2007 Acura TL change time

ÝÝ
Select the desired relock time by
moving the pointer with the INFO
( ) button and enter your selection
by pressing the SEL/RESET button. The headlights, parking lights, side
marker lights, taillights, and license
plate lights go of f af ter the selected
time when you close the driver’s
door.
You can change how long the lights
stay on bef ore they go of f as
described next.
Select the desired time (‘‘0s, 15s, 30s
or 60s’’) by moving the pointer with
the INFO ( ) button and enter your
selection by pressing the SEL/
RESET button.
Headlight Auto Of f Timer
Multi-Inf ormation Display
82
——
y

y
(%yy

ÝÝ
ÛÝ
Ý
Interior Light Dimming Time Default All
The interior lights fade out when you
close all doors (see page ). Select
how long it takes f or the interior
lights to f ade out (in seconds) f rom
‘‘5s, 15s, or 30s’’ by moving the
pointer with the INFO ( ) button. If you want the settings as they were
when the vehicle lef t the f actory,
display the menu shown above.
Select ‘‘DEFAULT ALL’’ by moving
the pointer with the INFO ( )
button and enter your selection by
pressing the SEL/RESET button.
Enter your selection by pressing the
SEL/RESET button. If you select ‘‘DEFAULT ALL,’’ the
display changes as shown. Press the
INFO ( / ) button to cancel
‘‘DEFAULT ALL,’’ or press the SEL/
RESET button to conf irm your
selection is ‘‘DEFAULT ALL.’’
To exit ‘‘DEFAULT ALL’’ without
changing the current settings, select
‘‘EXIT’’ by moving the pointer with
the INFO ( ) button and enter your selection by pressing the SEL/
RESET button.
118
Multi-Inf ormation Display
Inst rument s and Cont rols
83
——
y
y
(%yy

Tochangethe "HEA DLIGHTAUTO
OFFTIMER" setting,seepage 82.
The automatic lighting of f f eature
turns off the headlights, all other
exterior lights, and the instrument
panel lights within 15 seconds of
removing the key from the ignition
switch and closing the driver’s door.
The automatic lighting of f f eature
activates if you leave the headlight
switch in the ‘‘ ’’ or ‘‘ ’’
position or if the lights are turned on
by setting the switch in the ‘‘AUTO’’
position, remove the key, then open
and close the driver’s door. If you remove the key f rom the
ignition switch with the headlight
switch on, but do not open the door
and get out, the lights turn off after
10 minutes.
The lights turn on again when you
unlock or open the driver’s door.
If you unlock the door, but do not
open it within 15 seconds, the lights
go of f . With the driver’s door open,
you will hear a lights-on reminder
chime.
With the headlight switch off, the
daytime running lights come on
when you turn the ignition switch to
the ON (II) position and release the
parkingbrake.Theyremainonuntil
you turn the ignition of f , even if you
set the parking brake.
Automatic Lighting Of f Feature
Daytime Running Lights
Turn Signals and Headlights
88
——
y
y
(%yy

µ
µ µ
µ
If you unlock the doors with the
remote transmitter, but do not open
anydoorswithin30seconds,the
doors automatically relock and the
security system sets. To change this
setting, refer to Keyless Memory
Settings on page . Press this button once
to unlock the driver’s door or all the
doors (depending on the keyless
memory setting). Press it twice to
unlock the other doors. Some
exterior lights will f lash twice each
time you press the button.
The ceiling light (if the ceiling light
switch is in the center position) will
come on when you press the
UNLOCK button. If you do not open
anydoorswithin30seconds(or
whatever setting the relock timer is
set to), the light f ades out. If you
relock the doors with the remote
transmitter before 30 seconds have
elapsed, the light will go of f
immediately.
Press this button once to
lock all doors. Some exterior lights
will f lash. When you push LOCK
twice within 5 seconds (depending
on the keyless memory setting), you
will hear a beep to verify that the
doors are locked and the security
system has set. You cannot lock the
doors if any door is not f ully closed
or if the key is in the ignition switch. Pressthisbuttonfor
about 1 second to open the trunk.
Pressthisbuttonfor
about 2 seconds to attract attention:
the horn will sound, and the exterior
lights will f lash f or about 30 seconds.
To cancel panic mode, press any
other button on the remote
transmitter, or turn the ignition
switch to the ON (II) position.
81
UNL OCK
LOCK TRUNK
PA NIC
Remote Transmitter
Inst rument s and Cont rols
99
LOCK
BUTTON
UNLOCK
BUTTON
PANIC
BUTTON
TRUNK
BUTTON
——
y

