2007 HONDA CIVIC HYBRID brake light

[x] Cancel search: brake light

Page 58 of 268

HONDA CIVIC HYBRID 2007 8.G Owners Manual This section gives inf ormation about
the controls and displays that
contribute to the daily operation of
your vehicle. All the essential
controls are within easy reach............................
Con

Page 60 of 268

HONDA CIVIC HYBRID 2007 8.G Owners Manual ÎThe U.S.  instrument  panel is shown.  Differences  for the  Canadian  models are noted  in the  text.
Instrument  Panel
Instru m ent sand Cont ro ls
57
CHARGING  SYSTEM
INDICATOR
SUPPLEMENTAL REST

Page 63 of 268

HONDA CIVIC HYBRID 2007 8.G Owners Manual The left or right  turn signal  indicator
blinks  when you signal  a lane  change
or  turn.  If an  indicator  does not blink
or  blinks  rapidly,  it usually  means
one  of the  turn  signal  bulbs i

Page 66 of 268

HONDA CIVIC HYBRID 2007 8.G Owners Manual If you  turn  the steering  wheel to the
full  left  or right  position  repeatedly
while  stopping  or driving  at very  low
speed,  you may  feel slightly  harder
steering  due to overhe ating of th

Page 77 of 268

HONDA CIVIC HYBRID 2007 8.G Owners Manual ´µ
The buttons under the lef t side vent
control the brightness of the
instrument panel. Push the or
button to adjust the brightness. Pushthebuttontoturnonthe
hazard warning lights (four-way
flash

Page 97 of 268

HONDA CIVIC HYBRID 2007 8.G Owners Manual On Canadian  models
The outside  mirrors  are heated  to
remove  fog and  frost.  With the
ignition  switch in the  ON  (II)
position,  turn on the  heaters  by
pressing  the button.  The indicator  i

Page 149 of 268

HONDA CIVIC HYBRID 2007 8.G Owners Manual You can increase the set cruising
speed in any of these ways:Press and hold the RES/ACCEL
button. When you reach the
desired cruising speed, release the
button.
To increase your speed in very
small am

Page 155 of 268

HONDA CIVIC HYBRID 2007 8.G Owners Manual If the  hood  latch handle  moves
stiffly,  or if you  can open  the hood
without  lifting the handle,  the
mechanism  should be cleaned  and
lubricated.
Put  your  fingers  under the front
edge  of t
Page:   1-8 9-16 17-24 next >