2007 Acura RDX key

When the vehic le speed reaches
about 9 mph (about 15 km/h) or
more, all the doors lock
automatically.
To change the ‘‘AUTO DOOR
LOCK’’ setting, see page .
When you shift to P after driving, the
driver’s door unlocks.
To change the ‘‘AUTO DOOR
UNLOCK’’ setting, see page .With
the driver’s door open and the
key in the ignition, both master door
lock switches are disabled. They are
not disabled if the driver’s door is
closed. Pushing the switch down on
the open front passenger’s door will
lock all doors and the tailgate.
To
lock any passenger’s door when
getting out of the vehicl e, pull
backward on the lock tab and close
the door. To lock the driver’s door,
remove the key from the ignition
switch and pull backward on the lock
tab. Then close the door.
You can change the ‘‘AUTO DOOR
UNLOCK’’ setting in the multi-
info rmation display (see page ).
You
can change the ‘‘AUTO DOOR
LOCK ’’ setting in the multi-
info rmation display (see page ).
The childproof door locks are
designed to prevent children seated
in the rear f rom accidentally opening
the rear doors. Each rear door has a
lock lever near the edge. With the
lever in the LOCK position (lever is
down), the door cannot be opened
fromtheinsideregardlessof the
position of the lock tab. To open the
door, push the lock tab f orward and
use the outside door handle.
133
108
135
116
On RDX with Technology Packagemodel
On RDX with Technology Packagemodel
Childproof Door L ocks
Door L ocks
L ockout Prevent ion
132
LEVER
Lock
——
y

y
() y
y

The tailgate will lock or unlock when
you lock or unlock the driver’s door
by using the key, the lock tab on the
driver’s door, the master door lock
switch, or the remote transmitter.
To open the tailgate, press and hold
the switch, then lift up. To
close the tailgate, hold the
tailgate handle, lower the tailgate,
then press down on the back edge.
Keep the tailgate closed at all times
while driving to avoid damaging the
tailgate and to prevent exhaust gas
f rom getting into the interior. See on page
.
58
Tailgate
Carbon Monoxide Hazard
138
SWITCH
TAILGATE
HANDLE
——
y
y
() y
y

µµ
When you press the UNLOCK
button, the ceiling lights (if the front
and rear ceiling light switches are in
the door activated position) will
come on. If you do not open any door,
the lights stay on for about 30
seconds, then fade out. If you relock
the doors with the remote
transmitter before 30 seconds have
el ap sed, the lights go off
immediately.
You can change the ‘‘INTERIOR
LIGHT DIMMING TIME’’ setting in
the multi-information display (see
page ).
Press
this button once to
lock all doors and the tailgate. Some
exterior lights will flash once. When
you push LOCK twice within 5
seconds, you will hear a beep to
verify that the security system has
set. You cannot lock the doors and
thetailgateifanydoororthetailgate
is not fully closed or the key is in the
ignition switch. Press
this button once
to unlock the driver’s door. Push it
twice to unlock the remaining doors
and the tailgate. Some exterior lights
will flash twice each time you press
the button.
You can change the ‘‘KEYLESS
LOCK ACKNOWLEDGMENT’’
setting in the multi-information
display (see page ).
You can change the ‘‘DOOR LOCK
MODE’’ setting in the multi-
info rmation display (see page ).
103
110
112
On RDX with Technology Package
model
On RDX with Technology Packagemodel
Remote Transmitter
LOCK UNL OCK
140
UNLOCK
BUTTON
LOCK
BUTTON
PANIC
BUTTON
——
y

y
() y
y

If it takes several pushes on the
button to lock or unlock the doors
and the tailgate, replace the battery
as soon as possible.
Battery type: CR1616To replace the battery:Remove the screw at the base of
the transmitter with a small
Phillips-head screwdriver.
Separate the keypad from the
transmitter by pushing any button
f rom outside. Place a cloth on the edge of the
keypad, and remove the upper half
by caref ully prying on the edge
with a small f lat-tip screwdriver.
1.
2. 3.
Remote Transmitter
Replacing the Transmitter
Battery
142
SCREW
KEYPAD BATTERY
——
y
y
() y
y

