2007 Hyundai Matrix warning

6
OWNER MAINTENANCE
29
G200B01E-EAT
Individual Circuit Fuses
The fuse box containing the individual circuit fuses will be found in the back- side of multi box located in the rightside of driver. The multi box is re- moved by pulling lightly and then re- leasing the lid. A fuse rating grid will befound on the reverse side of the cover. In the event of fuse failure, the fuse should be replaced with one of equiva-lent rating. A fuse removal tool is provided within the fuse box to facili- tate replacement.
HFC4010 In the event of a replacement fuse
failing shortly after installation a mal- function within the circuit protected by that fuse is indicated. The circuit should be checked by a Hyundai authorisedrepairer at the first available opportunity.
G200B01FCG200B03Y
Good
Burned out
!WARNING:
The use of replacement fuses hav- ing a higher rating than specified or other means of connecting the cir-cuit will create a potential fire hazard. NOTE: See page 6-38 for the fuse pannel
descriptions.
fcuk-6.p65 12/27/2006, 10:16 AM
29

6 OWNER MAINTENANCE
30
!
o If battery electrolyte is spilled onto
skin or into eyes, the effected area must be flushed with copious amounts of water and medical as- sistance sought.
o If battery electrolyte is ingested, copious amounts of water or milkfollowed by an ant-acid (raw egg ormilk of magnesia) must be drunk. Vomiting should not be induced and medical assistance must be sought.
o Batteries must only be charged in
well ventilated areas from whichnaked lights or sources of sparks are excluded.
o Ensure that children, pets or other unauthorised persons are kept awayfrom batteries.
o Do not allow anything to bridge the positive (+) and negative (-) termi- nals of the battery.
o Never invert the battery.
The battery fitted during production isof the "Maintenance Free" type. WARNING:
The cooling fan is controlled by
engine coolant temperature and maysometimes operate even when theengine is not running. Do not touch the radiator fan until it is completely stopped.
As the coolant temperature de-
creases the fan will automaticallyshut off. This is a normal condition.
!
BATTERY MAINTENANCE
SG210A1-E
WARNING:
Motor vehicle batteries contain sulphuric acid which is corrosive and poisonous. Hydrogen gas is emitted from the battery which isexplosive when combined with oxy- gen. The following precautions must be strictly observed to avoid per-sonal injury or damage to the ve- hicle. D010B01FC
fcuk-6.p65
12/27/2006, 10:16 AM
30

6
OWNER MAINTENANCE
31
!
SG220A1-E ELECTRIC COOLING FANS
WARNING:
The cooling fan is controlled by
engine coolant temperature and may sometimes operate even when the engine is not running. Use extreme caution when working near theblades of the cooling fan so that you are not injured by a rotating fan blade. As the engine coolant tem-perature decreases, the fan will au- tomatically shut off. This is a nor- mal condition.
The engine cooling fan should operate
before the temperature gauge reachesthe upper portion of the scale and thecondenser fan should operate when- ever the air conditioning is in use.
POWER STEERING FLUID LEVEL
SG230A1-E
HFC5004
G230A02FC
Petrol engine
Diesel engine
The power steering fluid level should be checked daily. To check the power steering fluid level, be sure the ignition is "OFF", thencheck to make certain that the power steering fluid level is between the "MAX" and "MIN" level markings onthe fluid reservoir. NOTE: Grinding noise from power steering pump may be heard immediately after the engine is started in ex-tremely cold condition (below -4°F). If the noise stops dur- ing warm up, there is no abnormalfunction in the system. This is due to a power steering fluid character- istic in extremely cold conditions.
FLUID RECOMMENDATION Only automatic transmission fluidmeeting the specification of PSF-3 or Dexron 2 should be used in the power steering system.
fcuk-6.p65 12/27/2006, 10:16 AM
31

6
OWNER MAINTENANCE
33
!WARNING:
o Do not smoke or have any other open flame near the vehicle whilst bleeding the fuel system.
o Be sure to carefully wipe away
any water drained out in thismanner, because the fuel mixed in the water might be ignited and result in a fire.
G300A02FC
G300A02B-EAT
(Diesel engine)
If the fuel filter warning lamp illumi- nates during driving, it indicates thatwater has accumulated in the fuel filter. If this occurs, remove the water as described. REMOVAL OF WATER FROM THE FUEL FILTER1. Loosen the drain plug at the bottom
of the fuel filter.
2. Tighten the drain plug when water no longer comes out.
3. Check to be sure that the warning lamp illuminates when the ignition key is turned to "ON", and that it goes off when the engine is started. If in doubt, consult your nearest Hyundai authorised repairer.
NOTE: It is recommended that water accu-
mulated in the fuel filter should be removed by an authorised Hyundaiauthorised repairer. G300B02FC
fcuk-6.p65
12/27/2006, 10:16 AM
33

