Page 284 of 430

Engine Coolant (Gas and
DURAMAX
®/Isuzu Engines)
The cooling system in your vehicle is filled with
DEX-COOL®engine coolant. This coolant is
designed to remain in your vehicle for five years or
150,000 miles (240 000 km), whichever occurs
first, if you add only DEX-COOL
®extended
life coolant.
The following explains your cooling system and
how to add coolant when it is low. If you have
a problem with engine overheating, seeEngine
Overheating on page 288.A 50/50 mixture of clean, drinkable water and
DEX-COOL
®coolant will:
•Give freezing protection down to
−34°F (−37°C).
•Give boiling protection up to 265°F (129°C).
•Protect against rust and corrosion.
•Help keep the proper engine temperature.
•Let the warning lights and gages work as
they should.
Notice:Using coolant other than
DEX-COOL
®may cause premature engine,
heater core or radiator corrosion. In addition,
the engine coolant may require changing
sooner, at 30,000 miles (50 000 km) or
24 months, whichever occurs rst. Any
repairs would not be covered by your
warranty. Always use DEX-COOL
®
(silicate-free) coolant in your vehicle.
284
Page 295 of 430

Power Steering Fluid
SeeScheduled Maintenance on page 363to
determine when to check your power steering fluid.
How To Check Power Steering Fluid
Check your power steering fluid only when the
engine is warm. If the engine is not warm, you
probably will not get an accurate reading.
If the fluid level is between the MIN (Minimum) and
MAX (Maximum) marks, you have enough. If you
need fluid, add only enough of the proper fluid to
bring it in between the MIN and MAX marks.
If your power steering fluid level is low, this can
cause the brake or service brakes soon warning
lights to come on. In addition, the steering
effort and emergency brake distance could
increase.If either light remains on after you have added
power steering fluid to the proper level, then shut
off the engine for 10 seconds. This should
reset the brake warning lights. If one or both lights
stay on, see “Hydraulic Brake System Warning
Lights” underBrake System Warning Light
on page 169for more information.
What to Use
To determine what kind of fluid to use, see
Part C: Recommended Fluids and Lubricants on
page 397.
Notice:When adding power steering uid or
making a complete uid change, always
use the proper uid. Failure to use the proper
uid can cause leaks and damage hoses
and seals.
295
Page 341 of 430

Headlamp Wiring
The headlamp wiring is protected by a circuit
breaker in the light switch. An electrical overload
will cause the lights to go on and off, or in
some cases to remain off. If this happens, have
your headlamp wiring checked right away.
Windshield Wiper Fuses
The windshield wiper motor is protected by a
circuit breaker inside the motor and a circuit
breaker or fuse in the fuse block. If the motor
overheats, the wipers will stop until the motor
cools. If the overload is caused by an electrical
problem, be sure to get it fixed.
Fusible Links
A fusible link is a short piece of wire several gauge
sizes smaller than the circuit it protects. It will melt
in an overload situation, opening the circuit.
Your starter and other circuits have these fusible
links. The size is printed on the insulation. If the
insulation is burned beyond recognition, consult
your dealer for the proper size. Replace a fusiblelink with one of the same size and insulation type.
Fusible link insulation is a special purpose
high-temperature material.
Some examples of circuits with fusible links are
the hydraulic brake booster motor feed circuit, the
generator output circuit, and the intake heater
feed circuit in vehicles with a diesel engine.
Power Windows and Other
Power Options
Circuit breakers in the fuse panel protect the power
windows and other power accessories. When the
current load is too heavy, the circuit breaker opens.
This protects the circuit until the current load returns
to normal or the problem is fixed.
Fuses and Circuit Breakers
The wiring circuits in your vehicle are protected
from short circuits by a combination of fuses, circuit
breakers, maxi-fuses and fusible links. This greatly
reduces the chance of a fire caused by an electrical
problem. There may be a fuse taped to the wiring
harness near the hydraulic brake booster.
341
Page 343 of 430
Fuse Usage
7 Hazard Warning Flashers
8 Power Post
9 Courtesy Lamps
10 Warning Lights, Gages and Indicators
11 Starter
12 Rear Axle/Four-Wheel-Drive
13Trailer Turn Signals/Hazard Warning
Flashers
14 Radio/Chime
15 Daytime Running Lamps
16 Airbag System
17 Exterior/Interior Lamps
18 Parking Brake
19 Accessory Power
20 Ignition 4
21 Sidemarker Lamps
22 Turn Signal/Backup Lamps
23 TransmissionFuse Usage
24 Hydraulics/Air Brake
A Spare
B Spare
Fuse Usage
Blank Not Used
BRK Brake Warning Lamp
RT PRK Passenger’s Side Parking Lamps
Blank Not Used
Blank Not Used
LT PARK Driver’s Side Parking Lamps
RT REAR
TRN/STOPPassenger’s Side Rear Turn
Signal/Stoplamp
LT REAR
TRN/STOPDriver’s Side Rear Turn
Signal/Stoplamp
RADIO Radio
Blank Not Used
Blank Not Used
PWR WNDW Power Windows
343
Page 395 of 430

Lamps Check
Check panel lighting, warning lights, indicator
lights, and interior lamps. On the outside,
check: license plate lamps, sidemarker lamps,
reflectors or lights on outside mirrors, headlamps,
parking lamps, identification and clearance
lamps, taillamps, brake lamps, turn signals,
backup lamps, and hazard warning flashers.
Have headlamp aim checked at once if beams
seem improperly aimed.
Glass, Mirrors, Lamps and/or
Re ectors Condition Check
Look for broken, scratched, dirty, or damaged
glass, mirrors, lamps, or reflectors that could
reduce the view or visibility or cause injury.
Replace, clean or repair promptly.
Door Latches Check
Check that doors close, latch, and lock tightly.
Check for broken, damaged, or missing parts that
might prevent tight latching.
Hood Latches Check
Check that the hood closes firmly. Check for
broken, damaged, loose, or missing parts
that might prevent tight latching. Make sure the
secondary latch (if equipped) keeps the hood
from opening all the way when the primary latch
is released.
Fluid Leaks Check
Check for fuel, coolant, oil, or other fluid leaks by
looking at the surface beneath the vehicle after
it has been parked for awhile.
395
Page 430 of 430

W
Wait to Start Indicator................................. 174
Warning Lights, Gages and Indicators......... 161
Warnings
Hazard Warning Flashers......................... 142
Other Warning Devices............................ 142
Safety and Symbols..................................... 4
Vehicle Damage.......................................... 5
Washer Fluid, Low Warning Light................ 180
Water
Fuel......................................................... 256
Water in Fuel Warning Light........................ 182
What Fuel to Use........................................ 253
Wheels
Alignment and Tire Balance..................... 324
Front Bearings with Oil-Filled Hubs.......... 319
Loading.................................................... 323
Replacement............................................ 328
Tightening the Wheel Nuts....................... 325Where to Put the Restraint..................... 54, 55
Windows....................................................... 93
Manual...................................................... 93
Power........................................................ 94
Sliding Rear............................................... 94
Windshield
Washer.................................................... 146
Washer Fluid........................................... 296
Wiper Blade Replacement........................ 316
Wiper Blades, Cleaning............................ 336
Wiper Fuses............................................ 341
Wipers..................................................... 145
Winter Driving............................................. 231
Y
Your Vehicle and the Environment............... 360
430
Page:
< prev 1-8 9-16 17-24