2007 Acura MDX automatic transmission

Î
Î
Î Î
Î
CONTINUED: If equipped
Your Vehicle at a Glance
You rVehicle a ta Glance
3
HOOD RELEASE
HANDLE AUDIO
SYSTEM
GAUGES INSTRUMENT
PANEL
INDICATORS HomeLink
BUTTONS
AUTOMATIC
TRANSMISSION
HEADPHONE CONNECTORS
AUXILIARY INPUT JACKS
FUEL
FILL DOOR
RELEASE BUTTON
POWER
WINDOW
SWITCHES
DRIVING
POSITION
MEMORY SYSTEM
CLIMATE CONTROL
SYSTEM MIRROR
CONTROL
AUTO BUTTON
PARKING BRAKE
PEDAL REAR
CLIMATE
CONTROL SYSTEM
MOONROOF
SWITCH
POWER TAILGATE
BUTTON
POWER
DOOR LOCK
MASTER SWITCH
PARKING BRAKE
RELEASE HANDLE (P.272)
(P.63)
(P.72)
(P.130)
(P.151)
(P.147)
(P.317) (P.132)(P.319) (P.151) (P.263) (P.264)(P.173)(P.333) (P.178)
(P.168)
(P.153)
(P.150)
PASSENGER’S
FRONT AIRBAG
DRIVER’S
FRONT
AIRBAG (P.9
, 27)
(P.155) (P.9, 34)
——y

y
()-yy

Î
Î
Î Î
Î
: If equipped
Control Locations
62
HOOD RELEASE
HANDLE AUDIO
SYSTEM
GAUGES INSTRUMENT
PANEL
INDICATORS HomeLink
BUTTONS
AUTOMATIC
TRANSMISSION
HEADPHONE CONNECTORS
AUXILIARY INPUT JACKS
FUEL
FILL DOOR
RELEASE BUTTON
POWER
WINDOW
SWITCHES DRIVING POSITION
MEMORY SYSTEM
CLIMATE CONTROL
SYSTEM MIRROR
CONTROL
AUTO BUTTON
PARKING BRAKE
PEDAL REAR
CLIMATE
CONTROL SYSTEM
MOONROOF
SWITCH
POWER TAILGATE
BUTTON
POWER
DOOR LOCK
MASTER SWITCH
PARKING BRAKE
RELEASE HANDLE (P.155)
(P.130)
(P.151)
(P.147)
(P.317) (P.132)(P.319) (P.151) (P.263) (P.264)(P.173)(P.333) (P.178)
(P.168)
(P.153)
(P.150)
(P.272)
(P.63)
(P.72)
——y
y
()-yy

This indicator monitors the
temperature of the automatic
transmission fluid. It should come on
for a few seconds when you turn the
ignition switch to the ON (II)
position. If it comes on while driving,
it means the transmission fluid
temperature is too high. Pull to the
side of the road when it is safe, shift
to Park, and let the engine idle until
the indicator goes out.
You will also see an ‘‘A/T TEMP
HI GH’’ message on the multi-
info rmation display (see page ).Most
of the time, this indicator
comes on along with other indicators
in the instrument panel such as the
seat belt reminder indicator, SRS
indicator, VSA system indicator, etc.
This
indicator normally comes on for
a few seconds when you turn the
ignition switch to the ON (II)
position.
If it comes on while driving, it
indicates that one or more of your
vehicl e’s tires are extremely low on
pressure.
You will also see a ‘‘CHECK TIRE
PRESSURE’’ message on the multi-
info rmation display (see page ).
If this happens, pull to the side of the
ro ad when it is safe, check which tire
has lost pressure on the multi-
info rmation display, and determine
the cause. If it is because of a flat tire,
have the flat tire repaired as soon as
possible. If two or more tires are
underinflated, call a professional
towing service. For more
info rmation, see page . This
indicator comes on when there
is a system message on the multi-
information display. Press the INFO
button on the steering wheel (see
page ) to see the message (see
page ).
82
433 81 73
82
A/T Temperature
Indicator
Message Indicator
Low Tire Pressure
Indicator
Instrument Panel Indicators
68
Continuing to drive with the A/T
temperature indicator on may cause
serious damage to the transmission.
——y
y
()-yy

µ
µ
Hold past ON to turn the rear
window wiper on and to spray the
rear window washer.
Rotate the switch
counterclockwise to spray the
window washer.
When you shif t the transmission
to the reverse position with the
f ront windshield wipers activated,
the rear window wiper operates
automatically.
When the wiper control lever
position is INT, the rear wiper
operates intermittently. When it is
LO or HI, the rear wiper operates
continuously. Push down on the
lever to signal a lef t turn and up to
signal a right turn. To signal a lane
change, push lightly on the lever,
and hold it. The lever will return to
center when you release it or
complete a turn.
Turning the switch to
the ‘‘ ’’ position turns on the
parking lights, taillights, instrument
panel lights, side-marker lights, and
rear license plate lights.
Turning the switch to the ‘‘ ’’
position turns on the headlights. If
you leave the lights on with the key
removed f rom the ignition switch,
you will hear a reminder chime when
you open the driver’s door.
Turn signal
Of f
Parking and indicator lights
AUTO
Headlights on
High beams
Flashhighbeams
Fog lights of f
Fog lights on
Therearwindowwasherusesthe
same f luid reservoir as the wind-
shield washer. 1.
2.
3.
4.
5.
6.
7.
8.
9.
3.
4.
Turn Signal
Headlights
Turn Signal and Headlights
Windshield Wipers and Washers, Turn Signal and Headlights
118
——y


