2007 FIAT IDEA ignition

If you are still unable to start the engine, perform the
emergency start-up procedure (see “Emergency start-
up” in section “In an emergency”) and contact Fiat
Dealership.
IMPORTANT Never leave the ignition key at MAR
when the engine is off.
STARTING PROCEDURE FOR MULTIJET
VERSIONS
Proceed as follows:
❒Ensure that the handbrake is up;
❒Put the gear lever into neutral;
❒Turn the ignition key to MAR: the warning lights
m, Uand Ywill light up on the instrument
panel;
❒Wait for the warning lights
Yand m. The
hotter the engine is, the quicker this will happen;
❒Press the clutch pedal down to the floor without
touching the accelerator;❒Turn the ignition key to AVV as soon as warning
light
mgoes out. If you wait too long you will
lose the benefit of the work done by the glow
plugs. Release the key as soon as the engine starts.
IMPORTANT With cold engine, the accelerator pedal
shall be completely released while turning the ignition
key to AVV.
If the engine does not start at the first attempt, return
the ignition key to STOP before repeating starting.
If, when the ignition key is on MAR, warning light Y
remains lit, turn the key to STOP and then back to
MAR; if the warning light remains on, try with the
other keys provided with the car.
If you still cannot start the engine, contact Fiat
Dealership.
IMPORTANT Never leave the ignition key at MAR
when the engine is off.
179
SAFETY
DEVICES
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
CORRECT USE
OF THE CAR
The warning light mwill flash for 60 seconds at start-up or during prolonged cranking to signal a
fault in the glow plug heating system. You can use the car as usual if the engine starts but you should
contact a Fiat Dealership as soon as possible.

HOW TO WARM UP THE ENGINE AFTER IT
HAS JUST STARTED (petrol and Multijet
versions)
Proceed as follows:
❒Drive off slowly, letting the engine turn at medium
revs. Do not accelerate abruptly;
❒Do not drive at full performance for the initial
kilometres. Wait until the coolant temperature
gauge starts moving.
EMERGENCY START-UP
If the instrument panel warning light
Ystays on with
fixed light, the emergency start-up can be performed
by using the CODE card code (see section “In an
emergency”).STOPPING THE ENGINE
Turn the ignition to STOP while the engine is idling.
IMPORTANT After a taxing drive, you should allow
the engine to “catch its breath” before turning it off by
letting it idle to allow the temperature in the engine
compartment to fall.
180
SAFETY
DEVICES
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
CORRECT USE
OF THE CAR
Never bump start the engine by pushing, towing or coasting downhill. This could cause fuel to flow
into the catalytic exhaust system and damage it beyond repair.
A quick burst on the accelerator before turning off the engine serves absolutely no practical
purpose, it wastes fuel and is damaging especially to turbocharged engines.
Remember that the servobrake and power steering are not operational until the
engine has been started, therefore much effort than usual is required on the brake
pedal and steering wheel.WARNING

PARKING
Proceed as follows:
❒stop the engine and engage the handbrake;
❒engage a gear (on a slope, engage first gear if the car is faced uphill or
reverse if it is faced downhill) and leave the wheels steered.
Block the wheels with a wedge or a stone if the car is parked on a steep
slope. Avoid leaving the car parked with a wheel on the sidewalk or
steered against the kerb. Do not leave the ignition key at MAR to
prevent draining the battery. Always remove the key when you leave
the car.
181
SAFETY
DEVICES
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
CORRECT USE
OF THE CAR
HANDBRAKE
The handbrake lever is located between the two front seats.
Pull the handbrake lever upwards until the car cannot be moved.
Four or five clicks are generally enough when the car is on level ground while nine or ten may be required if the car
is on a steep slope or laden.
IMPORTANT If this is not the case, contact Fiat Dealership to have the handbrake adjusted.
When the handbrake lever is pulled up and the ignition key is at MAR the panel warning light xwill come on.
To release the handbrake:
❒slightly lift the handbrake and press release button (A);
❒keep button (A) pressed in and lower the lever. Warning light xwill go out.
Press the brake pedal when carrying out this operation to prevent the car from moving accidentally.
IMPORTANT If the handbrake lever tends to approach the end of stroke (slot on central console), contact Fiat
Dealership to have the handbrake adjusted.
WARNINGNever leave children unattended in the car. Always remove the ignition key when
leaving the car and take it out with you.
F0H0149m

