2007 CHEVROLET KODIAK manual transmission

Keys.............................................................. 86
Remote Keyless Entry (RKE) System.......... 87
Remote Keyless Entry (RKE)
System Operation.................................... 88
Doors and Locks.......................................... 91
Door Locks................................................. 91
Power Door Locks....................................... 92
Windows....................................................... 93
Manual Windows......................................... 93
Power Windows.......................................... 94
Sliding Rear Window................................... 94
Sun Visors.................................................. 95
Starting and Operating Your Vehicle........... 95
New Vehicle Break-In.................................. 95
Ignition Positions......................................... 96
Engine Starter Over-Crank Protection.......... 97
Starting the Gasoline Engine....................... 97
Starting the Diesel Engine......................... 100
Engine Alarm and Automatic Shutdown..... 104
High Idle System....................................... 106
Exhaust Restrictor (Engine Warm-Up)........ 108
Engine Checks Before Operating............... 109
Engine Coolant Heater.............................. 111
Diesel Engine Exhaust Brake.................... 112Two-Speed Rear Axle Electric
Shift Control........................................... 113
Air Shift Control (Automatic
Transmission)......................................... 114
Automatic Transmission Operation............. 115
Manual Transmission Operation................. 116
Power Take-Off (PTO)............................... 118
Four-Wheel Drive...................................... 119
Parking...................................................... 125
Parking Brake (With Hydraulic Brakes)...... 125
Parking Brake (with Air Brakes)................. 126
Parking Brake Burnish Procedure.............. 128
Air Suspension.......................................... 129
Parking Over Things That Burn................. 130
Engine Exhaust......................................... 131
Running the Engine While Parked............. 132
Mirrors......................................................... 133
Manual Rearview Mirror............................. 133
Outside Manual Mirrors............................. 133
Outside Power Mirrors............................... 133
Outside Convex Mirrors............................. 134
Outside Heated Mirrors............................. 134
Storage Areas............................................. 135
Center Console Storage Area.................... 135
Section 2 Features and Controls
85

Sun Visors
To block out glare, you can swing down the
visors. You can also swing them out to block glare
from the side.
Starting and Operating Your
Vehicle
New Vehicle Break-In
Notice:Your vehicle does not need an
elaborate break-in. But it will perform better in
the long run if you follow these guidelines:
Let your engine warm up before you
operate your vehicle under load.
Keep your speed at 55 mph (88 km/h) or
less for the rst 500 miles (805 km).
Do not drive at any one speed, fast or
slow, for the rst 500 miles (805 km).
Do not make full-throttle starts.
Avoid making hard stops for the rst
200 miles (322 km) or so. During this time
your new brake linings are not yet broken
in. Hard stops with new linings can mean
premature wear and earlier replacement.
Follow this breaking-in guideline every time
you get new brake linings.
Use the lowest gear you can when you start
a loaded vehicle in motion and when going
up hills to avoid overloading the engine.
Check and adjust engine and transmission
uid levels often and be sure tires are
properly inated for the load you are
carrying.
If you have a Caterpillar®diesel engine, see
the Caterpillar®Diesel Engine Operation
and Maintenance Manual.
95

Key In the Ignition
Never leave your vehicle with the keys inside, as it
is an easy target for joy riders or thieves. If you
leave the key in the ignition and park your vehicle,
a chime will sound, when you open the driver’s
door. Always remember to remove your key from
the ignition and take it with you. This will lock
your ignition and transaxle. Also, always remember
to lock the doors.
The battery could be drained if you leave the
key in the ignition while your vehicle is parked.
You may not be able to start your vehicle after it has
been parked for an extended period of time.
Engine Starter Over-Crank
Protection
Your vehicle may have an engine starter
over-crank protection system. If the starter motor
overheats and shuts off due to over-cranking,
the motor must cool down before it will reset and
allow starter operation. It can take up to
six minutes before the starter will work again.
Starting the Gasoline Engine
The 8th digit of your Vehicle Identification
Number (VIN) shows the code letter for your
engine. Use this number to verify the type of
engine in your vehicle. SeeVehicle Identication
Number (VIN) on page 340. Follow the proper steps
to start the engine.
To start a diesel engine, seeStarting the Diesel
Engine on page 100.
Automatic Transmission
Set the parking brake and move your shift lever to
NEUTRAL (N) or PARK (P), if so equipped. Your
engine will not start in any other position — that is a
safety feature.
Manual Transmission
Set the parking brake, shift to neutral NEUTRAL (N)
and hold the clutch pedal to the floor while starting
the engine.
97

Starting the Diesel Engine
Your vehicle’s diesel engine starts differently than
a gasoline engine. Read the following pages to
learn how to start, restart, warm-up, and stop your
diesel engine.
The information applies to Caterpillar
®Diesel
Engine, 6.6L DURAMAX®Diesel Engine, Isuzu 6H
Diesel Engine, unless otherwise noted.
If you have a Caterpillar
®Diesel Engine, also refer
to your Caterpillar®Diesel Engine Operation &
Maintenance Manual for the starting procedure.
Automatic Transmission
Move your shift lever to PARK (P) or
NEUTRAL (N). Your engine will not start in
any other position — that is a safety feature.
To restart when you are already moving,
use NEUTRAL (N) only.
Notice:Do not try to shift to PARK (P) if your
vehicle is moving. If you do, you could
damage the transmission. Shift to PARK (P)
only when your vehicle is stopped.
Manual Transmission
Move your shift lever to NEUTRAL and hold the
clutch pedal to the floor while starting the engine.
Your vehicle will not start if the clutch pedal is not all
the way down — that is a safety feature.
Starting Your Engine
1. Turn your ignition key to RUN.
Observe the wait to start light. SeeWait to
Start Indicator on page 174. This light may not
come on if the engine is hot.
If you have a Caterpillar
®diesel engine, see
your Caterpillar®Diesel Engine Operation
& Maintenance Manual for proper wait to start
light operation.
2. As soon as the wait to start light goes off,
immediately turn the ignition key to START.
When the engine starts, let go of the key.
If your vehicle is equipped with a DURAMAX
®
6600 Diesel Engine, it has a fast warm-up
glow plug system. The wait to start light
will illuminate for a much shorter time than
most diesel engines, due to the rapid heating
of the glow plug system.
100

