2007 CHEVROLET MALIBU display

To delete the entire song list, perform the
following steps:
1. Turn the CD player on.
2. Press the
Rbutton to turn song list on.
S-LIST displays.
3. Press and hold the
Rbutton for more
than four seconds. A beep sounds, followed
by two beeps after two seconds, and a
nal beep sounds after four seconds.
SONG LIST EMPTY displays indicating
that the song list has been deleted.
If a CD is ejected, and the song list contains
saved tracks from that CD, those tracks are
automatically deleted from the song list.
Any tracks saved to the song list again are
added to the bottom of the list.
To end song list mode, press the song list
button. One beep sounds and S-LIST is
removed from the display.
CD Messages
CHECK CD:If this message displays and/or the
CD ejects, it could be for one of the following
reasons:
It is very hot. When the temperature returns
to normal, the CD should play.
You are driving on a very rough road.
When the road becomes smoother,
the CD should play.
The CD is dirty, scratched, wet, or upside down.
The air is very humid. If so, wait about an
hour and try again.
There could have been a problem while
burning the CD.
The label could be caught in the CD player.
If the CD is not playing correctly, for any other
reason, try a known good CD.
If any error occurs repeatedly or if an error cannot
be corrected, contact your dealer/retailer. If the
radio displays an error message, write it down and
provide it to your dealer/retailer when reporting
the problem.
258

XM Radio Messages
Radio Display Message Condition Action Required
XL
(Explicit Language
Channels)XL on the radio display,
after the channel name,
indicates content with
explicit language.These channels, or any others, can be blocked at a
customer’s request, by calling 1-800-852-XMXM (9696).
Updating Updating
encryption codeThe encryption code in the receiver is being updated, and
no action is required. This process should take no longer
than 30 seconds.
No Signal Loss of signal The system is functioning correctly, but the vehicle is in a
location that is blocking the XM™ signal. When the vehicle
is moved into an open area, the signal should return.
Loading XM Acquiring channel audio
(after 4 second delay)The audio system is acquiring and processing audio and
text data. No action is needed. This message should
disappear shortly.
CH Off Air Channel not in service This channel is not currently in service. Tune to another
channel.
CH Unavail Channel no longer
availableThis previously assigned channel is no longer assigned.
Tune to another station. If this station was one of the
presets, choose another station for that preset button.
No Info Artist Name/Feature
not availableNo artist information is available at this time on this channel.
The system is working properly.
259

Radio Display Message Condition Action Required
No Info Song/Program Title
not availableNo song title information is available at this time on this
channel. The system is working properly.
No Info Category Name
not availableNo category information is available at this time on this
channel. The system is working properly.
No Info No Text/Informational
message availableNo text or informational messages are available at this time
on this channel. The system is working properly.
Not Found No channel available for
the chosen categoryThere are no channels available for the selected category.
The system is working properly.
XM Locked Theft lock active The XM™ receiver in your vehicle could have previously
been in another vehicle. For security purposes, XM™
receivers cannot be swapped between vehicles. If this
message is received after having your vehicle serviced,
check with your dealer/retailer.
Radio ID Radio ID label
(channel 0)If tuned to channel 0, this message alternates with the
XM™ Radio eight digit radio ID label. This label is needed
to activate the service.
Unknown Radio ID not known
(should only be if
hardware failure)If this message is received when tuned to channel 0,
there could be a receiver fault. Consult with your
dealer/retailer.
Chk XMRcvr Hardware failure in
the receiver moduleIf this message does not clear within a short period of
time, the receiver could have a fault. Consult with your
dealer/retailer.
260

Rear Seat Entertainment System
Your vehicle may have a DVD Rear Seat
Entertainment (RSE) system. The RSE system
includes a DVD player, a video display screen,
two sets of wireless headphones, and a
remote control.
This system also functions as a rear seat
audio (RSA) system. SeeRear Seat Audio (RSA)
(Without Entertainment System) on page 278
orRear Seat Audio (RSA) (With Entertainment
System) on page 280for more information.
Parental Control
The RSE system may be disabled from the
driver’s seat by pressing the power button on the
radio twice. To resume use of the RSE system
press the RSE power button.
Before You Drive
The RSE is designed for rear seat passengers
only. The driver cannot safely view the video
screen while driving and should not try to do so.The DVD system is designed to be inoperable
when the vehicle is exposed to extremely low or
high temperatures, in order to protect your system
from damage. Operate the DVD system under
normal or comfortable cabin temperature ranges.
Headphones
The RSE system includes two sets of wireless
headphones.
The wireless headphones have an ON/OFF button
and a volume control. To use the headphones
press, the ON/OFF button. An indicator light on
the headphones illuminate. If the light does
not illuminate, the batteries might need to be
replaced. See “Battery Replacement” later in this
section for more information. Press the button
to turn the headphones OFF when not in use.
If the RSE system is shut off or if the headphones
are out of range of the transmitters, located
at the top of the DVD player, for more than
three minutes, the headphones shut off
automatically to save the battery power.
If you move too far forward or step out of the
vehicle, the headphones lose the audio signal.
261

