2007.5 Peugeot 307 wheel
[x] Cancel search: wheelPage 135 of 212
10PRACTICAL INFORMATION
121
Detach the wheel/holder assembly
from the rear of the vehicle.
Take out the notched hook to
release the wheel, as shown in
the illustration. Removing the wheel
Slide the holder cover to gain
access to the tools.
If necessary, place a chock under
the wheel diagonally opposite to
the one to be changed.
Remove the trim, using the
wheelbrace 1 , pulling at the valve
p a s s a g e h o l e ( f o r v e h i c l e s i t t e d
with steel wheels).
Loosen the wheel bolts (see
§ "Special features of alloy
w h e e l s " f o r v e h i c l e s i t t e d w i t h
alloy wheels).
Note
: you can use the other end
of the tool 6 to unscrew the wheel
bolts.
Place the jack 4 in contact with
one of the four locating points
A on the sub-frame; the closest
possible to the wheel to be
changed.
Extend the jack 4 until its base
is in contact with the ground.
Ensure that the centre line of the
base of the jack is straight above
the locating point A used.
Raise the vehicle.
Remove one bolt and position the
centralising tool 5 in its place.
Unscrew the other bolts and
remove the wheel.
Page 136 of 212
10PRACTICAL INFORMATION
122
Fitting a wheel
Position the wheel using the
centralising tool 5 to assist you.
Tighten the bolts by hand and
remove the centralising tool 5 .
Partly tighten the bolts using the
wheelbrace 1 .
Fold the jack 4 and remove it.
Fully tighten the bolts using the
wheelbrace 1 .
Replace the wheel trim, starting
by placing the wheel trim notch
opposite the valve, and press it
on using the palm of the hand.
Put the corresponding tools in the
holder and secure its cover.
Place the holder on the ground
and align the spare wheel on it.
Pass the notched hook into the
holder cover.
R e i t t h e w h e e l u n d e r t h e v e h i c l e
tightening the winch control nut
using the wheelbrace 1 .
Fully tighten and check that
t h e w h e e l i s h o r i z o n t a l l y l u s h
a g a i n s t t h e r e a r l o o r .
C l o s e t h e l a p u s i n g t h e l u g t o
lock the winch.
Store the rest of the tools in the
right-hand trim of the boot.
F o r y o u r s a f e t y , a l w a y s
change the wheel:
- on level, stable, non-slippery ground,
- with the handbrake on and the ignition switched off,
- w i t h i r s t o r r e v e r s e g e a r e n g a g e d (position P for the automatic
gearbox),
- with the vehicle chocked.
N e v e r g o u n d e r n e a t h a v e h i c l e t h a t
i s s u p p o r t e d o n l y b y a j a c k ( u s e a
ramp).
N e v e r r e i t t h e h o l d e r u n d e r t h e
vehicle without the spare wheel.
D o n o t u s e a s c r e w d r i v e r i n p l a c e
o f t h e w h e e l b r a c e t o u n w i n d o r
w i n d t h e w i n c h . R e c o m m e n d a t i o n s w h e n u s i n g
t h e t e m p o r a r y s p a r e w h e e l *
Your vehicle may be equipped with a
spare wheel which has a different rim
to the standard wheel.
After use, it must be replaced as
quickly as possible.
Observe the following instructions to
avoid altering the behaviour of the
vehicle:
-
do not exceed
50 mph (80 km/h) ,
- d o n o t i t a w h e e l t r i m ,
- drive with care,
- check the tyre pressure indicated
on the label.
A f t e r c h a n g i n g t h e w h e e l :
- have the correct positioning of the
punctured wheel, the tightening
of the bolts and the tyre pressure
checked by a PEUGEOT dealer
as soon as possible,
- have the punctured tyre repaired a n d r e i t i t t o t h e v e h i c l e a s s o o n
as possible,
- have the correct positioning of the spare wheel checked by a
PEUGEOT dealer.
W h e e l s i t t e d w i t h t h e T y r e U n d e r -
I n l a t i o n D e t e c t i o n s y s t e m
For further information refer to "Tyre
u n d e r - i n l a t i o n d e t e c t i o n " i n t h e
safety section.
