2007 DODGE NITRO display

NOTE:Your system can be set to display pressure units
in PSI, kPA or BAR.
NOTE:A low spare tire will not cause the “Tire Pressure
Monitoring Telltale Light” to illuminate or the chime to
sound.
Should a low tire condition occur on any of the four
active road tire(s), you should stop as soon as possible,and inflate the low tire(s) that is flashing on the graphic
display to the vehicle’s recommended cold placard pres-
sure value. The system will automatically update, the
graphic display of the pressure value(s) will stop flash-
ing, and the “Tire Pressure Monitoring Telltale Light”
will extinguish once the updated tire pressure(s) have
been received. The vehicle may need to be driven for up
to 10 minutes above 15 mph (24 km/h) to receive this
information.
Check TPM System Message
The “Tire Pressure Monitoring Telltale Light” will
flash on and off for 60 seconds and an audible
chime will sound when a system fault is detected.
The flash cycle will repeat every ten minutes, without an
audible chime until the fault condition no longer exists.
The EVIC will display the “CHECK TPM SYSTEM”
message for 3 seconds. This text message is then followed
STARTING AND OPERATING 293
5

by a graphic display, with “- -“ in place of the pressure
value(s) indicating which Tire Pressure Monitoring Sen-
sor(s) is not being received.
NOTE:Your system can be set to display pressure units
in PSI, kPA or BAR.If the ignition key is cycled, this sequence will repeat,
providing the system fault still exists. If the system fault
no longer exists, the “Tire Pressure Monitoring Telltale
Light” will no longer flash, theCHECK TPM SYSTEM
text message will not be present, and a pressure value
will be displayed instead of dashes.
NOTE:Your vehicle is either equipped with the stan-
dard compact spare tire or an optional non-matching full
size spare tire. Both of these spare tires do not have a tire
pressure monitoring sensor. Therefore, they will not be
monitored by the Tire Pressure Monitor System (TPMS).
In the event that the non-matching full size or compact
spare tire is swapped with a low pressure road tire, the
next ignition key cycle will still show the “Tire Pressure
Monitoring Telltale Light” to be ON, a chime to sound,
and the Electronic Vehicle Information Center (EVIC) will
still show the low tire pressure value flashing on the
graphic display.
294 STARTING AND OPERATING

However, driving the vehicle for up to 10 minutes above
15 mph (24 km/h) will display a “CHECK TPM SYS-
TEM” text message on the EVIC. This text message will
then be followed by a graphic display, with “- -“ in place
of the flashing low pressure value. For every subsequent
key cycle, the “Tire Pressure Monitoring Telltale Light”
will be ON, a chime will sound, a “CHECK TPM SYS-
TEM” text message will be displayed in the EVIC, and
the graphic display will have “- -“ in place of a pressure
value. After the original road tire has been properly
repaired, and put back onto the vehicle in place of the
non-matching full size or compact spare tire, the TPMS
will update the graphic display on the EVIC with a new
tire pressure value instead of “- -“, and the “Tire Pressure
Monitoring Telltale Light” will be OFF as long as none of
the road tires are below the low pressure warning thresh-
old. The vehicle may need to be driven for up to 10
minutes above 15 mph (24 km/h) to receive this infor-
mation.General Information
This device complies with part 15 of the FCC rules and
RSS 210 of Industry Canada. Operation is subject to the
following conditions:
•This device may not cause harmful interference.
•This device must accept any interference received,
including interference that may cause undesired op-
eration.
The tire pressure sensors are covered under one of the
following licenses:
United States.....................KR5S120123
Canada........................2671-S120123
STARTING AND OPERATING 295
5

NOTE:Tighten the gas cap about 1/4 turn until you
hear one click. This is an indication that cap is properly
tightened.
If the gas cap is not tighten properly, the Malfunction
Indicator Light will come on. Be sure the gas cap is
tightened every time the vehicle is refueled.
WARNING!
A fire may result if gasoline is pumped into a
portable container that is inside of a vehicle. You
could be burned. Always place gas containers on the
ground while filling.
Loose Fuel Filler Cap Message
If the vehicle diagnostic system determines that the fuel
filler cap is loose, improperly installed, or damaged, a
“CHECK GASCAP” message will be displayed in the
EVIC (Electronic Vehicle Information Center). Refer to
“Electronic Vehicle Information Center” in Section 4 of
this manual. Tighten the fuel filler cap until a “clicking”
sound is heard. This is an indication that the fuel filler
cap is properly tightened. Refer to “Onboard Diagnostic
System — OBDII” in Section 7 of this manual for more
information.
CAUTION!
Damage to the fuel system or emission control
system could result from using an improper fuel
tank filler cap (gas cap). A poorly fitting cap could let
impurities into the fuel system.
302 STARTING AND OPERATING

ONBOARD DIAGNOSTIC SYSTEM — OBD II
Your vehicle is equipped with a sophisticated onboard
diagnostic system called OBD II. This system monitors
the performance of the emissions, engine, and automatic
transmission control systems. When these systems are
operating properly, your vehicle will provide excellent
performance and fuel economy, as well as engine emis-
sions well within current government regulations.
If any of these systems require service, the OBD II system
will turn on the “Malfunction Indicator Light.” It will
also store diagnostic codes and other information to
assist your service technician in making repairs. Al-
though your vehicle will usually be drivable and not
need towing, see your dealer for service as soon as
possible.CAUTION!
•Prolonged driving with the “Malfunction Indica-
tor Light” on could cause further damage to the
emission control system. It could also affect fuel
economy and driveability. The vehicle must be
serviced before any emissions tests can be per-
formed.
•If the “Malfunction Indicator Light” is flashing
while the engine is running, severe catalytic con-
verter damage and power loss will soon occur.
Immediate service is required.
Loose Fuel Filler Cap Message
After fuel is added, the vehicle diagnostic system can
determine if the fuel filler cap is loose, improperly
installed, or damaged. A loose fuel filler cap message will
be displayed in the instrument cluster. Tighten the gas
340 MAINTAINING YOUR VEHICLE