2007 CHEVROLET CORVETTE tow

Installing the Roof Panel
{CAUTION:
An improperly attached roof panel may
fall into or y off the vehicle. You or
others could be injured. After installing
the roof panel, always check that it is
rmly attached by pushing up on the
underside of the panel. Check now and
then to be sure the roof panel is rmly
in place.
Notice:If you drop or rest a roof panel
on its edges, the roof panel, paint and/or
weatherstripping may be damaged. Always
place the roof panel in the stowage receivers
after removing it from the vehicle.In most cases, it makes it easier if two people
re-install the roof panel.
1. Park on a level surface and set the parking
brake. Shift an automatic transmission into
PARK (P). Shift a manual transmission
into NEUTRAL.
2. Check that the front release latches and
the rear release latch on the vehicle’s roof
opening are in their opened positions before
attempting to install the roof panel.
3. If the roof panel is stored in the rear storage
area of the vehicle, grasp the rear edge of the
roof panel with both hands and gently lift it
up and remove it from the storage area.
4. Carefully place the roof panel over the top of
the vehicle.
5. Position the rear edge of the roof panel to the
weatherstrip on the back of the roof opening.
Then align and t the pins at the rear of the roof
panel inside the openings in the rear overhead
weatherstrip. Gently lower the front edge of the
roof panel to the front of the roof opening.
138

Notice:If you lower the top on your vehicle
in cold weather (0°F/-18°C or lower), you
may damage top components. Do not lower
the top in cold weather.
Notice:If you raise or lower the convertible
top while the vehicle is in motion, you could
damage the top or the top mechanism. The
repairs would not be covered by your warranty.
Always put an automatic transmission in
PARK (P) or a manual transmission in
NEUTRAL before raising or lowering the
convertible top.
Lowering the Power Convertible Top
1. Park on a level surface. The vehicle must
be running or in Acc. Shift an automatic
transmission into PARK (P) and set the
parking brake. Shift a manual transmission
into NEUTRAL, and set the parking brake.
2. Make sure the trunk is closed and the rear
trunk partition in the rear storage area is
in the fastened upright position, and that
no objects are forward of the divider.
See “Rear Trunk Partition” underRear
Storage Area on page 131.3. Release the convertible top front latch,
located above the inside rearview mirror,
by pulling and turning it clockwise toward
the driver’s door. Push upward on the front
edge. The windows will automatically lower.
147

4. After the convertible top is completely raised,
release the power convertible top button.
5. Pull the convertible front top latch down
and turn it counterclockwise to lock the
convertible top.
If the radio is on the sound may be muted for a
brief time due to a new audio system equalization
being loaded.If the vehicle has lost power, the convertible top can
still be raised by releasing pressure on the hydraulic
pump, located under the passenger’s side of the
tonneau cover, by using the following steps. The
carpet liner on the passenger’s side must be pulled
back to access the hydraulic pump.
Manual operation of the power convertible top
cannot be attempted for ve minutes from the last
time the convertible top button was pressed if the
top is not completely stowed, with the top down and
the tonneau latched, or closed, with the front top
latch locked in place, at the time the convertible
top button was released.
149

Other Warning Devices
If you carry reective triangles, you can set them
up at the side of the road about 300 feet (100 m)
behind your vehicle.
Horn
Press near or on the horn symbols on the steering
wheel pad to sound the horn.
Tilt Wheel
A tilt wheel allows you to adjust the steering wheel
before you drive. You can raise it to the highest
level to give your legs more room when you
exit and enter the vehicle.
The lever that allows you to tilt the steering wheel
is located on the left side of the steering column.To tilt the wheel, hold the steering wheel and pull
the lever toward you. Then move the wheel to
a comfortable position and release the lever to lock
the wheel in place.
159

Telescopic Steering Column
If your vehicle has this feature, the telescopic
steering column will allow you to adjust the
distance the steering wheel is from the
instrument panel.
The telescopic steering
column switch is located
on the right side of
the steering column.
To operate the telescopic steering column, push
the switch forward and the wheel will move
away from you. Pull the switch rearward and the
wheel will move toward you
The telescopic steering column position can be
stored with your memory settings. SeeMemory
Seat, Mirrors and Steering Wheel on page 10
for more information.
Turn Signal/Multifunction Lever
The lever on the left side of the steering column
includes the following:
GTurn and Lane-Change Signals.
SeeTurn and Lane-Change Signals
(Auto Signal) on page 161.
3Headlamp High/Low-Beam Changer.
SeeHeadlamp High/Low-Beam Changer
on page 162.
-Fog Lamps. SeeFog Lamps on page 171.
Flash-to-Pass Feature. SeeFlash-to-Pass
on page 162.
160