* According to model and country.
Page 137 of 212
10PRACTICAL INFORMATION
123
Alloy wheel bolts are covered by
chrome trims.
Use the yellow tool 6 to remove the
trims before slackening the bolts. Wheel with centre trim
F i t t i n g s n o w t y r e s
I f y o u i t s n o w t y r e s m o u n t e d o n
steel wheels onto your vehicle, it
is essential to use special bolts
available from your PEUGEOT
dealer.
slide the trim remover 7 into the
notch of the centre trim,
use the trim remover as a lever
pressing on the trim to unclip it,
unscrew the bolt using the anti-
theft socket and the wheelbrace.
I f y o u r v e h i c l e i s i t t e d w i t h a s t e e l
s p a r e w h e e l , w h e n i t t i n g i t , i t i s
normal when tightening the bolts to
notice that the washers do not come
into contact with the rim. The spare
wheel is secured by the cone shape
of each bolt.
This anti-theft socket was
given to you on delivery
of your vehicle along with
the duplicate keys and the
c o n i d e n t i a l c a r d .
Make a careful note of the code
number engraved on the head of the
anti-theft socket. This will enable you
to obtain a duplicate socket from a
PEUGEOT dealer.
S p e c i a l f e a t u r e s o f a l l o y w h e e l s
Fitting the spare wheel
A n t i - t h e f t b o l t s
Y o u r w h e e l s a r e i t t e d w i t h a n a n t i -
theft bolt, one per wheel.
Bolt covers
Wheel with chrome trim
remove the chrome trim,
unscrew the bolt using the anti-
theft socket and the wheelbrace.
Page 141 of 212
10PRACTICAL INFORMATION
127
Remove the tailgate upper trim
carefully by unclipping it on either
side, perpendicular to its direction
of engagement.
Insert a screwdriver into the two
outer holes B to press on the two
tabs C .
Push the light unit outwards while
maintaining the pressure on the
tabs.
Pull the light unit outwards while
tilting it.
Change the faulty bulb.
W h e n r e i t t i n g , e n s u r e t h a t t h e
light unit tabs are engaged
correctly and that the tailgate
upper trim has been put back in
place correctly.
1. Brake lights (P 21 W).
2. S i d e l i g h t s ( x 2 ) ( R 5 W ) .
3. D i r e c t i o n i n d i c a t o r s ( P 2 1 W ) .
4. R e v e r s i n g l i g h t ( P 2 1 W ) ,
l e f t - h a n d s i d e .
F o g l a m p ( P 2 1 W ) , r i g h t - h a n d
s i d e .
These 6 bulbs are changed by
removing the light:
Remove the corresponding boot
side trim to access the light,
R e m o v e t h e l i g h t i x i n g n u t i n s i d e
the boot,
R e m o v e t h e l i g h t i x i n g n u t o u t -
side the boot,
Remove the light,
Unclip the harness,
Remove the bulb holder pressing
on the tabs A ,
Change the faulty bulb.
Note: if necessary, use the wheel-
brace to remove the nuts.
W h e n r e i t t i n g , t a k e c a r e t o p o s i t i o n
the bulb holder and the light
correctly.
Number plate lights
(W 5 W)
Insert a thin screwdriver into one
of the external holes of the lens.
Push it outwards to unclip it.
Remove the lens.
Change the faulty bulb.
Rear lights (estate) T h i r d b r a k e l i g h t ( e s t a t e )
(4 W 5 W bulbs)
Page 142 of 212
10PRACTICAL INFORMATION
128
C h a n g i n g a f u s e
Before changing a fuse, you must
establish the cause of the fault and
have it corrected. The fuse numbers
are indicated on the fuse box.
Always change a faulty fuse for one
of the same rating (same colour).
Use the special pliers located on the
inside of the fascia fuse box cover,
this support also contains the spare
fuses.
F a s c i a p a n e l f u s e s
Fuse No. Rating Functions
F1 15 A Rear wiper.
F2 30 A Locking and deadlocking.