6 OWNER MAINTENANCE
34
G290A01FC
5. Open the bonnet.
6. Draw the vertical line (through the centre of each headlight beam pat- tern) and the horizontal line (through the centre of each headlight beampattern) on the aiming screen.And then, draw the horizontal paral-lel line at 1.18 in. (30 mm) under the horizontal line.
7. Adjust each cut-off line of the low beam to the parallel line with a phillipsscrewdriver - VERTICAL AIMING
8. Adjust each cut-off line of the low beam to each vertical line with a phillips screwdriver - HORIZONTALAIMING.
Horizontal Aiming
Vertical Aiming
HEADLIGHT AIMING ADJUSTMENT
G290A01FC-EAT Before performing aiming adjustment,
make sure of the following.
1. Keep all tyres inflated to the correct
pressure.
2. Place the vehicle on level ground and press the front bumper & rear bumper down several times. Place the vehicle at a distance of 118 in. (3,000 mm) from the test wall.
3. See that the vehicle is unloaded (except for full levels of coolant,engine oil and fuel, and spare tyre,jack, and tools).
4. Clean the head lights lens and turn on the headlight (Low beam).
!WARNING:
o Do not smoke or have any other open flame near the vehicle whilst bleeding the fuel system.
o Be sure to carefully wipe away any water drained out in thismanner, because the fuel mixed in the water might be ignited and result in a fire.
Extracting air in the fuel filter If you drove until you have no fuel left
or if you replaced the fuel filter, be sureto extract air in the fuel system as it makes you difficult to start the engine.
1) Remove the air extract nozzle cap
on the fuel filter.
2) Pump up and down until the fuel flows out of the plug opening.
NOTE: Use cloths when you extract air so
that the fuel is not sprayed around. Clean the fuel around the fuel filteror the injection pump before start- ing the engine to prevent fire. Fi- nally, check each part if the fuel isleaking.
fcuk-6.p65 12/27/2006, 10:16 AM
34

6 OWNER MAINTENANCE
36
!WARNING
The halogen bulb contains gas un-
der pressure and if impacted could shatter, resulting in flying fragments. Always wear eye protection whenservicing the bulb. Protect the bulb against abrasions or scratches and against liquids when lighted. Turnon the bulb only when installed in a headlight. Replace the headlight if damaged or cracked. Keep the bulbout of the reach of children and dispose of the used bulb with care.
G270A02A-GAT
HEADLIGHT BULB Replacement instructions:
1. Allow the bulb to cool. Wear eye protection.
2. Always grasp the bulb by its plastic
base, avoid touching the glass.
3. Disconnect the power cord from the bulb base in the back of the head- light.
4. Remove the dust cover. G270A01FC
5. Push the bulb spring for removing
the headlight bulb.
6. Remove the protective cap from the replacement bulb and install the new bulb by matching the plastic base with the headlight hole. Installthe dust cover after retightening the bulb spring and reconnect the power cord.
7. Use the protective cap and carton
to dispose of the old bulb.
8. Check for proper headlight aim. G270A02FC
fcuk-6.p65
12/27/2006, 10:16 AM
36

6
OWNER MAINTENANCE
37
Socket type
W2.1×9.5D P43t-38
PK22s
BA 15s
W2.1×9.5D S8.5/8.5
W2.1×9.5D W2.1×4.6D Part Name
High Mounted Rear Stop Light Rear Fog Light License Plate Light Luggage Compartment Light Rear Combination Light
No.
1 2 3 4 5 6 7
BULB WATTAGE
G280A02FC-EAT
G280A02FC-D
Part Name
Front Position Light Head Light (High/Low) Front Fog Light (Not all models) Front Turn Signal Light Interior Light Side Repeater Front Door Edge Warning Light (Not all models) No.
89
1011 12
Wattage
5
60/55 55 215
10 10 5
Socket type BA 15s BA 15s
W2.1×9.5D S8.5/8.5
BA 15s
BAY 15d
BA 15s
Map LightRoom Light
Turn Signal Light Stop/Tail Light Back -up Light
Wattage
21 2155
21
21/5 21
fcuk-6.p65 12/27/2006, 10:16 AM
37

8
CONSUMER INFORMATION
5
!
SI060D3-E
WHEEL REPLACEMENT
The original wheels may only be re-
placed with Hyundai Approved wheels.
Tyres of different size, construction or
tread pattern should not be intermixed on the same axle. Radial and cross plytyres should not be used on the same vehicle.
The use of tyres and wheels of non
approved sizes can be dangerous.
WARNING:
o Driving on worn or defective tyres is dangerous. Worn tyres may cause loss of steering control and a serious deterioration of braking efficiency. Defective tyresmay cause vibration and loss of control through blow outs.
o Your vehicle is equipped with tyres designed to provide for saferide and handling capability. Do not use a size and type of tyre and wheel that is different from the one that is originally installedon your vehicle.
SI060B1-E
TYRE REPLACEMENT
0.06 in.(1.6 mm)
Wear indicator I090A02FC
Tyres must be replaced when the wear
indicators appear as a solid bar across the tyre tread. At this point, the re- maining tread depth will be approxi- mately 0.06 in.(1.6 mm). In addition tothis, the tyre must be replaced if any portion of the tread has become bald or if there are any lumps, bulges ordeep cuts in the sidewalls or tread. Replacement tyres must be of the
recommended size and rating andshould be of the same manufacture and tread pattern on each axle.
It can affect the safety and perfor- mance of your vehicle, whichcould lead to handling failure or rollover and serious injury. When replacing the tyres, be sure to equip all four tyres with the tyre and wheel of the same size,type, tread, brand and load-carry- ing capacity. If you nevertheless decide to equip your vehicle withany tyre/wheel combination not recommended by Hyundai for off- road driving, you should not usethese tyres for highway driving.
o Tyres degrade over time, even
when they are not being used.Regardless of the remaining tread, it is recommended that tyres gen- erally be replaced after six (6)years of normal service. Heat caused by hot climates or fre- quent high loading conditions canaccelerate the aging process. Failure to follow this warning can result in sudden tyre failure, whichcould lead to a loss of control and an accident involving seri- ous injury or death.
fcuk-8.p65 12/27/2006, 10:17 AM
5