2007 FIAT SEICENTO clock

12GETTING TO KNOW YOUR CAR
AIRBAGPRETENSIONERS
AND
CLOCK SPRING2019
07
2018 2017
01 02 03 04 05 06
08 09 10 11 122015
07
2014 2013
01 02 03 04 05 06
08 09 10 11 12
ATTENZIONE:
CAUTION:
ACHTUNG: ATTENTION:
fig. 7b
P4Q00226
Operations which lead
to knocks, vibrations or
localised heating (over
100°C for a maximum of 6
hours) in the area around the
pretensioners may cause damage
or trigger them. These devices
are not affected by vibrations
caused by irregularities of the
road surface or low obstacles
such as kerbs, etc. Contact a Fiat
Dealership for any assistance.A small amount of smoke may be
produced. This smoke is in no way
toxic and presents no fire hazard.
The pretensioner does not require
any maintenance or greasing. Anything
that modifies its original conditions in-
validates its efficiency. If due to unusual
natural events (floods, sea storms,
etc.) the device has been affected by
water and mud, it must necessarily be
replaced.
The pretensioner can
only be used once.
After a collision that has
triggered it, have it replaced at
a Fiat Dealership. The validity of
the device is written on the plate
located on the front left door
post. The pretensioners should
be replaced at a Fiat Dealership
as this date approaches..PRETENSIONERS
To increase the efficiency of the front
and rear (where provided) seat belts,
the Fiat Panda is fitted with preten-
sioners. These devices “feel”, through
a sensor, that a violent crash is in
progress and rewind the seat belts a
few centimetres. In this way they en-
sure that the seat belt adheres per-
fectly to the wearer before the re-
straining action begins.
The seat belt locks to indicate that
the device has intervened; the seat belt
cannot be drawn back up even when
guiding it manually.
IMPORTANTTo obtain the high-
est degree of protection from the ac-
tion of the pretensioning device, wear
the seat belt keeping it firmly close to
the chest and pelvis.

22GETTING TO KNOW YOUR CAR
INSTRUMENT PANEL
A.Clock setting button
B.Speedometer
C.Fuel level gauge
D.Trip meter reset button
E. Kilometre or mileage counter
F. Clock.
P4Q01004
fig. 18

24GETTING TO KNOW YOUR CAR
CLOCK
B-fig. 22 Clock display.
To adjust the time press A-fig. 22.
P4Q01056
fig. 22
CUT-OFF SWITCH ON
DISPLAY fig. 23
The display shown appears automat-
ically when the inertial fuel cut-off
switch cuts in, following a crash of a
certain magnitude.
The switch shuts off the supply of
fuel.
IMPORTANTSee the description
in the
CONTROLSparagraph under IN-
ERTIAL FUEL CUT-OFF SWITCH. The clock will advance by one unit
each time the button is pressed. Press
the button and hold it down for a few
seconds to rapidly advance the time
automatically.
When the clock draws near to the
correct time, release the button and
complete the regulation manually.

68GETTING TO KNOW YOUR CAR
IMPORTANTThe hermetic clo-
sure may cause a slight pressure in the
tank: a slight hissing when turning the
cap is quite normal.
To close:
1)the cap coupling is “bayonet”
type. Insert the cap (with the key) and
turn it clockwise until it clicks;
2)keeping the cap still, turn the key
clockwise and remove it; close the
flap.
fig. 92
P4Q01051
Never pour even the
tiniest amount of leaded
petrol in the tank, not
even in an emergency; this would
damage the catalytic exhaust be-
yond repair. FUEL TANK CAP
The fuel filler cap is fitted with a lock.
To open:
1)press on the point indicated and
open the flap fig. 90;
2) holding the cap still, turn the key
anticlockwise fig. 91;
3) turn the cap anticlockwise by
about one fourth of a turn and re-
move it.
The cap is provided with a strap A-
fig. 92fastening it to the flap so that
is cannot be lost.
fig. 90
P4Q00076
fig. 91
P4Q01050
An inefficient catalytic
exhaust causes harmful
emissions with conse-
quent environmental pollution.
REFUELLING
To guarantee full tank filling, carry
out two refuelling operations after the
first click of the fuel delivery gun.
Avoid further topping up operations
that could cause damages to the fuel
system.