F3 5 A Air bags and pre-tensioners unit.
F4 10 A Brake (STOP) and clutch pedal switches, engine
coolant level switch, steering wheel angle sensor,
ESP dual-function sensor, particle emission
i l t e r p u m p , d i a g n o s t i c s o c k e t , e l e c t r o c h r o m a t i c
mirror.
F5 30 A Front electric windows, sunroof, heated mirrors.
C H A N G I N G A F U S E
The fuse boxes are located in the
lower part of the fascia (passenger
side) and in the engine compartment
(left-hand side).
Correct Incorrect
Open the glove box lid to gain
access to the fuses.
Page 143 of 212
10PRACTICAL INFORMATION
128
C h a n g i n g a f u s e
Before changing a fuse, you must
establish the cause of the fault and
have it corrected. The fuse numbers
are indicated on the fuse box.
Always change a faulty fuse for one
of the same rating (same colour).
Use the special pliers located on the
inside of the fascia fuse box cover,
this support also contains the spare
fuses.
F a s c i a p a n e l f u s e s
Fuse No. Rating Functions
F1 15 A Rear wiper.
F2 30 A Locking and deadlocking.
F3 5 A Air bags and pre-tensioners unit.
F4 10 A Brake (STOP) and clutch pedal switches, engine
coolant level switch, steering wheel angle sensor,
ESP dual-function sensor, particle emission
i l t e r p u m p , d i a g n o s t i c s o c k e t , e l e c t r o c h r o m a t i c
mirror.
F5 30 A Front electric windows, sunroof, heated mirrors.
C H A N G I N G A F U S E
The fuse boxes are located in the
lower part of the fascia (passenger
side) and in the engine compartment
(left-hand side).
Correct Incorrect
Open the glove box lid to gain
access to the fuses.
Page 144 of 212
10PRACTICAL INFORMATION
129
Fuse N° Rating
Functions
F6 30 A Rear electric windows.
F7 5 A Front and rear courtesy lights, map reading lights, glove bo x lighting.
F8 20 A Audio equipment, audio/telephone, multifunction display
, alarm siren, alarm unit, trailer fuse
box, driving school module, steering wheel controls supply.
F9 30 A 12 V front socket, 12 V rear socket.
F10 15 A A u t o m a t i c g e a r b o x c o n t r o l u n i t , t y r e u n d e r - i n l a t i o n c o n t r o l u n i t , S T O P s w i t c h .
F11 15 A D i a g n o s t i c s o c k e t , p a r t i c l e e m i s s i o n i l t e r u n i t , l o w c u r r e n t i g n i t i o n s w i t c h .
F12 15 A Driving school module, rear parking assistance.
F13 5 A Engine fuse box, rain and brightness sensor.
F14 15 A Trailer fuse box, instrument panel, air bags and pre-tensioners
unit, automatic air conditioning,
hands-free kit.
F15 30 A Locking and deadlocking.
F16 - PARC shunt.
F17 40 A Heated rear screen.
Page 150 of 212
10PRACTICAL INFORMATION
W i t h o u t l i f t i n g
( 4 w h e e l s o n t h e g r o u n d )
You must always use a tow bar.
The removable towing eye is inside
the spare wheel.
Estate: the removable towing eye is
inside the right-hand boot trim. F r o m t h e f r o n t :
Unclip the cover, by pressing the
bottom part,
Screw in the towing eye as far as
it will go.
L i f t i n g ( 2 w h e e l s o n l y o n t h e
g r o u n d )
It is preferable to raise the vehicle
with a professional lifting device.
When towing with the engine
switched off, there is no brak-
ing or steering assistance.
T O W I N G Y O U R V E H I C L E
From the rear:
Unclip the top of the cover using
a coin,
Screw in the towing eye as far as
it will go.
S p e c i a l f e a t u r e s o f t h e
automatic gearbox
When towing with four wheels on the
ground, the following rules must be
obeyed:
- lever in position N ,
-
tow the vehicle at less than 30 mph
(50 km/h) up to a maximum dis-
tance of 30 miles (50 km).
- do not add oil to the gearbox.