Headlamp High/Low-Beam Changer
To change the headlamps from low beam to
high, push the turn signal lever all the way forward.
To change from high to low beam, pull the lever
rearward.
While the high beams
are on, this light on
the instrument panel
cluster will also be lit.
Flash-to-Pass
To use the ash-to-pass feature, briey pull the
turn signal lever toward you. The high-beam
indicator ashes to indicate to the other driver that
you intend to pass. If the low-beam headlamps
are off and the fog lamps are on, the fog
lamps ash.
Windshield Wipers
Use the lever located on the right side of the
steering column to operate the windshield wipers.
1(High Speed):Move the lever to this
position for steady wiping at high speed.
6(Low Speed):Move the lever to this
position for steady wiping at low speed.
&(Delay):Move the lever to this position to
set a delay between wipes.
162

Head-Up Display (HUD)
{CAUTION:
If the HUD image is too bright, or too
high in your eld of view, it may take you
more time to see things you need to see
when it is dark outside. Be sure to keep
the HUD image dim and placed low in your
eld of view.
If your vehicle has the Head-Up Display (HUD), you
can see some of the driver information that appears
on the instrument panel cluster.
The information may be displayed in English or
metric units and appears as an image focused out
toward the front of your vehicle. The HUD consists
of the following information:
Speedometer
Turn Signal Indicators
High-Beam Indicator Symbol
Tachometer
Manual Paddle Shift Gear Indicator
(If Equipped)
These displays on the HUD are for use when
using the manual paddle shift controls to shift
the transmission. See “Manual Paddle Shift” in
Automatic Transmission Operation on page 95.
Shift Light
This light is used for performance driving to
indicate that the vehicle’s best performance
level has been reached to shift the transmission
into the next higher gear. An arrow pointing up
will light up on the display just prior to reaching
the engine fuel cut-off mode. This cut-off is
about 6,500 RPM for the LS2 engine and
7,000 RPM for the LS7 engine.
Check Gages Warning
Engine Coolant Temperature Gage
Transmission Fluid Temperature Gage,
(Automatic Transmission Vehicles Only)
Engine Oil Temperature Gage
Engine Oil Pressure Gage
G-Force Gage
Audio Functions, Street Mode Only
Navigation, Only with Navigation Radio,
Turn-by-Turn Guidance
174

Manual Operation
Driver Power/Temperature:Press the driver
temperature knob on the driver side of the climate
control panel to turn the climate control system
off. This is the only setting that completely shuts off
the fan. The digital display will show only the
outside temperature. You can still adjust the driver
and the passenger set temperature and the air
intake mode when the climate control is off.
Passenger Power/Temperature:Press the
passenger temperature knob on the passenger
side of the climate control panel to turn the
passenger’s climate control system on or off. Turn
the knob to increase or decrease the temperature
for the passenger. If the passenger’s climate
control system is off, the driver’s temperature knob
will control the temperature for the entire vehicle.
N(MODE):Press this button to manually
lock in the current air delivery setting and to
stop the automatic mode control. Pressing the
MODE button will delete AUTO from the digital
display and the mode graphics will be shown.
To change the setting, press the MODE button
again. The AUTO button must be pressed to
return to the automatic mode selection.To change the current mode, select one of the
following:
H(Vent):This mode directs most of the air to
the instrument panel outlets, with a very small
amount of air directed to the oor outlets.
%(Bi-Level):This mode directs about half of the
air to the instrument panel outlets, and directs
the remaining air to the oor outlets. Cooler air is
directed to the upper outlets and warmer air to
the oor outlets.
6(Floor):This mode directs most of the air to
the oor outlets with some air directed to the
side window defogger outlets and some air
directed toward the windshield.
The MODE button can also be used to select
the defog mode. Information on defogging
and defrosting can be found later in this section.
x9w(Fan):Press the button with the fan
symbol to manually increase or decrease the
fan speed. Keep pressing the up or down arrow
on this switch until the desired fan speed appears
on the display.
181