The following tips will help you get good starting in
cold weather.
•Use the recommended engine oil when the
outside temperature drops below freezing.
SeeEngine Oil (Caterpillar
®Diesel Engine) on
page 268orEngine Oil (Gasoline Engine)
on page 268orEngine Oil (DURAMAX
®/Isuzu
Diesel Engine) on page 272. When the
outside temperature drops below 0°F (−18°C),
use of the optional engine coolant block
heater is recommended.
•If you experience longer cranking times, notice
an unusual amount of exhaust smoke or are
at higher altitudes (over 7,000 ft. or 2 135 m),
you may use your optional engine coolant
block heater. SeeEngine Coolant Heater on
page 111.
•SeeWhat Fuel to Use on page 253for
information on what fuel to use in cold
weather.
Cold Weather Starting
(Caterpillar®Diesel)
Because the diesel engine uses compression
ignition, it is harder to start in cold weather than a
gasoline engine. The air intake heater and use
of the proper engine oil, optional engine coolant
heaters and optional ether injection systems
help cold weather starting. See the Caterpillar
®
Diesel Engine Operation & Maintenance Manual
for more information.
Restarting the Diesel Engine While
Moving (Automatic Transmission)
If you have to restart the engine while the vehicle
is moving, you will first have to shift to
NEUTRAL (N). This safety feature prevents
starting the engine when the transmission is in a
drive gear for more information.
102

Stopping the Diesel Engine
1. Set the parking brake and shift to
NEUTRAL (N) or PARK (P).
2. Turn the ignition key to OFF.
If your vehicle has a two-speed axle, see
Two-Speed Rear Axle Electric Shift Control on
page 113.
If you have a Caterpillar
®diesel engine, see your
Caterpillar®Diesel Engine Operation &
Maintenance Manual for additional information.
Diesel Engine Warm-Up
Several factors affect how quickly your diesel
engine warms up. These can include outside
temperature, engine load, idle time and your
vehicle’s option content. Your vehicle may be
equipped with some features that can help
the engine reach operating temperature sooner.
Some of these features are discussed below.Also, remember that an automatic transmission
adds heat to the cooling system through the heat
exchanger in the radiator. Because of this,
vehicles equipped with automatic transmissions
are often able to retain engine coolant heat better
than manual transmission vehicles.
See your Caterpillar
®Operation & Maintenance
manual for additional diesel engine warm-up
information.
If Your Diesel Engine Will Not Start
If you have run out of fuel, seeRunning Out of
Fuel on page 262.
If you are not out of fuel, and your engine will not
start, do this:
Turn your ignition key to RUN. Immediately after
the wait to start light goes off, turn the ignition key
to START.
If the light does not go off, wait a few seconds, then
try starting your engine again. And, see your dealer
as soon as you can for a starting system check.
If the light comes on and then goes off and you
know your batteries are charged, but your engine
still will not start, your vehicle needs service.
103

High Idle System
High Idle System with Switch
If your vehicle has this
feature, the manual high
idle switch is located
in the instrument panel
switchbank.
This system can be used to increase your engine
idle speed whenever the following conditions
are met:
•The brake pedal is not pressed.
•The vehicle speed is below about 5 mph
(8 km/h) for vehicles with diesel engines. The
vehicle must not be moving and the
accelerator must not be pressed for vehicles
with gasoline engines.
•If the vehicle has manual transmission the
clutch pedal is not pressed or, if the vehicle
has the automatic transmission it is in
NEUTRAL (N) or PARK (P).
The manual high idle feature is activated by
pressing the switch on the instrument panel. When
the switch is pressed again, or any of the
previous conditions are not met, manual high idle
will be deactivated.
The manual high idle has been preset at the
factory. Your dealer may change the setting to fit
your needs.
For vehicles with Caterpillar
®diesel engines, the
high idle switch can be used to set any desired
high idle speed.
106

To set a new temporary engine idle speed do the
following:
1. Make sure all of the previously described
conditions are met.
2. Press the accelerator pedal to the desired
engine speed.
3. Momentarily press the manual high idle
switch.
The temporary high idle speed will be set. This
new high idle rpm level will be remembered by the
system until either the ignition is turned to OFF
or a new high idle speed is set.
Automatic High Idle System
The automatic high idle feature will engage
whenever you start your vehicle and the engine is
below the preset operating temperature. This
will help decrease engine warm-up time.On vehicles that have the Caterpillar
®diesel
engine you may have an exhaust restrictor that
will operate in High Idle mode. The exhaust brake
switch must be on for this feature to operate.
SeeDiesel Engine Exhaust Brake on page 112for
more information.
Idle speed will then return to normal under any of
the following conditions:
•The engine reaches the preset operating
temperature or has been operating for at least
10 minutes.
•The brake pedal is pressed.
•The manual transmission clutch pedal is
pressed or, if the vehicle has automatic
transmission, it is shifted from NEUTRAL (N)
or PARK (P).
•The vehicle speed exceeds about 5 mph
(8 km/h).
•The throttle is pressed.
107