Page 81 of 442

¶¶µµ
µµµ
µµµ
To reset a trip meter, display it, and
then press and hold the Select/Reset
knob until the number resets to ‘‘0.0’’.
When you reset Trip A, AVG. FUEL
A is reset at the same time. When
you reset Trip B, AVG. FUEL B is
reset.
This shows your vehicle’s average
f uel economy in mpg (U.S. models)
or
/100 km (Canadian models)
since you last reset the Trip A or
Trip B. If the outside temperature is
incorrectly displayed, you can adjust
it up 5°F in U.S. models ( 3°C in
Canadian models) warmer or cooler.
NOTE: The temperature must be
stabilized bef ore doing this
procedure.
When the temperature reaches the
desired value, release the Select/
Reset knob. You should see the new
outside temperature displayed.
The average f uel mileage will be
reset when you reset the trip meter,
or if the vehicle’s battery goes dead
or is disconnected. This shows the outside temperature
in Fahrenheit (U.S. models), or in
Centigrade (Canadian models).
The temperature sensor is in the
f ront bumper. The temperature
reading can be affected by heat
ref lection f rom the road surf ace,
engine heat, and the exhaust f rom
surrounding traf f ic. This can cause
an incorrect temperature reading
when your vehicle speed is under
19 mph (30 km/h). When you start
your trip, the sensor is not f ully
acclimatized, theref ore it may take
several minutes until the proper
temperature is displayed.
In certain weather conditions,
temperature readings near f reezing
(32°F, 0°C) could mean that ice is
f orming on the road surf ace.
To adjust the outside temperature
indicator, press and hold the Select/
Reset knob f or 10 seconds. The
f ollowing sequence will appear f or 1
secondeach:0,1,2,3,4,5, 5, 4,
3, 2, 1, 0 (U.S.) or 0, 1, 2, 3,
3, 2, 1, 0 (Canada).
CONT INUED
Gauges
AVG. FUEL A/B Out side T emperat ure Indicat or
Inst rument s and Cont rols
77
——
y
y
() yy
Page 82 of 442

This shows the temperature of the
engine’s coolant. During normal
operation, the reading should rise
from the ‘‘C (Cold)’’ mark to about
the middle of the gauge. In severe
driving conditions, such as very hot
weather or a long period of uphill
driving, the reading may rise to near
the ‘‘H (Hot)’’ mark of the gauge. If
it re aches the ‘‘H’’ mark, pull safely
to the side of the road. See page for instructions and precautions
on checking the engine’s coolant
system. The information display in the
instrument panel shows you the
engine oil life and maintenance
service items when the ignition
switch is in the ON (II) position. This
information helps to keep you aware
of the periodic maintenance your
vehicle needs for continued trouble-
free
driving. Refer to page for
more information. If
your fuel fill cap is loose or
missing, a ‘‘CHECK FUEL CAP’’
messa ge appears on the information
display after you start the engine.
For more information, see page .
391 330280
Gauges
T emperat ure Gauge
Check Fuel Cap Message
Maint enance Minder
78
——
y
y
() yy
Page 85 of 442

The odometer shows the total
distance your vehicle has been
driven. It measures miles in U.S.
models and kilometers in Canadian
models. It is illegal under U.S.
federal law and Canadian provincial
regulations to disconnect, reset, or
alter the odometer with the intent to
ch ange the number of miles or
kilometers indicated.
This meter shows the number of
miles (U.S.) or kilometers (Canada)
driven since you last reset it. There
are two trip meters: Trip A and Trip
B. Each trip meter works
independently, so you can keep track
of two different distances. When
you reset Trip A, AVG.
FUEL A is reset at the same time.
When you reset Trip B, AVG.
FUEL B is reset. The
temperature sensor is in the
front bumper. The temperatu re
reading can be affected by heat
reflection from the road surface,
engine heat, and the exhaust from
surrounding traffic. This can cause
an incorrect temperature reading
when your vehicle speed is under
19 mph (30 km/h). When you start
your trip, the sensor is not fully
acclimatized, therefore it may take
several minutes until the proper
te mperature is displayed.
In certain weather conditions,
temperature readings near freezing
(32°F, 0°C) could mean that ice is
forming on the road surface.
To reset a trip meter, display it, then
press and hold the SEL/RESET
button until the number resets to
‘‘0.0’’. You
can adjust the outside
temperature in the multi-info rmation
display (see page ).
You
can customize the Trip A and
AVG. FUEL A reset condition in the
multi-info rmation display (see page
).
This shows the outside temperature
in Fahrenheit (U.S. models), or in
Centigrade (Canadian models). 98
96
Multi-Inf ormation Display
Odometer
Trip MeterOutside Temperature Display
Inst rument s and Cont rols
81
——
y
y
() yy
Page 86 of 442

