2007 HONDA ACCORD COUPE ignition

Î
Î
CONT INUED
To load or play CDs, the ignition
switch must be in the ACCESSORY
(I) or the ON(II) position.
On models with Satellite Radio You operate the CD changer with
the same controls used f or the radio.
To select the CD changer, press the
CD/AUX button (CD/AUX/XM
button on models with satellite
radio). The number of the track
playing is shown in the display. With
the in-dash CD changer, the disc and
track numbers are displayed. The
system will continuously play a CD
until you change modes.
You cannot load and play 3-inch
(8-cm)discsinthissystem.
:
To Play a CD
A M/FM/CD Changer
Features
141
CD/AUX
BUTTON
EJECT
BUTTON
SEEK/SKIP
BAR
LOAD BUTTON CD LOAD INDICATORCD SLOT
TRACK NUMBER
AM/FM BUTTON
DISC NUMBER RPT BUTTON
RDM
BUTTON
PRESET
BARS
NOTE: This illustration shows the U.S. EX-L and EX-V6 models.
Other models are similar. CD/AUX/XM
BUTTON
AUDIO PWR KNOB
EX, EX-L, SE, and all V6 models without navigation system
——y
y
(#y
y

Your vehicle’s in-dash CD changer
holds up to six discs. You cannot load and play 3-inch(8-cm)discsinthissystem.
When the CD load indicator turns
green and ‘‘LOAd’’ appears in the
screen again, insert the next CD in
the slot.
Do not try to insert a disc until
‘‘LOAd’’ appears. You could
damage the audio unit.
Repeat this until all six positions
are loaded. If you are not loading
all six positions, the system begins
playing the last CD loaded.
Press the LOAD button until you
hear a beep and see ‘‘LOAd’’ in the
display.
To load only one CD, press and
release the LOAD button.
The disc number f or an empty
position is highlighted and the red
CD load indicator starts blinking.
To play the radio when a CD is
playing, press the AM/FM button.
Press the CD/AUX or CD/AUX/XM
button again to switch back to the
CD changer.
To listen to satellite radio when a CD
is playing, press the CD/AUX/XM
button.
To play a tape when a CD is playing,
insert a tape in the player (optional).
If a tape is in the player, press the
CD/AUX or CD/AUX/XM button.
Press the CD/AUX or CD/AUX/XM
button again to switch back to the
CD changer. Insert a disc into the CD slot when
the green CD load indicator comes
on. Insert it only about half way;
the drive will pull it in the rest of
the way. You will see ‘‘BUSY’’ in
the display as the CD load
indicator turns red and blinks as
the CD is loaded.
If you turn the system of f while a CD
is playing, either with the AUDIO
PWR knob or by turning of f the
ignition, the disc will stay in the drive.
When you turn the system back on,
the CD will begin playing where it
left off. 1. 2.
1. 3. 4. 5.
On models with Satellite Radio
L oading CDs in t he In-dash CD
Changer
A M/FM/CD Changer
142
Do not use discs with adhesive labels.
The label can curl up and cause the
disc to jam in the unit.
——y
y
(#y
y

µµ
µ To continuously replay
a track, press and release the RPT
button. You will see RPT in the
display. Press it again to turn it of f .
To continuously
replay the current disc, press and
hold the RPT button. You will see
D-RPT in the display. Press the RPT
button again to turn it off.
Press and release the
RDM button to play the tracks in
random order. You will see RDM in
the display. Press it again to return
to normal play. If a tape is in the optional tape player,
press the CD/AUX or CD/AUX/XM
button to switch to the tape while a
CD is playing. Press the CD/AUX or
CD/AUX/XM button again to switch
back to the CD changer.
PresstheAM/FMorCD/AUX/XM
button to switch to the AM/FM
radio or satellite radio while a CD is
playing. To play the CD, press the
CD/AUX/XM button again.
Press the AM/FM button to switch
to the AM/FM radio while a CD is
playing. To play the CD, press the
CD/AUX button.
If you turn the system of f while a CD
is playing, either with the AUDIO
PWR knob or by turning of f the
ignition, the disc will stay in the drive.
When you turn the system back on,
the CD will begin playing where it
left off.
On models with Satellite Radio
REPEAT
D-REPEA T
RANDOMTo Stop Playing a CD
A M/FM/CD Changer
144
——y
y
(#y
y

µ
´
µ
´
You can also eject discs when the
ignition switch is of f . The disc that
was last selected is ejected f irst.
Load the desired CDs into the
magazine, and load the magazine
into the changer according to the
instructions that came with the unit.
To remove the disc currently in play,
press the eject ( ) button. When
a disc is removed f rom a slot, the
system automatically begins the load
sequence so you can load another
CD in that position. If you do not
remove the disc f rom the changer
within 15 seconds, the system
returns to the previous mode (AM/
FM or satellite radio). The disc will
reload into the system and will
remainthereinapausemode.
To remove a different CD from the
changer,firstselectitwiththe
appropriate preset bar. When that
CD begins playing, press the eject
button. Continue pressing the eject
button to remove all the discs from
the changer. An optional eight disc CD changer is
available for your vehicle from your
dealer.
This disc changer uses the same
controls used f or the in-dash CD
changer or the radio.
To select the CD changer, press the
CD/AUX or CD/AUX/XM button.
The disc and track numbers will be
displayed. To select a dif f erent disc,
use the preset 5 (DISC ) side or
preset 6 (DISC ) side of the preset
bar. To select the previous disc,
press the preset 5 (DISC ), or
preset 6 (DISC ) to select the next
disc in sequence.
If you select an empty slot in the
magazine, the changer will search
f or the next available CD to load and
play.
Operating the Optional CD
Changer
Removing CDs f rom the In-dash
CD Changer
A M/FM/CD Changer
Features
145
——y


