2007 FIAT IDEA engine

ENGINE COOLANT FLUID
The coolant level shall be checked with cold engine and shall be included
between the MIN and MAX mark on the reservoir.
If the level is low, pour slowly a mixture of 50% distilled water and 50%
FL Selenia PARAFLU UP through the filler neck.
A 50-50 mixture of PARAFLU UP and distilled water gives freeze
protection to –35°C.
IMPORTANT Do not remove the reservoir cap when the engine is hot:
you risk scalding yourself.
269
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
CAR
MAINTENANCE
F0H0210m
F0H0211m
1.2 16V, 1.4 8V (where provided),
1.4 16V versions
1.3 Multijet and 1.9 Multijet versions
The cooling system is pressurised. If necessary, replace the cap only with another
genuine one, otherwise system efficiency could be compromised.WARNING
WARNINGThe cooling system uses PARAFLU UP antifreeze. Do not add fluid having different
specifications from that already existing. PARAFLU UP cannot be mixed with other
types of fluids. Should other fluids be added, do not start the engine and contact
Fiat Dealership as soon as possible.

WINDSCREEN/REAR WINDOW/HEADLIGHT WASHER
FLUID
To top up, remove the cap (A) and then pour a mixture of water and
TUTELA PROFESSIONAL SC 35, in the following concentrations:
❒30% TUTELA PROFESSIONAL SC 35 and 70% water in summer;
❒50% TUTELA PROFESSIONAL SC 35 and 50% water in winter.
In case of temperatures below –20°C, use undiluted TUTELA
PROFESSIONAL SC 35.
Check level through the reservoir.
270
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
CAR
MAINTENANCE
F0H0212m
WARNINGDo not travel with the windscreen washer reservoir empty: the windscreen washer
is fundamental for improving visibility.
WARNINGCertain commercial additives for windscreen washers are inflammable. The engine
compartment contains hot components which may set it on fire.

DIESEL FUEL FILTER
(“green filter”)
DRAINING THE CONDENSE (diesel versions)
IMPORTANT The presence of water in the fuel circuit
may cause serious damage to the entire injection
system and cause irregular engine operation. If the
warning light
cturns on (or on certain versions, adedicated message is shown on the reconfigurable
multifunction display) contact a Fiat Dealership as soon
as possible to have the bleeding operation carried out.
272
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
CAR
MAINTENANCE
WARNINGThe presence of water in the fuel circuit may cause serious damage to the entire
injection system and cause irregular engine operation. If the warning light
cturns
on (or on certain versions, a dedicated message is shown on the reconfigurable
multifunction display) contact a Fiat Dealership as soon as possible to have the
bleeding operation carried out. Should the above indications take place after
refuelling, water has probably been poured into the tank: turn the engine off
immediately and contact a Fiat Dealership.

USEFUL ADVICE FOR
LENGTHENING THE LIFE OF YOUR
BATTERY
To avoid draining your battery and lengthen its life,
observe the following indications:
❒when you park the car, ensure the doors, tailgate
and bonnet are closed properly;
❒the ceiling lights must be off. The car is however
provided with an automatic system for switching off
internal lights;
❒do not keep accessories (e.g.: sound system, hazard
lights, etc.) switched on for a long time when the
engine is not running;
❒before performing any operation on the electrical
system, disconnect the battery negative cable;
❒battery terminals shall always be perfectly
tightened.IMPORTANT A battery which is kept at a charge of
less than 50% (optical indicator with dark colour
without green area in the middle) for any length of
time will be damaged by sulphation leading to a
reduction in cranking power. Moreover, this might
lead to a higher risk of the battery electrolyte freezing
(this may even occur at -10°C).
If the car is left inactive for a long period of time, refer
to “Car inactivity”, in section “Correct use of the car”.
If after buying the car, you want to install electric
accessories which require permanent electric supply
(alarm, free-hands set, etc.) contact Fiat Dealership
whose qualified personnel, in addition to suggesting
the most suitable devices of the Lineaccessori Fiat, will
evaluate the overall electric absorption, checking
whether the car’s electric system is capable of
withstanding the load required, or whether it should
be integrated with a more powerful battery.
275
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
CAR
MAINTENANCE

