2007 HONDA ACCORD Owners Manual

µ
With the driver’s door open and the
key in the ignition, both door lock
switches are disabled. They are not
disabled if the driver’s door is closed.
Pushing the switch down on the
open passenger’s door will lock all
doors.
The childproof door locks are
designed to prevent children seated
in the rear f rom accidentally opening
the rear doors. Each rear door has a
lock lever near the edge. With the
lever in the LOCK position, the door
cannot be opened f rom inside
regardless of the position of the lock
tab. To open the door, pull the lock
tab up, and use the outside door
handle. Pressthisbuttononceto
lock all doors. Some exterior and
interior lights will f lash. The doors
do not lock if they are not f ully
closed or the key is in the ignition
switch.
L ockout Prevent ionChildproof Door L ocks Remote T ransmitter
LOCK
Door Locks, Remote Transmitter
78
LEVERPANIC
BUTTON
TRUNK
RELEASE
BUTTON LOCK
BUTTON
UNLOCK
BUTTON
LOCK
UNLOCK
——
y
y
(yy

µµ
µ Pressthisbuttonfor
about 1 second to attract attention;
thehornwillsoundandtheexterior
lights will f lash f or about 30 seconds.
To cancel panic mode, press any
other button on the remote
transmitter, or turn the ignition
switch to the ON (II) position.
Pressthisbuttonfor
about 1 second to open the trunk.
You cannot open the trunk if the key
is in the ignition switch.
You cannot lock the doors with the
remote transmitter if they are not
f ully closed or the key is in the
ignition switch.
If you unlock the doors with the
remote transmitter, but do not open
any of the doors within 30 seconds,
the doors automatically relock.
Af ter the doors automatically relock,
the security system will be active.
When you push LOCK twice within 5
seconds, you will hear a beep to
verify that the security system is
active.
Press this button once
to unlock the driver’s door. Push it
twice to unlock the other doors.
The ceiling light (if the ceiling light
switch is in the center position) will
come on when you press the
UNLOCK button. If you do not open
any door, the light stays on f or about
30 seconds, then f ades out. If you
relock the doors with the remote
transmitter before 30 seconds have
elapsed, the light will go of f
immediately.U.S. EX, EX-L, and V6 mo dels
Canadian SE, EX-L, and V6 mo dels
U.S. EX, EX-L, and V6 mo delsCanadian SE, EX-L, and V6 mo delsPA NIC
TRUNK
UNL OCK
Remote Transmitter
Inst rument s and Cont rols
79
——
y
y
(yy

Avoid dropping or throwing the
transmitter.
Protect the transmitter from
extreme temperature.
Do not immerse the transmitter in
any liquid.
If you lose a transmitter, the
replacement needs to be
reprogrammed by your dealer.If it takes several pushes on the
button to lock or unlock the doors,
replace the battery as soon as
possible.
Battery type: CR1616
To replace the battery:Remove the screw at the base of
the transmitter with a small
Phillips-head screwdriver.
Separate the transmitter by prying
its middle seam with your
f ingernail.
1. 2.
Remote Transmitter
Remote Transmitter Care Replacing the Transmitter Battery
80
SCREW
——
y
y
(yy

´
Inside the transmitter, separate
the inner cover f rom the keypad
by releasing the two tabs on the
cover. Remove the old battery from the
back of the inner cover, and note
the polarity. Make sure the
polarity of the new battery is the
same ( side f acing down), then
insert it into the back of the cover.
Install the parts in reverse order.
3. 4. 5.
As required by the FCC:
This device complies with Part 15 of the FCC rules. Operation is subject to thef ollowing two conditions: (1) This device
may not cause harmf ul interf erence, and (2) this device must accept any
interf erence received, includinginterf erence that may cause undesired
operation.
Changes or modif ications not expresslyapproved by the party responsible f or
compliance could void the user’s authority to operate the equipment.
This device complies with IndustryCanada Standard RSS-210.Operation is subject to the f ollowing two
conditions: (1) this device may not causeinterf erence, and (2) this device must
accept any interf erence that may cause undesired operation of the device.
Remote Transmitter
Inst rument s and Cont rols
81
BATTERY
TAB
——
y
y
(yy
An impro perly dispo sed o f battery
c an hurt the enviro nment. Always
c o nfirm lo c al reg ulatio ns fo r battery
dispo sal.

To protect items in the trunk when
you need to give the key to someone
else:Give the person the valet key.
Pull up on the trunk release lever
located to the lef t of the driver’s
seat.
Lockthetrunkreleaseleverwith
the master key. Also make sure
the trunk pass-through cover is
locked (see page ).
Press and hold the trunk release
button on the remote transmitter. To close the trunk, press down on
the trunk lid.
See page f or cargo loading and
weight limit inf ormation. Keep the
trunk lid closed at all times while
driving to avoid damaging the lid,
and to prevent exhaust gas from
getting into the interior. See
on page .
You can open the trunk in either of
the following ways: 1. 2.
165
89
53
Trunk
Carbon
Monoxide Hazard
82
Pull
TRUNK RELEASE LEVER MASTER
KEY
——
y
y
(yy

As a saf ety f eature, your vehicle has
a release lever on the trunk latch so
the trunk can be opened f rom the
inside.To open the trunk, push the release
lever to the lef t.
For more inf ormation about child
saf ety, see page .
38
Emergency T runk Opener
Trunk
Inst rument s and Cont rols
83
V 6 m odel is show n
——
y
y
(yy

After the seat reaches a comfortable
temperature, select LO by pushing
the back of the switch. This will keep
the seat warm.
In HI, the heater turns of f when the
seat gets warm, and turns back on
after the seat’s temperature drops.
In LO, the heater runs continuously.
It does not cycle with temperature
changes.Follow these precautions whenever
you use the seat heaters:
Use the HI setting only to heat the
seats quickly, because it draws
large amounts of current f rom the
battery.
If the engine is lef t idling f or an
extended period, do not use the
seat heaters even on the LO
setting. It can weaken the battery,
causing hard starting.
Both f ront seats are equipped with
seat heaters. Because of the sensors
f or the side airbag system, there is
no heater in the passenger’s seat-
back. The ignition switch must be
ON (II) to use the heaters.
EX-L and EX-V6
Seat Heaters
84
——
y


y
(yy

µ
Raises or lowers the
seat.
Adjusts the seat-back
angle f orward or
backward.
M o ves the who le seat
up and fo rward, o r do wn
and bac kward. The fro nt
o f the seat also tilts up
Moves the seat
f orward and backward.
The controls f or the adjustable
driver’s power seat are on the
outside edge of the seat bottom. You
can adjust the power seat with the
ignition switch in any position. Make
all seat adjustments bef ore you start
driving.
The passenger’s seat has two
switches. One moves the seat
f orward and backward, and the other
adjusts the seat-back angle. To change the lumbar support, move
the lever on the right side of the
seat-back forward or backward.
Keep moving the lever f orward or
backward until you f ind a suitable
position.
See pages f or important saf ety
inf ormation and warnings about how to
properly position seats and seat-backs. 14
13
EX-V6
U.S. EX-L, LX-V6, and EX-V6
Canadian EX-L and V6 mo dels
U.S. EX, EX-L, and EX-V6
Canadian SE, EX-L, and EX-V6
Power Seat Adjustment Driver’s Lumbar Support
Seats
Inst rument s and Cont rols
85
——
y
y
(yy
o r do wn at the same
the same time.