This shows the estimated distance
you can travel on the fuel rema ining
in the fuel tank. This distan ce is
estimated from the fuel economy
you received over the last several
miles(U.S.) or kilometers (Canada),
so it will vary with changes in speed,
traffic, etc.
This shows the time traveled since
you last reset it. When you turn the
ignition switch to the ON (II)
pos ition, ELAPSED TIME is reset.
You can customize the ELAPSED
TIME reset condition in the multi-
info rmation display (see page ).You
can customize the Trip A and
AVG. FUEL A reset condition in the
multi-info rmation display (see page
).
This
shows your vehicle’s average
fuel economy in mpg (U.S. model s)
or
/100 km (Canadian models)
since you last reset the Trip A or
Trip B.
When
you reset Trip A, AVG.
SPEED is also reset.
This
shows the average speed you
are traveling in miles per hour (mph)
forU.S.modelsorkilometersper
hour (km/h) for Can adian models.
When the battery is disconnect ed, or
you refuel, RANGE is also reset.
The
multi -information display in the
instrument panel shows you the
engine oil life and maintenance
service items when the ignition
switch is in the ON (II) position. This
information helps to keep you aware
of the periodic maintenance your
vehicle needs for continued trouble-
free driving. Refer to page for
more inf ormation.
This shows your current f uel
mileage.
When you turn of f the engine, INST.
MPG or INST. L/100 km is also
reset.
The average f uel mileage will be
reset when you reset the trip meter,
or if the vehicle’s battery goes dead
or is disconnected.98
100
330
Multi-Inf ormation Display
RANGE
EL A PSED T IME
AVG. FUEL A/B A VG. SPEED
Maintenance Minder
INST.MPG(U.S.models)/INST.
L /100km (Canadian models)
82
——
y
y
() yy
Page 92 of 442

ÎÎÎ
Î Î
Î
Î Î
µ™¶™
µ™ ¶™
Î
Menu Item Setting Option Page
Group Setup Description
LANGUAGE SELECT ION
ADJUST OUTSIDE
TEMP. DISPLAY
TRIP A & AVG. FUEL
RESET with REFUEL
ELAP. TIME RESET
CONDITION
INTERIOR LIGHT
DIMMING T IME
HEADLIGHT AUT O OFF
TIMER
AUTO DOOR LOCK ENGLISH
FRENCH
SPANISH
5°F 0°F 5°F
3°C 0°C 3°C
ON
OFF
IGN RESET
TRIP A RESET
TRIP B RESET
15 sec
30 sec
60 sec
0sec
15 sec
30 sec
60 sec
SHIFT FROM P
WITH VEH SPEED
OFF 94
96
98
100
103
105
108
MET ER SET UP
(P.93)
LIGHTING SETUP
(P.102)
DOOR SETUP
(P.107) Changes the language used in the display.
Changes the outside temperature reading above or
below its current reading.
Causes trip meter A and the average fuel economy
to reset when you refuel.
Resets the elapsed time of your current trip.
Changes how long (in seconds) the interior lights
stay on after you close the doors.
Changes how long (in seconds) the exterior lights
stay on after you close the driver’s door.
Changes when the doors automatically lock.
: Default setting
Multi-Inf ormation Display
88
——
y
y
() yy
Page 97 of 442
Û
Ý
ÛÝ
ÛÝ
Here are the four custom settings
forthemetersetup:
LANGUAGE SELECTION
ADJUST OUTSIDE TEMP.
DISPLAY
TRIP A & AVG. FUEL RESET
with REFUEL
ELAP. TIME RESET
CONDITION
While METER SETUP is shown in
the CUSTOMIZE GROUP of the
multi-info rmation display, press the
SEL/RESET button.
Each time you press the INFO ( /
) button, the screen changes as
shown in the illustration. Press the
INFO ( / ) button until you see
the setting you want to customize,
then press the SEL/RESET button
to enter your selection.
CONTINUED
Meter Setup
Multi-Information Display
Instru me ntsand Cont ro ls
93
: Press the SEL/
RESET button or
the Select/Reset
knob
: Press the INFO
( / ) button or
rotate Select/
Reset knob Seepage94
Seepage96
Seepage98
Seepage100
——
y
y
() yy
Page 102 of 442
ÛÝÛÝ
While METER SETUP is shown in
the CUSTOMIZE GROUP of the
multi-inf ormation display, press the
SEL/RESET button. The screen
changes to CUSTOMIZE MENU.
Press the INFO ( / ) button until
you see the above display.
To cause Trip A and AVG. FUEL A
to reset every time you ref uel your
vehicle, f ollow these instructions:
Press the SEL/RESET button. The
screen changes as shown above.
Select ON or OFF by pressing the
INFO ( / ) button, then press the
SEL/RESET button to enter your
selection.
Multi-Inf ormation Display
T rip A & A vg. Fuel Reset wit h Ref uel
98
——
y
y
() y
y
Page 103 of 442
ÛÝ
To exit TRIP A & AVG. FUEL
RESET with REFUEL without
changing the current setting, select
EXIT by pressing the INFO ( / )
button, then press the SEL/RESET
button. The screen goes back to
CUSTOMIZE MENU.
When your choice is set, you will see
the above display f or several seconds,
then the screen goes back to
CUSTOMIZE MENU.
If your choice is not set, you will see
the above display f or several seconds,
then the screen goes back to
CUSTOMIZE MENU. If this
happens, you need to repeat the
same procedure.
CONT INUED
Multi-Inf ormation Display
Inst rument s and Cont rols
99
——
yy
() y
y