2007 Alfa Romeo 156 mirror

GETTING TO KNOW YOUR CAR25
STEERING WHEEL
ADJUSTMENTThe steering wheel position is adjustable
and may be move nearer to or further away
from the driver and also raised or lowered.
To do this, it is necessary to release lever
(A-fig. 32) and pull it towards the steer-
ing wheel.
After setting the steering wheel in the most
appropriate position, lock it pushing the lever
fully home.
ADJUSTING THE
REAR-VIEW MIRRORSINTERNAL REAR-VIEW
MIRRORThe mirror, fitted with a safety device
which releases it in the event of a violent
impact can be moved to two positions: nor-
mal or anti-glare by operating lever (A-
fig. 33).
fig. 32
A0B0035m
fig. 33
A0B0595m
The steering wheel position
must only be adjusted with
the car stationary.
WARNING
It is absolutely forbidden to
carry out whatever after-
market operation involving steering
system or steering column modifi-
cations (e.g.: installation of anti-
theft Device) that could badly affect
performance and safety, cause the
lapse of warranty and also result in
non-compliance of the car with ho-
mologation requirements.
WARNING

GETTING TO KNOW YOUR CAR26
Folding (fig. 35)
– If necessary (for example when the size
of the mirror causes difficulty in narrow
spaces) the door mirror can be folded in to-
wards the car from position (A) to position
(B).Defrosting/demisting (fig. 36)
The electric mirrors can be fitted with heat-
ing coils which are operated together with
rearscreen heating pressing button (A) and
prevent the mirrors from frosting and/or
misting.
WARNINGThis function is timed and
is deactivated after a few minutes.
fig. 36
A0B0399m
fig. 35
A0B0370m
When travelling the door
mirrors must always be in
position (A).
WARNING
As the driver’s door mirror
is curved, it may slightly
alter the perception of distance.
WARNING
DOOR MIRRORSElectrically adjustable (fig. 34)
Select the mirror to be adjusted (right or
left) using switch (A):
– move switch (A) to (B) to adjust the
left door mirror;
– move switch (A) to (D) to adjust the
right door mirror.
Then, reposition the switch (A) in the in-
termediate locking position (C).
WARNINGThe mirror can only be ad-
justed electrically when the ignition key is
in the MARposition.fig. 34
A0B0018m

GETTING TO KNOW YOUR CAR52
When the rain sensor is reactivated, the
wiper performs at least one stroke, even if
the windscreen is dry, to indicate that reac-
tivation has occurred.
WARNINGIn case of failure of the right-
hand stroke or rain sensor, windscreen wiper
operation with the right-hand lever at (B)
shall take place in intermittent mode.
The rain sensor is located behind the inner
rear-view mirror in contact with the wind-
screen and inside the area cleaned by the
wiper and it controls an electronic control
unit which in turns controls the wiper motor.At each start, the rain sensor automatically
stabilises at a temperature of about 40°C
to eliminate any condensation from the con-
trol surface and prevent the formation of ice.
The rain sensor is able to detect and au-
tomatically adapt to the presence of the fol-
lowing particular conditions which require
different sensitivity:
– impurities on the control surface (salt,
dirt, etc.);
– streaks of water caused by worn wiper
blades;
– difference between day and night (the
human eye is more disturbed during the
night by the wet glass surface).Headlight washers (fig. 78)
(optional for versions/markets
where applicable)
These are operated when the sidelights
are on and the windscreen washer is
switched on.
fig. 78
A0B0581m

GETTING TO KNOW YOUR CAR
110
REAR SWIVEL OUTLET
ADJUSTMENTFig. 98: front seats (on dashboard ends)
Fig. 99: rear seat (on the console be-
tween seats)
MANUAL CLIMATE
CONTROL SYSTEM (fig. 99a - where applicable)CONTROLS1 Air temperature adjustment knob (mix-
ing warm / cold air)
2Climate control compressor on / off but-
ton
3Inside air re-circulation on / off button
4Fan knob
5Maximum defrosting / demisting on /
off button for windscreen and front side win-
dows and wing mirror coils
6Rearscreen heating and wing mirror de-
frosting on / off button.
7Air distribution knob.
fig. 98
A0B0038m
fig. 99
A0B0289m
Air flow can be adjusted by means of vanes
(A) with press-on opening and closing.
Air flow can be directed by rotating the out-
let by means of the vanes.

