2007 HONDA ELEMENT lock

The lock tab on the passenger’s door
locks and unlocks only that door.
Pulling up on the driver’s door lock
tab only unlocks the driver’s door.
To lock the driver’s door, remove the
key f rom the ignition switch, pull the
outside door handle and push the
lock tab down or push the door lock
switch down. Release the handle,
then close the door.
To unlock the driver’s door f rom the
outside, turn the key and release it.
To lock all of the doors and hatch,
press the door lock switch on the
driver’s door, or press the lock tab
down on the driver’s door, or use the
keyontheoutsidelock.Pressingup
on the door lock switch will unlock
all of the doors and the hatch.
You will hear a reminder beeper if
you leave the key in the LOCK (0) or
the ACCESSORY (I) position and
open the driver’s door. Remove the
key to turn of f the beeper.
If your vehicle has an automatic
transmission, the shif t lever must be
in Park bef ore you can remove the
key f rom the ignition switch.
Power Door L ocks
Ignit ion Swit ch, Door L ocks
80
DOOR LOCK SWITCH
LOCK TAB
Removing the key from the
ignition switch while driving
locks the steering. This can
cause you to lose control of the
vehicle.
Remove the key from the
ignition switch only when
parked.

Lock the hatch by pushing down
the lock tab on the driver’s door
(see page ), or by using the
master key in the driver’s door
lock.
Lock or unlock the hatch with the
master door lock switch.
Useyourmasterkeytolockand
unlock the hatch. Turn the key
counterclockwise to lock the hatch,
and clockwise to unlock it.
To lock or unlock the hatch.
To open the rear door, pull the rear
door handle located in the rear door
edge. The rear door can be opened
only when the f ront door is open.
To close the doors, close the rear
door first, then the front door. The
f ront door cannot be latched without
f irst closing the rear door. Closing
the rear door on the f ront door will
damage both doors. 80
CONT INUED
Door L ocks
Hatch
Rear Doors
Inst rument s and Cont rols
81
UNLOCK
LOCK

See page for information on
cargo loading. Keep the tailgate and
the hatch closed at all times while
driving to avoid damaging them, and
to prevent exhaust gas from getting
into the interior. See
on page .
Youcanopenthetailgateonlywhen
the hatch is open. To open the
tailgate, slide the lock lever to the
lef t and swing down the tailgate. To
close the tailgate, lif t it up and push
it f irmly until it latches.
Bef ore closing the tailgate, make
sure the hatch is raised. Closing the
tailgate on the lowered hatch can
damage the hatch and the tailgate.
When both the hatch and tailgate are
open, the hatch cannot be latched
without f irst closing the tailgate. To close the hatch, lower it, then
press down on the back edge. With the hatch unlocked, open it by
pulling the handle and lif ting up. 147
54
Door L ocks
Carbon
Monoxide Hazard
Tailgate
82

µ
See pages for important safety
inf ormation and warnings about how to properly position seats and seat-backs. 1413
To change the seat-back angle of the
f ront seat, pull up on the lever on the
outside of the seat bottom. Adjust
theseat-backandmakesureitlocks
into position.
Make all seat adjustments bef ore
you start driving.
To adjust the seat forward and
backward, pull up on the bar under
the seat cushion’s f ront edge. Try to
movetheseattomakesureitis
locked in position.
Seats
Seat A djustmentsFront Seat
Inst rument s and Cont rols
83

To adjust the height of the driver’s
seat, turn the dial on the outside of
the seat bottom.To change the angle of the rear seat-
back, pull the strap at the inside
edge of the seat cushion, make sure
the seat-back locks into position.
Each front seat has an armrest on
thesideof theseat-back.Touseit,
pivotitdown.If equipped
Seats
Driver’s Seat Height Adjustment Front Seat ArmrestsRear Seat
84
SEAT-BACK ADJUSTMENT STRAP

You can recline the seat-backs on the
front seats so they are level with the
rear seat cushions, making a large
cushioned area. To do this: Adjust
the front seats forward as
far as possible. Pull up the seat-
back angle adjustment lever and
pivot the seat-back backward until
it is level with the rear seat
cushion.
Move the front seat backward
until it touches the rear seat.
Adjust the rear seat-back to the
desired position.
Reverse this procedure to return the
fr ont and rear seats to the upright
position. Make sure you install the
head restraints and the seats are
locked securely before driving.
When you return the seat-back to its
upright position, hold the seat-back
to keep it f rom going up too quickly.
Remove the head restraints f rom
the f ront seats (see page ), and
store them in the side pockets of
the cargo area.
1. 2.
3.
4.
85
Reclining the Front Seats
Seats
86

A fastening strap is attached to the
inside of the seat cushion. While
pushing the seat up and toward
thesidewall,hookthefastening
straptothegrabrail.Fold down the seat support.Reverse this procedure to return the
rear seat to the upright position.
When not in use, store the fastening
strap hook in the f abric pocket on
the bottom of the seat cushion.
Make sure the seat is locked
securely.
4. 5.
Seats
88
GRAB RAIL
FASTENING STRAP SEAT SUPPORT

Both seats can be removed to give
more cargo capacity. To remove a
seat:Pull the release strap on the seat
support to unlock the seat support. Remove the cover between the
seat cushion and the side wall by
pulling the tab and pulling the
cover straight up.
Push the lock lever f orward to
unlock the seat.
1. 3.
2.
CONT INUED
Removing the Rear Seats
Seats
Inst rument s and Cont rols
89
RELEASE STRAP
COVERTAB
STEEL HANDLE
LOCK LEVER