y
(#y
y

Û
Î
ÎCONT INUED
Thetapedirectionindicatorcomes
on to show you which side of the
tape is playing. The indicates the
sideyouinsertedupwardisnow
playing. If you want to play the other
side, press the preset 3 (PLAY/
PROG) side of the preset bar. When
the player reaches the end of the
tape, it will automatically reverse
direction and play the other side.
The ignition switch must be in the
ACCESSORY (I) or the ON (II)
position. Make sure the open side of
thetapeisfacingright,theninsert
thetapemostof thewayintotheslot.
Thesystemwillpullthetapeinthe
rest of the way and begin to play it.
On models with Satellite Radio
Optional
:
To Play a Tape
A M/FM/CD Changer
Features
147
AM/FM BUTTON
CD/AUX
BUTTON
PRESET BARS TAPE DIRECTION INDICATOR
DOLBY INDICATOR
REPEAT INDICATOR
SEEK/SKIP BAR
CD/AUX(XM)
BUTTON
NOTE: This illustration shows the U.S. EX-L and EX-V6 models.
Other models are similar. RPT
BUTTON
AUDIO PWR KNOB
EX, EX-L, SE, and all V6 models without navigation system
——y


y
(#y
y

µµ
µ
Î
ÎPress the side to f ind
the beginning of the current song or
passage. Press the side to f ind
the beginning of the next song or
passage. When the system reaches
the beginning of a song or passage, it
begins to play it.
Press the RPT button
to continuously play a song or
passage. You will see RPT displayed.
The track will repeat until you press
the RPT button again.
The skip and repeat
f unctions use silent periods on the
tape to find the end of a song or
passage. These f eatures may not
work if there is almost no gap
between selections, a high noise
level, or a silent period in the middle
of a selection.
To rewind the tape,
push the preset 1 (REW) side of the
preset bar. You will see REW in the
display. To f ast f orward the tape,
push the preset 2 (FF) side of the
preset bar. You will see FF displayed.
Press the preset 1, 2, or 3 side of the
bars to take the system out of rewind
or fast forward.
Dolby noise reduction comes on
when you insert a tape. The
indicator in the display also
comeson.If thetapewasnot
recorded in Dolby, turn it of f by
pressing the preset 4 (NR) side of
the preset bar. Dolby remains of f
until you press the preset bar again. To switch to the AM/FM radio,
Satellite Radio (U.S. models), or CD
changer while a tape is playing, press
the AM/FM or CD/AUX button
(CD/AUX/XM button on models
with satellite radio). To change back
to the tape player, push the CD/AUX
or CD/AUX/XM button.
To remove the tape, press the eject
button on the tape player. If you
want to turn the player off, press the
AUDIO PWR knob or turn of f the
ignition. The tape will remain in the
drive. When you turn the system
back on, the tape will be in pause
mode. Press the preset 3 (PLAY/
PROG) side of the preset bar.
Dolby noise reduction is manuf actured under
license from Dolby Laboratories Licensing
Corporation. ‘‘DOLBY’’ and the double-D symbol are trademarks of Dolby Laboratories
Licensing Corporation.
SK IP
REPEAT
T ape Search Functions
FF/REW
To Stop Playing a Tape
A M/FM/CD Changer
148
NOTE:
——y

y
(#y
y

µµ
µ The seek f unction
searches up and down f rom the
current f requency to f ind a station
with a strong signal. To activate it,
press the or side of the
bar, then release it.
The scan f unction samples
all stations with strong signals on the
selected band. To activate it, touch
the SCAN icon. You will see SCAN in
the display. The system will scan f or
a station with a strong signal. When
it f inds one, it will stop and play that
station for about 5 seconds.
If you do nothing, the system will
scan f or the next strong station and
play it f or 5 seconds. When it plays a
station you want to listen to, touch
the SCAN icon again.
The ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Turn the system on by pushing the
PWR/VOL knob or the AM/FM
button. Adjust the volume by turning
the PWR/VOL knob.
Pushing the AUDIO DISPLAY
button will also turn on the system.
You can use any of f ive methods to
f ind radio stations on the selected
band: TUNE, SEEK, SCAN, the
preset icons, and AUTO SELECT.
Use the TUNE/SOUND
knob to tune the radio to a desired
f requency. Turn the knob right to
tune to a higher f requency, and turn
the knob lef t to tune to a lower
f requency.
The band and f requency that the
radio was last tuned to is displayed.
To change bands, press the AM/FM
button. On the FM band, ST will be
displayed if the station is broadcast-
ing in stereo. Stereo reproduction in
AM is not available.
For inf ormation on XM satellite radio,
see page .
153 SEEK
SCAN
T o Play the A M/FM Radio T o Select a Station
TUNE
A M/FM/CD Changer
150
——y

y
(#y
y

XMis a registered trademark of
XM Satellite Radio, Inc.
Your vehicle is capable of receiving XM
Satellite Radio anywhere in the
United States except Hawaii and
Alaska. It is not available in Canada.
Satellite radio is available on U.S.
models only.
The ignition switch must be in the
ACCESSORY (I) or the ON (II)
position.
Turn the system on by pushing the
PWR/VOL knob, the CD/AUX/XM,
or AUDIO button.
Turn the PWR/VOL knob to adjust
the volume.
U.S. models
A M/FM/CD Changer
To Play XMSatellite Radio
XM
Satellite Radio
Features
153
SCAN ICON
MODE ICON
CHANNEL INDICATOR
SEEK/SKIP BAR
SCAN BUTTON
PWR/VOL KNOB TUNE KNOB
CH/DISC BAR
PRESET ICONS
U.S. EX-L and EX-V6 models with navigation system
CD/AUX/XM
BUTTON
AUDIO BUTTON
——y
y
(#y
y