284
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
CAR
MAINTENANCE
Engine compartment
At the end of the winter the engine compartment
should be carefully washed, without directing the jet
against electronic control units. Contact a specialised
workshop to have this done.
IMPORTANT Washing should be carried out with the
engine cold and the ignition key at STOP. After
washing make sure that the various protections (e.g.:
rubber caps and various covers) have not been
damaged or removed.INTERIORS
Periodically check that water is not trapped under the
mats (due to water dripping off shoes, umbrellas, etc.)
which could cause oxidisation of the sheet metal.
CLEANING SEATS AND FABRIC AND
VELVET PARTS
Use a soft brush or vacuum cleaner to remove dust.
Velvet is cleaned better if the brush is moistened.
Rub the seats with a sponge moistened with a solution
of water and neutral detergent.
CLEANING LEATHER SEATS
Remove dried on dirt with lightly moistened chamois
leather or cloth without pressing too hard.
Remove liquid or grease stains with a dry absorbent
cloth without rubbing. Then wipe with a soft cloth or
chamois leather with water and neutral soap.
If the stain persists, use specific products, carefully
following the instructions for use.
IMPORTANT Never use spirit or alcohol-based
products.
WARNINGNever use flammable
products like oil ether or
rectified petrol for
cleaning car interiors.
Electrostatic discharges
generated by rubbing
during cleaning
operations could cause
fire.

286
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
INDEX
DASHBOARD
AND CONTROLS
TECHNICAL
SPECIFICATIONS
T T
E E
C C
H H
N N
I I
C C
A A
L L
S S
P P
E E
C C
I I
F F
I I
C C
A A
T T
I I
O O
N N
S S
IDENTIFICATION DATA ................................................. 287
ENGINE CODES - BODYWORK VERSIONS .............. 289
ENGINE ................................................................................. 290
FUEL FEED/IGNITION ....................................................... 292
TRANSMISSION .................................................................. 292
BRAKES ................................................................................... 293
SUSPENSIONS ....................................................................... 293
STEERING............................................................................... 293
WHEELS .................................................................................. 294
DIMENSIONS ........................................................................ 297
PERFORMANCE ................................................................... 298
WEIGHTS ............................................................................... 299
CAPACITIES........................................................................... 300
FLUIDS AND LUBRICANTS ............................................. 301
FUEL CONSUMPTION ....................................................... 303
CO
2EMISSIONS .................................................................. 304

IDENTIFICATION DATA
You are advised to note the identification codes. The identification data
stamped and given on the plates and their position are the following:
1 - Model plate
2 - Chassis marking
3 - Bodywork paint identification plate
4 - Engine marking.
MODEL PLATE
The plate is to be found on the front crossmember of the engine
compartment and bears the following identification data:
A - Manufacturer’ name.
B - Homologation number.
C - Vehicle type code.
D - Chassis number.
E - Maximum vehicle weight fully loaded.
F - Maximum vehicle weight fully loaded with trailer.
G - Maximum vehicle weight on front axle.
H - Maximum vehicle weight on rear axle.
I - Engine type.
L - Body version code.
M - Spare part code.
N - Smoke opacity index (for diesel engines).
287
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
INDEX
DASHBOARD
AND CONTROLS
TECHNICAL
SPECIFICATIONS
4
21
3F0H0225m
F0H0226m

CHASSIS MARKING
It is printed on the passenger compartment floor, near the right-hand
front seat.
It can be reached by lifting the special flap in the carpeting and includes
the following data:
❒car model;
❒chassis number.
BODYWORK PAINT
IDENTIFICATION PLATE
It is applied on front bonnet and shows following data:
A - Paint manufacturer.
B - Colour name.
C - Fiat colour code.
D - Respray and touch up code.
ENGINE MARKING
Engine marking is stamped on the cylinder block on passenger
compartment side and includes the model and the chassis number.
288
SAFETY
DEVICES
CORRECT USE
OF THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
INDEX
DASHBOARD
AND CONTROLS
TECHNICAL
SPECIFICATIONS
F0H0228m
F0H0227m