µ
As required by the FCC:This device complies with Part 15 of theFCC rules. Operation is subject to thef ollowing two conditions: (1) This devicemay not cause harmf ul interf erence, and(2) this device must accept anyinterf erence received, includinginterf erence that may cause undesiredoperation.
Changes or modif ications not expresslyapproved by the party responsible f orcompliance could void the user’sauthority to operate the equipment.
This device complies with IndustryCanada Standard RSS-210.Operation is subject to the f ollowing twoconditions: (1) this device may not causeinterf erence, and (2) this device mustaccept any interf erence that may causeundesired operation of the device.Remove the old battery and note
the polarity. Make sure the
polarity of the new battery is the
same ( side f acing up), then
insert it in the keypad.
Snap the two halves of the keypad,
then install the parts in reverse
order. An improperly disposed battery
can hurt the environment.
Always conf irm local regulations
for battery disposal.
4.
5.
Remote Transmitter
Inst rument s and Cont rols
143
——
y
y
() y
y

The moonroof has a key-of f delay.
You can open and close the
moonroof f or up to 10 minutes af ter
you turn of f the ignition switch. The
key-of f delay cancels as soon as you
open either f ront door. You must
then turn the ignition switch to the
ON (II) position f or the moonroof to
operate.If the moonroof runs into any
obstacle while it is closing
automatically, it will reverse
direction, and then stop. To close the
moonroof , remove the obstacle, then
use the moonroof switch again.
Auto reverse stops sensing when the
moonroof is almost closed. You
should always check that all
passengers and objects are away
f rom the moonroof bef ore closing it. Auto Reverse
Moonroof
154
Opening or closing the
moonroof on someone’s hands
or fingers can cause serious
injury.
Make sure all hands and fingers
are clear of the moonroof
before opening or closing it.
If you try to open the moonroof in
below-f reezing temperatures, or when
it is covered with snow or ice, you can
damage the moonroof panel or motor.
——
y
y
() y
y

Open any door.
Remove the key from the ignition
switch.
Unlock the doors with the key,
locktabonthedriver’sdoor,
master door lock switch, or
remote transmitter.
After all doors are closed tightly, the
light(s) dims slightly, then fades out
in about 30 seconds. If
you do not open any door after
unlocking the driver’s door or
removing the key from the ignition
switch, the light(s) fade out in about
30 seconds. If you leave any door
open without the key in the ignition
switch, the light(s) will go off after 3
minutes.
You can use the front ceiling lights
whenever the lights are off.
To turn the lights on or off, push its
lens.
In
the door activated position, both
front and rear ceiling lights come on
when you:
You can change the ‘‘INTERIOR
LIGHT DIMMING TIME’’ setting in
the multi-information display (see
page ).103
On RDX with Technology Package
model
Interior Lights
Inst rument s and Cont rols
159
LENSES
——
y

y
() y
y

The courtesy lights in the ceiling
console come on when the light
switch is in the or the
position. You can adjust their
brightness by turning the Select/
Reset knob on the instrument panel. The
cargo area light has a two
position switch. In the OFF (right)
position, the light does not come on.
In the ON (left) position, the light
comesonwhenyou openthetailgate.
Your
vehicle also has a courtesy light
in the ignition switch. This light
comesonwhenyou;
Unlock the driver’s door.
Remove the key from the ignition
switch. Open any door.
The
courtesy light in each front door
comes on when the door is opened,
and goes out when the door is closed.
After all doors are closed tightly, the
light fades out in about 30 seconds.
You can change the ‘‘INTERIOR
LIGHT DIMMING TIME’’ setting in
the multi-information display (see
page ). 103
On RDX with Technology Package
model
Interior Lights
Courtesy Lights Cargo Area Light
160
COURTESY LIGHTS ON OFF
——
y

y
() y
y