2007 Acura TL oil type

Help assure your vehicle’s f uture
reliability and perf ormance by paying
extra attention to how you drive
during the f irst 600 miles (1,000 km).
During this period:
You should also f ollow these
recommendations with an
overhauled or exchanged engine, or
when the brakes are replaced.Do not change the oil until the
multi-inf ormation display indicates
it is needed. Avoidhardbrakingforthefirst
200 miles (300 km). Avoid full-throttle starts and rapid
acceleration.
Your vehicle is designed to operate
on premium unleaded gasoline with a
pump octane of 91 or higher. If this
octane grade is unavailable, regular
unleaded gasoline with a pump
octane of 87 or higher may be used
temporarily. The use of regular
unleaded gasoline can cause metallic
knocking noises in the engine and
will result in decreased engine
perf ormance. The long-term use of
regular-grade gasoline can lead to
engine damage.
Your vehicle is designed to operate
on premium unleaded gasoline with a
pump octane number of 91 or higher.
Useof aloweroctanegasolinecan
cause occasional metallic knocking
noises in the engine and will result in
decreased engine perf ormance. Use
of a gasoline with a pump octane
number less than 87 can lead to engine damage.
We recommend quality gasolines
containing detergent additives that
help prevent f uel system and engine
deposits.
In addition, in order to maintain good
perf ormance, f uel economy, and
emissions control, we strongly
recommend, in areas where it is
available, the use of gasoline that
does NOT contain manganese-based
f uel additives such as MMT.
Use of gasoline with these additives
may adversely af f ect perf ormance,
and cause the malfunction indicator
lamp on your instrument panel to
come on. If this happens, contact
your dealer f or service.Type S
All models except Type S
Break-in Period Fuel Recommendation
Break-in Period, Fuel Recommendation
234
——
y

y
(%yy

Always change the oil and f ilter
according to the maintenance
messages shown on the multi-
inf ormation display. The oil and f ilter
collect contaminants that can
damage your engine if they are not
removed regularly.
Changing the oil and f ilter requires
special tools and access f rom
underneath the vehicle. The vehicle
should be raised on a service station-
type hydraulic lif t f or this service.
Unless you have the knowledge and
proper equipment, you should have
this maintenance done by a skilled
mechanic.Run the engine until it reaches
normal operating temperature,
then shut it off.
Open the hood, and remove the
engine oil f ill cap. Remove the oil
drain bolt and washer f rom the
bottom of the engine. Drain the oil
into an appropriate container.
You may use a synthetic motor oil if
it meets the same requirements
given f or a conventional motor oil: it
displays the API Certif ication Seal
and it is the proper weight. You must
f ollow the oil and f ilter change
intervals shown on the multi-
inf ormation display.
Your vehicle does not require any oil
additives. Additives may adversely
af f ect the engine or transmission
perf ormance and durability.
2. 1.
Synthetic Oil
Engine Oil A dditives
Changing the Oil and Filter
A dding Engine Oil, Changing the Oil and Filter
284
DRAIN BOLT
WASHER
——
y
y
(%yy

Theheadlightswereproperlyaimed
when your vehicle was new. If you
regularly carry heavy items in the
trunk, readjustment may be required.
Adjustment should be done by your
dealer or other qualif ied mechanic.Remove the left or right side
engine compartment cover f rom
thesideyouareworkingonby
caref ully pulling the cover out.
If youarereplacingthebulbon
the driver’s side, remove the air
intake cover by removing the two
f astener pins and pulling the cover
out. Then remove the upper part
of the air intake duct by pulling it
straight up.
The headlight bulbs are a type of
high voltage discharge tube. High
voltage can remain in the circuit
even with the light switch off and the
key removed. Because of this, you
shouldnotattempttoexamineor
change a headlight bulb yourself . If a
headlight bulb f ails, take your
vehicle to a dealer to have it replaced. 1.
CONT INUED
Headlight A iming
Headlights
Replacing a Daytime Running
Light Bulb
Lights
Maint enance
293
Halogen bulbs get very hot when lit. Oil,
perspiration, or a scratch on the glass
can cause the bulb to overheat and
shatter.
——
y
y
(%yy

µµ
Î
Î
Î
Î
Î
Î
Î
Î
Specif ications
338
Capacities
Capacities Weights
Air Conditioning Dimensions 189.3 in (4,809 mm)
2.6 US qt (2.5
)
7.9 US qt (7.5
)
3.1 US qt (2.9)
5.3 US qt (5.0)
4.2 US qt (4.0
)
4.5 US qt (4.3
)
0.16 US gal (0.6
)
2.2 US qt (2.1
)
2.6 US qt (2.5)
4.8 US qt (4.5
)
2.17 US gal (8.2
)
2.11 US gal (8.0)
1.69 US gal (6.4
)
1.72 US gal (6.5)
Engine
coolant
Engine oil
Automatic
transmission
fluid
Manual
transmission
fluid
Windshield
washer
reservoir
Excluding the oil remaining in the engine Including the coolant in the reserve tank and that remaining in the
engine
Reserve tank capacity: 8.1 US qt (7.7
)
62.0 in (1,576 mm) 62.1 in (1,577 mm)
107.9 in (2,740 mm)
56.7 in (1,441 mm)
75.4 in (1,916 mm)
Fuel tank ND-OIL8
17.6 19.4 oz (500 550 g) HFC-134a (R-134a)
See the certification label attached
to the driver’s doorjamb.
Gross vehicle weight rating
Refrigerant type
Charge quantity
Lubricant type Length
Width
Height
Wheelbase
Track 189.8 in (4,822 mm)
Approx.
Front
Rear
Change
Manual
Automatic
Total Manual
Automatic
Change Including
filter
Without
filter
Total
Change
Total
Change
Total
U.S. Vehicle
Canada Vehicle
Type S
Type S
:
1:
2:
3:
1
2
3
17.1 US gal (64.7)
——y


y
(%yy

Service Information Summary
Gasoline:
Fuel Tank Capacity:
Recommended Engine Oil:
Automa tic Transmission Fluid: Tire
Pressure (measured cold):
SpareTirePressure:
Power
Steering Fluid:
Brake Fluid:
Manual
Transmission Fluid:
4.5 US qt (4.3
)
Premium
unleaded gasoline,
pump octane number of 91 or
higher.
API Service SJ ‘‘Energy
Conserving’’ oil, SAE 5W-20
viscosity (see page ).
Oil change capacity (including
filter):
Honda ATF-Z1 (Automatic
Transmission Fluid) preferred, or
aDEXRON
III ATF as a
temporary replacement (see page
). Front:
33
psi (230 kPa , 2.3 kgf/cm
)
Rear:
Front:
Rear:
60 psi (420 kPa , 4.2 kgf/cm
)
32
psi (220 kPa , 2.2 kgf/cm
)
Honda
Manual Transmission
Fluid preferred, or an SAE 10W-30
or 10W-40 motor oil as a
temporary replacement (see page
).
Capacity:
2.6 US qt (2.5
)
Honda Power Steering Fluid
preferred, or another brand of
power steering fluid as a
temporary replacement. Do not
use ATF (see page ).
Honda Heavy Duty Brake Fluid
DOT 3 preferred, or a DOT 3 or
DOT 4 brake fluid as a temporary
replacement (see page ). 32 psi (220 kPa , 2.2 kgf/cm
)
35 psi (240 kPa , 2.4 kgf/cm
)
283
288 290
292291 All models except Type S
Type S
17.1 US gal (64.7)
——
y
y
(%y
y