Stereo RCA Jacks
The RCA jacks are located on the DVD faceplate
on the oor console. The RCA jacks allow
audio and video signals to be connected from
an auxiliary device such as a camcorder or a video
game unit to the RSE system. The yellow RCA
jack is used for video inputs, the red RCA jack
for right audio inputs, and the white RCA jack
for left audio inputs. The system requires
standard RCA cables, not included, to connect
the auxiliary device to the RCA jacks. Refer to
the manufacturer’s instructions for proper usage.
To use the auxiliary audio and video inputs,
connect an external auxiliary device such as a
camcorder to the RCA jacks and turn on both
the auxiliary device power and the power on the
front of the RSE system. Press the play and
source buttons at the same time or the AUX button
on the remote control to switch to the auxiliary
device. See “DVD Player” and “Remote Control”
later in this section for more information.
Audio Output
Audio from the DVD player or auxiliary devices
can be heard through the following possible
sources:
Wireless Headphones
Vehicle’s Speakers
Wired Headphones (not included)
Only one audio source can be heard through
the vehicles speakers at a time.
The RSE system or an auxiliary device can
be heard through all of the vehicles speakers
when the following occurs:
The RSE system is off
A DVD or auxiliary device is playing
The front audio system is on and the SRCE
button is pressed to enable the RSE system
The headphone symbol appears on the radio
display when the RSE system is on and the
headphone symbol disappears from the
display when it is off.
263

To turn the vehicles rear speakers on and off,
press the power button on the RSE system or
on the remote control. When the rear speakers
are off, the audio from the RSE system can
be heard through both the wireless headphones
and the vehicles front speakers at the same time.
The RSE system can be heard through the
wired headphones, not included, on the RSE
system when the following occurs:
The RSE system is on
A DVD or auxiliary device is playing
The volume on the radio can vary when
switching between a radio station, CD, DVD,
or auxiliary device.
If there is a decreased audio signal during CD
or DVD play, there can be a low hissing noise
through the speakers and/or headphones.
If the hissing sound in the wireless headphones
seems excessive, make sure that the headphone
batteries are fully charged. Some amount of
hissing is normal.
Video Screen
The video screen is located on the back of the
oor console. Open the video screen by rotating
the screen up and adjust its position as desired.
The video screen may not be able to be moved up
if the rear seat is too far forward. See “Rear Sliding
Seat (MAXX Only)” underRear Seat Operation
on page 17for more information.
When the video screen is not in use, push it down
into its stored position.
The DVD player and display continues to operate
when the video screen is in either the up or
down positions.
The window on the RSE system contains the
transmitter for the wireless headphones and the
remote control. If the screen is in the closed
position, the signals are not available for the
operation of the headphones or the remote control.
Notice:Avoid directly touching the video
screen, as damage may occur. See “Cleaning
the Video Screen” later in this section for
more information.
264

DVD Player
The DVD player is located on the end of the oor
console under the video screen.
The DVD player can be controlled by the buttons
on the RSE system and/or by the buttons on
the remote control. See “Remote Control” later
in this section for more information.
The DVD player is only compatible with DVDs
of the appropriate region code for the country that
the vehicle was sold in. The DVD region code
is printed on the jackets of most DVDs. Video CDs,
standard audio CDs, and audio CD-Rs can be
played by the DVD player. The video screen
displays a menu when an audio CD or CD-R
is playing.
If an error message appears on the video screen,
see “DVD Messages” later in this section.
DVD Player Buttons
O(Power):Press theObutton to turn the
RSE system on and off.
c/Z(Stop/Eject):Press thec/Z(stop)
button to stop playing, rewinding, or fast forwarding.
Press the
c/Z(eject) button again to eject
a DVD or CD.
265

Stopping and Resuming Playback
To stop playing a disc, press and release
the
c/Z(stop) button on the DVD player
faceplate or the remote control.
To resume playback, press the
k(play/pause)
button on the DVD player faceplate or the remote
control. The movie should resume play from
where it was last stopped if the disc has not been
ejected or the stop button has not been pressed
twice on the remote control.
If the disc has been ejected or if the stop button
has been pressed twice on the remote control,
press the
k(play) button once to resume play
at the beginning of the disc. A resume symbol
appears momentarily on the video screen.
When the resume symbol is displayed, press
the
k(play) button again to resume playback
from where the disc last stopped.
Ejecting a Disc
Press thec/Z(eject) button, on the DVD
player or the remote control, to eject the disc.If a disc is ejected from the player, but not
removed, the DVD player reloads the disc after
a short period of time. The disc is stored in
the DVD player. The DVD player does not
resume play of the disc automatically.
Remote Control
To use the remote control, aim it at the transmitter
window on the DVD player and press the desired
button. Direct sunlight or very bright light could
affect the ability of the transmitter to receive signals
from the remote control. If the remote control does
not seem to be working, the batteries might need
to be replaced. See “Battery Replacement” later
in this section. Objects blocking the line of sight
affects the function of the remote control.
Notice:Do not store the remote control in
heat or direct sunlight. This could damage the
remote control and it would not be covered
by your warranty. Keep the remote control
stored in the rear seat armrest when not in use.
If your vehicle is the Malibu MAXX, your vehicle
may have a rear seat storage compartment.
Store the headphones and the remote control in
this compartment when not in use.
267