95IN AN EMERGENCY
TYPES OF BULBS fig. 11
Several types of bulbs are installed in
the car:
A. Glass bulbs Snapped into posi-
tion. Pull to remove.
B. Bayonet connection bulbs Re-
move from the bulb holder by press-
ing the bulb and rotating it anti-clock-
wise.
C. Cylindrical bulbs Remove by
pulling away from terminals.
D. Double filament halogen
bulbs To remove the bulb release the
clip holding the bulb in place.
E. Halogen bulb To remove the
bulb, release the clip holding the bulb
in place. BULB (fig. 11) TYPE W
MAIN BEAM
DIPPED BEAM
FRONT SIDE LIGHTS
FRONT DIRECTION INDICATORS
SIDE DIRECTION INDICATORS
REAR DIRECTION INDICATORS
BRAKE/TAILLIGHTS
REVERSE LIGHT
REAR FOGLIGHT
CEILING LAMP
NUMBER PLATE LIGHT
FRONT FOGLIGHT
ADDITIONAL BRAKE LIGHT (3rdbrake light)
D
D
A
B
A
B
B
B
B
C
B
E
AH4 60/55
H4 60/55
W5W 5
P21W 21
W5W 5
P21W 21
P21/5W 21/5
P21W 21
P21W 21
CW5 5
R5W 5
H3 55
W5W 5

97IN AN EMERGENCY
3)replace the bulb and refit the bulb
holder A.
Front direction indicators
To replace the 12V-21W bulb:
1) release the clip A-fig. 17, work-
ing in the direction of the arrow;
2)remove the lens unit B-fig. 18
from the front;
3)the bulb holder Cis connected to
the lens. Turn it slightly to remove;
4)remove the bulb D, pushing it in
slightly and turning it anti-clockwise at
the same time;5)after changing the bulb, refit the
bulb holder onto the lens;
6)replace the lens unit in its seating
inserting the tabs E-fig. 19in the
guides Fto the side of the light;
7)refasten the clip A-fig. 17. FRONT SIDE LIGHTS
To replace the 12V-5W bulb:
1)take out the bulb holder A-
fig. 15, turning slightly to release;
2)remove the bulb B-fig. 16;
fig. 16
P4Q01027
fig. 15
P4Q01026
fig. 17
P4Q01028
fig. 18
P4Q00108
fig. 19
P4Q00109

99IN AN EMERGENCY
REAR LIGHT CLUSTER
To replace a bulb:
1)loosen the two screws A-fig. 25
from the respective housings and tip
the lens;
2)remove bulb holder C-fig. 26 re-
leasing clip D; 3)remove bulbs fig. 27, pushing
them slightly and turning them anti-
clockwise;
E- double filament bulb 12V-21/5W
for brake and taillights;
F- 12V-21W bulb for direction in-
dicators;
G- 12V-21W bulb for right light
cluster reversing light; left light cluster
rear foglight. NUMBER PLATE LIGHTS
To replace a bulb:
1) with a screwdriver, press clip as
shown in fig. 28;
2) remove the bulb holder A-fig. 29
from the lens by turning it slightly;
fig. 25
P4Q00175
fig. 26
P4Q00112
fig. 27
P4Q00113
fig. 28
P4Q00114
fig. 29
P4Q00115

145INDEX
I I I I
N N N N
D D D D
E E E E
X X X X
ABS ............................................ 54
Accessories purchased by the
owner ......................................... 66
– Installation of electric/
electronic devices ................ 67
– Radio transmitters and
cellular telephones ............... 67
Air filter ....................................... 117
Air recirculation ......................... 35
Air vents (adjustable) ................ 33
Front airbags ............................... 56
– front airbag passenger side 57
– general warnings .................. 58
– front airbags .......................... 576
Analogue clock ........................... 24
Ashtray ......................................... 42
At the filling station ................... 66
Battery
– checking the carge ............... 119
– checking the fluid level ....... 118
– jump starting .................. 88-105
– recharging .............................. 105– replacing the battery ........... 118
– useful advice .......................... 119
Bodywork
– advice for maintenance ....... 125
– exterior and underbody
warranty ................................. 125
– protection from
atmospheric agents ............. 124
– versions .................................. 129
Bonnet .......................................... 51
Boot ............................................... 47
– anchoring the load ............... 49
– extension ............................... 48
– opening .................................... 47
Brake fluid level .......................... 116
Brake lights .................................. 99
Brakes
– fluid level ................................ 116
– service and emergency ....... 132
Bulbs
– bulb replacement ................. 93
– bulb types .............................. 95
– external bulb replacement . 96
– general instructions ............. 94
– internal bulb replacement .. 101
Capacities .................................. 139
Car maintenance
– additional checks .................. 112
– annual inspection schedule 112
– scheduled service ................. 109
– service schedule ................... 110
Ceiling light
– bulb replacement ................. 100
– control .................................... 39
Centralised locking system ...... 45
Cheap running ............................ 79
Cigar lighter ................................ 42
Clutch ........................................... 131
Conditions of use ...................... 79
Containing running costs ......... 77
Control buttons ......................... 40
Courtesy light
– bulb replacement ................. 101
– control .................................... 39