192
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
WARNING
LIGHTS AND
MESSAGES
GENERAL WARNINGS
Failure indicationsshown on the reconfigurable
multifunction display together with buzzer sounding
(adjustable) and warning light (if any) coming on on the
cluster, are accompanied by specific warning
messages(e.g.: “Switch off engine”, etc...). These
indications are concise and cautionaryand are
aimed to suggest the prompt actionthe driver must
adopt when a car malfunctioning appears. These
indications, however, shall not be considered as
exhaustive and/or as an alternative to the
specifications contained in this “Owner Handbook”,
which shall always be read through carefully and
thoroughly. In case of failure indication always refer
to the specifications contained in this section.
IMPORTANT Failure indications displayed on the
reconfigurable multifunction display are divided into
two categories: very serious failures and
serious/minor failures.
The message and the warning indication corresponding
to very serious failures are displayed alternately for
few seconds. This “cycle” is repeated indefinitely and it
stops any previous indication on the display. It is
displayed every time the ignition key is turned to MAR,
until the cause of malfunctioning is removed. Should failure disappear, message and warning light will
however stay on for about 2 seconds. Eliminating the
failure, the warning light and the displayed message will
go off. It is possible to stop this “cycle” by pressing
button Q; in this case the screen active before the
failure will be resumed and the warning light will stay
on until eliminating the failure cause.
The message and the warning indication corresponding
to serious/minorfailures are displayed alternately for
few seconds. This “cycle” is repeated for about 20
seconds and then goes off, but it comes on again every
time the ignition key is turned to MAR.
Should failure disappear during the 20 seconds
displaying, message and warning light will stay on for
about 2 seconds. Eliminating the failure, the warning
light and the displayed message will go off.
At the end of the display cycle (which lasts approx. 20
seconds), or if button Qis pressed, the screen active
before the failure will be resumed and the warning
light will stay on until eliminating the failure cause.
Q= Press button “MODE” for less than two seconds
R= Press button “MODE” for over two seconds

193
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
WARNING
LIGHTS AND
MESSAGES
LOW BRAKE FLUID LEVEL
Turning the ignition key to MAR the warning light
on the dial turns on, but it should go off after few
seconds.
The warning light turns on (together with the
message on the display, on certain versions) when
the level of the brake fluid in the reservoir falls
below the minimum level, due to possible leak in
the circuit.x
HANDBRAKE ON
Turning the ignition key to MAR the warning light
on the dial turns on, but it should go off after few
seconds. The warning light turns on when the
handbrake is on.
IMPORTANT If the warning light
xturns on
when travelling
check that the handbrake is not engaged.
x
Warning
light on dialMessage on
multifunction display Message on reconfigurable
multifunction display
WARNINGIf the warning light xturns on when travelling (on certain versions together with the
message on the display) stop the car immediately and contact Fiat Dealership.red
red

194
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
WARNING
LIGHTS AND
MESSAGES
FRONT PASSENGER AIR BAG
DEACTIVATED (where required)
Dial warning light comes on when front
passenger air bag is deactivated. With front
passenger air bag on, turning the ignition key to
MAR, warning light
Fcomes on flashing on the
cluster for about 4 seconds, then it shall go off.
F
SEAT BELTS NOT FASTENED
The warning light will come on flashing, together
with the warning buzzer when, with the car
moving, the driver's seat belt is not correctly
fastened. The S.B.R. (Seat Belt Reminder) buzzer
can only be excluded by Fiat Dealership. On
versions fitted with reconfigurable multifunction
display (Comfort), the system can be reactivated
through the set-up menu (see diagram aside).
<
WARNINGWarning light Findicates also warning light ¬failure. This is indicated by
intermittent flashing, over 4 seconds, of warning light F. In this event, warning
light ¬could be not up to indicate restraint system failures, if any. Stop the car
and contact Fiat Dealership to have the system checked. amber
red
Warning
light on dialMessage on reconfigurable
multifunction displayMessage on
multifunction display

196
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
WARNING
LIGHTS AND
MESSAGES
ENGINE COOLANT FLUID HIGH
TEMPERATURE
Turning the ignition key to MAR the warning
light on the dial turns on, but it should go off
after few seconds.
The warning light turns on (on certain versions
together with the message on the display) when
the engine is overheated. If the warning light
comes on when driving, proceed as follows:
❒normal driving conditions: stop the car,
switch off the engine and check whether the
water level in the reservoir is not below the
MIN mark. Otherwise wait for few seconds
to allow engine cooling, then open slowly and
carefully the cap, top up coolant and check
whether its level is falling between MIN and
MAX marks in the reservoir. Check visually
any leak. If when restarting the warning light
comes on again, contact a Fiat Dealership;
ç
continues on next page
red
Warning
light on dialMessage on reconfigurable
multifunction displayMessage on
multifunction display

mGLOW PLUGS (Multijet versions)
Turning the ignition key to MAR, the warning
light on the dial comes on and goes off when
glow plugs reach the preset temperature. Start
the engine immediately after warning light
switching off.
IMPORTANT With high ambient temperature,
warning light stays on for very short time.amber
Warning
light on dial Message on
multifunction displayMessage on reconfigurable
multifunction display
201
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
WARNING
LIGHTS AND
MESSAGES