO MODEL INDEX
ISUZU KB P190 2007