2007 FIAT IDEA boot

The tilted seats are fastened in this position by the action of the side
struts.
Partial extension
Operating the required part (right or left) of the seat in the same way it
is possible to obtain partial extension of the boot as illustrated.
IMPORTANT For rear seat complete tilting it could be necessary to
move the front seats forward.
To return the cushions on the floor
Use tapes (B) to return the cushions on the floor.
132
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
F0H0111m
F0H0112m
F0H0110m
With table folded seats, in the event of a
crash it can be dangerous to carry heavy
objects on the rear seat back.WARNING
WARNINGThe position of the rear seat backs folded
on the respective cushions shall not be
considered a loading position and
therefore cannot bear heavy weights.
If the central seat belt is fastened to the
seat, release it before tilting the seat.WARNING

EXTENDING THE BOOT WITH FIXED SEAT
Proceed as follows:
❒fasten the seat buckles to the tabs on the seat back (as shown by
arrows);
❒check that the webbing (C) of each of the two side seat belts is
inserted into the respective belt guiding catch (D);
❒raise the cushion (A) as shown in the figure
❒release the seat back moving the levers (B) as shown by the arrow. Tilt
it to make a single loading surface with the boot floor;
❒if vertical space must be increased, remove Cargo box (where
provided) positioned under load plane mat.
133
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
F0H0346m
F0H0347m

137
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
F0H0117m
F0H0118m
F0H0119m
To adjust the headlight slant
To adjust the headlight slant operate buttons
and Òlocated on the
dashboard.
The display provides the visual indication of the positions during the
adjustment operation.
Position 0 - one or two people occupying the front seats.
Position 1 - five people.
Position 2 - five people + load in the boot.
Position 3 - driver + maximum permissible load stowed in the boot.
IMPORTANT Check beam aiming every time the load carried changes.
HEADLIGHT ADJUSTMENT ABROAD
The dipped-beam headlights are adjusted for circulation in the country in
which the vehicle is marketed. In countries with opposite circulation, to
avoid glaring oncoming vehicles, it is necessary to cover the areas of the
headlight as shown below: this is done using non-transparent sticker tape.
Figures refer to passing from right-hand drive to left-hand drive.

CONTAINING RUNNING COSTS
Here are some suggestions which may help you to
keep the running costs of your car down and lower
the amount of toxic emissions released into the
atmosphere.
GENERAL CONSIDERATIONS
Car maintenance
Have checks and adjustments carried out in
accordance with the “Service schedule”.
Tyres
Check the pressure of the tyres routinely at an
interval of no more than 4 weeks: if the pressure is
too low, consumption levels increase as resistance to
rolling is higher.
Unnecessary loads
Do not travel with too much luggage stowed in the
boot. The weight of the car (especially when driving in
town) and its trim greatly affects consumption and
stability.Roof rack/ski rack
Remove the roof rack or the ski rack from the roof as
soon as they are no longer used. These accessories
lower air penetration and adversely affect
consumption levels. When needing to carry
particularly voluminous objects, preferably use a
trailer.
Electric devices
Use electric devices only for the amount of time
needed. Rear heated window, additional headlights,
windscreen wipers and heater fan need a considerable
amount of energy, therefore increasing the
requirement of current increases fuel consumption (up
to +25% in the urban cycle).
Climate control
The air conditioner is an additional load which greatly
affects the engine leading to higher consumption (on
average up to +20%). When the temperature outside
the vehicle permits it, use the air vents where possible.
Spoilers
The use of non-certified aerodynamic items may
adversely affect air drag and consumption levels.
183
SAFETY
DEVICES
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
CORRECT USE
OF THE CAR

198
SAFETY
DEVICES
CORRECT USE
OF THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
WARNING
LIGHTS AND
MESSAGES
INCOMPLETE DOOR LOCKING
The warning light on the dial turns on (on certain
versions together with the message on the
display) when one or more doors, the boot or
the bonnet are not properly shut.
Symbols
¯/˙shown on the display indicate
incomplete left/right door closing.
´
(*) Or rear
red
green
Warning
light on dialMessage on reconfigurable
multifunction displayMessage on
multifunction display
(*)
“DUALDRIVE” ELECTRIC POWER
STEERING SYSTEM
On versions with modal instrument panel the
warning light turns on when the “dualdrive”
electric power steering is activated.
On versions with comfort instrument panel, the
message CITY is displayed on the reconfigurable
multifunction display when the “dualdrive”
electric power steering is activated.
X

225
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
FIX & GO automatic (QUICK TYRE REPAIR
KIT) (where provided)
The quick tyre repair kit Fix & Go automatic is placed in the boot.
The kit includes:
❒bottle (A) containing sealer and fitted with:
– filling pipe (B);
– sticker (C) bearing the notice “max. 80 km/h”, to be placed in a posi-
tion visible to the driver (on the instrument panel) after fixing the tyre;
❒instruction brochure, to be used for prompt and proper use of the quick
repair kit and to be then handed to the personnel charged with handling
the treated tyre;
❒compressor (D) including gauge and connections;
❒a pair of protection gloves located in the side space of the compressor;
❒adapters for inflating different elements.
In the kit container (placed in the boot under the carpet) are also housed
the screwdriver and the tow hitch.
F0H0354m
F0H0355m
Hand the instruction brochure to the personnel charged with treating the tyre
repaired with the kit.WARNING

236
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
For versions with alloy rims
❒Make sure that hub contact surfaces are clean;
❒Refit the standard wheel fitting it on the pins, refit the fastening bolts
and tighten them using the wrench provided;
❒Lower the car and remove the jack;
❒Using the wrench provided, tighten the bolts in the sequence shown
previously for the space-saver spare wheel (see figure);
❒Refit the snap-fitted wheel hub cap.
When you have finished
❒Stow the spare wheel (C) in the space provided in the boot;
❒Insert the jack partially open in its container (B) forcing it lightly to
prevent it from vibrating when travelling;
❒Put the tools back into their places in the container;
❒Stow the container complete with tools on the spare wheel and
secure everything with the clamping device (A);
❒Correctly re-position the stiff cover.
F0H0161m

239
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
IN AN
EMERGENCY
Bulb Ref. Figure Type Power
Main beam headlightsEH1 55W
Dipped beam headlights DH7 55W
Front side lights AW5W 5W
Front fog lights (where provided)EH1 55W
Front direction indicators BPY21W 21W
Side direction indicators AWY5W 5W
Rear direction indicators BPY21W 21W
Taillights BP21/5W 21W/5W
Brake lights BP21/5W 21W/5W
Third brake light (additional brake lights) AW5W 5W
Reversing light BP21W 21W
Rear fog lights BP21W 21W
Number plate lights CC5W 5W
Front ceiling lightAW5W 10W
Rear ceiling lightAW5W 10W
Rear ceiling lights (with sunroof)AW5W 5W
Boot light AW5W 5W