y
()-y
y

You can increase the set cruising
speed in any of these ways:You can decrease the set cruising
speed in any of these ways:
Press and hold the RES/ACCEL
button. When you reach the
desired cruising speed, release the
button.
Push on the accelerator pedal.
Accelerate to the desired cruising
speed, then press the SET/
DECEL button. Press and hold the SET/DECEL
button. Release the button when
you reach the desired speed.
To increase your speed in very
small amounts, tap the RES/
ACCEL button. Each time you do
this, the vehicle speeds up about 1
mph (1.6 km/h).
Cruise control may not hold the set
speed when you are going up and
down hills. If your vehicle speed
increases going down a hill, use the
brakes to slow down. This will cancel
thecruisecontrol.Toresumetheset
speed, press the RES/ACCEL button.
The CRUISE CONTROL indicator
on the instrument panel will come
back on.
When climbing a steep hill, the
automatic transmission may
downshif t to hold the set speed.
To slow down in very small
amounts, tap the SET/DECEL
button. Each time you do this,
your vehicle will slow down about
1 mph (1.6 km/h).
Tap the brake pedal lightly with
your f oot. The CRUISE
CONTROL indicator on the
instrument panel will go out.
When the vehicle slows to the
desired speed, press the SET/
DECEL button.
CONT INUED
Changing the Set Speed
Cruise Control
Features
267
——y
y
()-yy

This section gives you tips on
starting the engine under various
conditions, and how to operate the
automatic transmission. It also
includes important inf ormation on
parking your vehicle, the braking
system, the super handling-all wheel
drive (SH-AWD) system, the vehicle
stability assist (VSA) system, active
damper system, the tire pressure
monitoring system (TPMS), and
f acts you need if you are planning to
tow a trailer or drive off-high way.........................
Driving Guidelines .330
........................
Preparing to Drive .330
.......................
Starting the Engine .332
Check Starting System .................................
Message .332
..............
Automatic Transmission . 333
Super Handling-All Wheel Drive ...................
(SH-AWD) System . 340
...........................................
Parking .342
Tire Pressure Monitoring System ......................................
(TPMS) .343
.............................
Braking System .348
...............
Anti-lock Brakes (ABS) . 349
Vehicle Stability Assist (VSA) ........................................
System .351
................
Active Damper System . 353
...........................
Towing a Trailer .355
..................
Trailer Stability Assist . 367
..............
Of f -Highway Guidelines . 369
Driving
Driving
329
——y
y
()-yy

The ‘‘D’’ indicator comes on for a
few seconds when you turn the
ignition switch to the ON (II)
position. If it flashes while driving (in
any shift position), it indicates a
possible problem in the transmission.
If the malfunction indicator lamp
comes on along with the ‘‘D’’
indicato r, there is a problem with the
automatic transmission control
system. Avoid rapid acceleration, and
have the transmission checked by
your dealer as soon as possible.
When the ‘‘D’’ indicator warns of a
possible problem with the
transmission, you will see a ‘‘CHECK
TRANSMISSION’’ message on the
multi-inf ormation display (see page ).
These indicators on the instrument
panel show which position the shif t
lever is in. In the Sequential
SportShif t Mode, the ‘‘M’’ indicator
next to the ‘‘D’’ indicator comes on,
and the illuminated number under
the charging system indicator shows
you the gear you have selected. To shif t f rom Park to any position,
press firmly on the brake pedal and
pressthereleasebuttononthefront
of the shif t lever, then pull the lever.
YoucannotshiftoutofParkwhen
the ignition switch is in the LOCK
(0) or the ACCESSORY (I) position.
82
CONT INUED
Shif t L ever Position Indicators Shif ting
Automatic Transmission
Driving
333
——y
y
()-yy

µ
µ µ
µ To
avoid transmission damage, come
to a complete stop before shifting
into Park. The shift lever must be in
Park before you can remove the key
from the ignition switch.
Press the brake
pedal and press the release button
on the front of the shift lever to shift
fr om Park to reverse. To shift from
reverse to neutral, come to a
completestop,andthenshift.Press
the release button before shifting
into reverse from neutral.
Use neutral if you
need to restart a stalled engine, or if
it is necessary to stop briefly with
the engine idling. Shift to the Park
position if you need to leave your
vehicle for any reason. Press on the
brake pedal when you are moving
the shift lever from neutral to
another gear. Use
this position for
your norm al driving. The
transmission automatically selects a
suitable gear (1 through 5) for your
sp eed and acceleration. You may
notice the transmission shifting up at
higher engine speeds when the
engine is cold. This helps the engine
warm up faster.
This position mechani-
cally locks the transmission. Use
Park whenever you are turning off or
starting the engine. To shift out of
Park, you must press on the brake
pedal and press the release button
on the shif t lever. Make sure your
f oot is of f the accelerator pedal.
If you have done all of the above and
still cannot move the lever out of
Park, see on
page . 338
Do this:
Press the brake pedal, and
press the shift lever release
button.
Press the shift lever release
button.
Move the shift lever.
To shift from:
PtoR
RtoP
NtoR
DtoD DtoD DtoN
NtoDRtoN
3
3
Automatic Transmission
Reverse (R)
Neutral (N) Drive (D)
Park (P) Shif t L ock Release
334
——y

y
()-yy