GETTING TO KNOW YOUR CAR
112
Preventive demisting procedure
In cases of heavy damp and/or rain
and/or big differences in temperature be-
tween inside the car and outside, it is ad-
visable to proceed as follows to demist the
windows:
– turn off inside air re-circulation (if on)
– turn knob (1) as far as it will go clock-
wise
– turn knob (4) clockwise to an inter-
mediate speed
– turn knob (7) to
Q
or
ZQ
if the win-
dows do not mist up.
Climate control system is very useful to
speed up demisting. Set controls to demist-
ing function as described previously and
switch the climate control system on by
pressing button (2)
√
REARSCREEN AND WING
MIRROR (where applicable)
DEMISTING / DEFROSTINGPress button (6)
(
) to demist /defrost
the rearscreen and wing mirrors (where ap-
plicable).
When this function is on the relevant but-
ton led will come on.
To turn this function off, press the button
again, the button led will go off.
WARNINGDo not apply stickers on the
inside of the rearscreen over the heating fil-
aments to avoid damaging it.
FAN SPEED ADJUSTMENTTo ventilate the passenger's compartment
properly, proceed as follows:
– open completely the central and side
vents;
– turn knob (4) to the required speed;
– turn knob (7) to
E;
– - turn off inside air re-circulation (if on).

GETTING TO KNOW YOUR CAR
115
For more detailed information on the sys-
tem and how to make the best use of it,
read the instructions given in the following
pages.The coolant used for the
climate control system is
R134a which meets cur-
rent regulations and does not harm
the environment in the event of ac-
cidental spillage.
Absolutely avoid the use of other
fluids which are incompatible with
the system components.fig. 100
A0B0382m
GENERALThe car is equipped with a two-zone cli-
mate control system, controlled by an elec-
tronic control unit which makes it possible
to separately adjust the air temperature on
the driver’s side and on the passenger’s side.
To obtain optimum temperature control in
the two areas of the passenger compart-
ment, the system has an outside sensor, a
passenger compartment sensor and a two-
zone sun ray sensor.
On some versions, the system is integrated
with an incipient misting sensor installed be-
hind the internal rearview mirror, which is
able to “monitor” a predefined area of the
windscreen inner surface which can auto-
matically act on the system to prevent or re-
duce misting, through a series of operations
such as: opening air recirculation, enabling
compressor, air flow to the windscreen, fan
speed sufficient for demisting; and, in case
of heavy misting, enabling the
MAX
-DEF
function.
The climate control com-
pressor cannot work when
the outside temperature is less
than 2°C. Therefore, it is recom-
mended that the internal air recir-
culation function
v
is not used
when the outside temperature is
low, as the windows could mist
over rapidly.
WARNING

GETTING TO KNOW YOUR CAR
118
CONTROLS
(fig. 101)
1- Inside temperature adjustment knob
(driver’s side)
2- Inside temperature set display (driver’s
side)
3- Knob for adjusting the fan speed and
switching the system off
4- Fan speed set, air distribution and sys-
tem off display (OFF
)
5- Inside temperature set display (pas-
senger’s side)
6- Inside temperature adjustment knob
(passenger’s side)
7- Inside air recirculation on/off button
v
(manual/automatic)
8- Air distribution selection button
9- Rearscreen heating and wing mirror de-
frosting on/off button
(
10- Maximum defrosting/demisting
on/off button for windscreen and front side
windows, rearscreen heating and wing mir-
ror coils (function
MAX
-DEF
- -
)
11- Button for aligning the temperature
set on the passenger’s side with that on the
driver’s side
MONO
12- Climate control compressor on/off
enable button
√
13- Inside air temperature sensor
14- Button for selecting the system au-
tomatic mode
AUTO
fig. 101
A0B0056m

GETTING TO KNOW YOUR CAR
132
fig. 113
A0B0074m
QUICK FRONT WINDOW
DEMISTING/DEFROSTING
BUTTON
(-
MAX
-DEF
function)
(fig. 113)
Pressing button (10)
-
the climate con-
trol automatically activates timed operation
of all the functions needed to quicken
demisting/defrosting of the windscreen and
front side windows, i.e.:
– it turns on the climate control compres-
sor;
– switches off inside air recirculation, if on
(both leds off);
– sets the maximum air temperature (HI)
on both displays (2) and (5);
– operates the fan at a predefined speed;
– directs the flow of air towards the wind-
screen and front side window vents;
– turns on rearscreen heating and, if pre-
sent, the wing mirror coils.
When the maximum demisting/defrost-
ing function is on, the led on button (10)
-
, the led on the rearscreen heating but-
ton (9)
(
and the led on button (12)
√
come on; at the same time the leds on
button (7)
v
go out.WARNINGIf the engine is not warm
enough, the function will not engage the
predefined fan speed immediately, to limit
the flow to the passenger compartment of
air that is not warm enough to demist the
windows.