y
(%y
y

Change the hour by pressing and
holding the H button until the
numbers advance to the desired time.
Change the minutes by pressing and
holding the M button until the
numbers advance to the desired time.
You can quickly set the time to the
nearest hour. If the displayed time is
before the half hour, press the R
button to set the clock back to the
previous hour. If the displayed time
is after the half hour, the clock sets
forward to the beginning of the next
hour.
For example: 1:06 will reset to 1:00
1:52 will reset to 2:00
The clock is set automatically.
The
clock displays the time with the
ignition switch in the ON (II)
position. If your vehicl e’s battery is
disconnected or goes dead, you will
need to reset the clock.
The
moonroof has a key-off delay.
You can still open and close the
moonroof for up to 10 minutes after
you turn off the ignition switch. The
key-off delay cancels as soon as you
open either front door. You must
then turn the ignition switch to the
ON (II) position f or the moonroof to
operate.
You can use the remote transmitter
or the key to operate the moonroof
f rom the outside. Ref er to page f or details.
114
On models without navigation system
On models with navigation system
Clock
Operating the Moonroof with the
Remote Transmitter or the Key
Moonroof , Clock
116
If you try to open the moonroof in
below-f reezing temperatures, or when
it is covered with snow or ice, you can
damage the moonroof panel or its
motor.
——
y

y
(%y

y

µµÓÓµ
µ´
To listen to XM radio, turn the
ignition switch to the ACCESSORY
(I) or the ON (II) position. Push the
power/volume knob to turn on the
audio system, and press the ‘‘XM’’
button. Adjust the volume by turning
the knob. The last channel you
listened to will show in the display. To switch between
channel mode and category mode,
press and hold the DISP/MODE
button until the mode changes.
Each time you press and release the
DISP/MODE button, the display
changes in the f ollowing sequence:
channel name, channel number,
category, artist name, and music title. In the channel mode, you can select
all of the available channels. In the
category mode, such as Jazz, Rock,
Classical, etc., you can select all of
the channels within that category. You may experience periods when
XM Radio does not transmit the
artist’s name and song title
inf ormation. If this happens, there is
nothing wrong with your system.
Turn the TUNE knob lef t
or right to select channels. In the
category mode, you can only select
channels within that category.
In any
mode, press either button to select
another category.
Operating the XM Radio
MODE
TUNE
CATEGORY ( or )
Audio System (Models without Navigation System)
140
——
y
y
(%y
y

´µ
µ ´
µ
¼
Each time you press the DISP button,
the display shows you the text data
on a disc, if the disc was recorded
with text data.
You can see the album, artist, and
track name in the display. If a disc is
recorded in MP3 or WMA, you can
see the f older and f ile name, and the
album, artist, and track tag.
The display shows up to about 16
characters of selected text data (the
foldername,filename,etc.).If the
text data has more than 16
characters, you will see the first 15
characters and the indicator in
the display. Press and hold the DISP
button until the next 16 characters
are shown. You will also see some text data
under these conditions:
When a new f older, f ile, or track is
selected.
When you change the audio mode
to play a disc with text data or in
MP3 or WMA.
When you insert a disc, and the
system begins to play. Use the SEEK or SEEK button
while a disc is playing to select
passages and change tracks (f iles in
MP3/WMA mode).
Each time you press and
release the SEEK button, the
player skips f orward to the
beginning of the next track (f ile in
MP3 or WMA). Press and release
the SEEK button to skip
backward to the beginning of the
current track. Press it again to skip
to the beginning of the previous
track.
With the f older name, you will see
the FOLDER indicator in the display.
The TRACK indicator is shown with
the file or track name.
When loading a CD-DA with text
data, the album and track name are
showninthedisplay.Withadiscin
MP3 or WMA, the display shows the
f older and f ile name.
T ext Dat a Display Funct ion
T o Change or Select T racks/Files
SEEK
Audio System (Models without Navigation System)
148
——
y

y
(%y
y

µ
µ µ
µ
µ
In MP3 or WMA mode In MP3 or WMA mode
To
select a different folder, turn the
TUNE knob to move to the
beginning of the next f older. Turn
theknobtotherighttoskiptothe
next f older, and to the lef t to move to
the beginning of the current f older.
Turn it again to skip to the beginning
of the previous f older. Turning the
TUNE knob more than one click
skips several f olders at a time.
To continuously replay
a track (f iles in MP3 or WMA mode),
press and release the RPT button.
You will see RPT in the display.
Press and hold the RPT button for 2
seconds to turn it off. This feature,
when activated, replays all f iles on
the selected f older in the order they
are compressed. To activate folder
repeat, press the RPT button twice.
You will see F-RPT in the display.
The system continuously replays the
current f older. To turn of f f older
repeat, press the RPT button for 2
seconds, or push it twice.
Each time you press and release the
RPT button, the mode changes f rom
f ile repeat to f older repeat, then to
normal playing. When you press
the RPT button three times, D-RPT
appears in the display, and the
system continuously replays the
current disc. To turn this f eature of f ,
press the RPT button or touch DISC
RPT again.
This f eature plays
the tracks within a disc (the f iles
within a f older in MP3 or WMA
mode) in random order. To activate
random play in CD-DA f ormat, press
and release the RDM button. In MP3
or WMA mode, press the RDM
button to activate random play within
a f older. You will see F-RDM in the
display. To return to normal play,
press the RPT button f or 2 seconds,
or push it twice.
CONT INUED
FOLDER SELECTION
REPEAT (TRACK/FILE
REPEAT) FOL DER-REPEA T
DISC REPEAT
RANDOM (Random within a
disc/f older)
Audio System (Models without Navigation System)
Features
149
——
y

y
(%y
y