Page 146 of 182
Battery fluid contains sulfuric acid. Do not allow battery fluid to contact eyes, skin, fabrics or painted surfaces. If
contact occurs, flush the affected area immediately with water. Obtain medical help immediately if eyes are affected.
pg. 164 Maintenance and servicing
Bulbs
Bulbs used in the car1. Low beam headlight 55W H11
2. Bi -Xenon headlight (option) 35W D2S
3. High beam headlight 55W HB3
4. Brake light, Rear fog light P21/W5
5. Turn signal, front/ rear (amber bulb) PY21W
6. Tail lights, Parking light, Side marker light P21/W5
7. Footwell lighting, cargo compartment light W5W
8. Vanity mirror 1,2W
9. License plate lighting,
Parking light in headlight housing
Side turn signal (amber bulb) W5W
10. Front fog light (option) 55W H11
NOTE:
Never touch the glass of bulbs with your fingers. Grease and oils from your fingers vaporize in the heat and will
leave a deposit on the reflector, which will damage it.
The optional Bi -Xenon headlight bulbs contain trace amounts of mercury. These bulbs should always be disposed
of by a trained and qualified Volvo service technician.
Certain bulbs not listed here should only be replaced by a trained and qualified Volvo service technician.
pg. 165 Maintenance and servicing
Replacing front bulbs
ProCarManuals.com
Page 147 of 182
Removing the headlight housing
The entire headlight housing must be lifted out when replacing the high/low beam, parking light, turn signal, and side
marker bulbs. To lift out the housing:
Remove the key from the ignition and turn the headlight switch to position 0.
Open the hood.
Pull up the headlight housing's retaining pin (1)
Pull the headlight housing to one side and then forward (2).
Disconnect the wiring connector.
Lift out the headlight housing and place it on a soft surface to avoid scratching the lens.
After the defective bulb has been replaced, reinsert the housing in the reverse order. Check that the retaining pin is
correctly inserted.
WARNING!
Bi -Xenon headlights (option) - due to the high voltage used by these headlights, these bulbs should only be replaced
by a trained and qualified Volvo service technician.
Low beam bulb
Open the hood.
Remove the headlight housing.
Press the retaining clamps to the sides.
Release the bulb's retaining spring by pressing it to the right, and then moving it outward and downward.
Pull out the bulb.
Disconnect the wiring connector from the bulb. Installing a new bulb.
Insert the new bulb. It can only be installed in one position.
ProCarManuals.com
Page 179 of 182
Information symbol32, 33
Inspection readiness156
Instrument overview7
Instrument panel32
Instrument panel lighting38
Interior lighting77
ISOFIX/LATCH anchors29
J
Jack, positioning140
Jack, positioning correctly140
Jump starting119
K
Key blade88
Keylock2, 105
Kickdown109
L
Label information188
LATCH anchors29
License plate lighting, replacing169
Lighting panel38
Lighting, interior77
Load anchoring eyelets83
Loading the vehicle133
Locking (double locking feature)91
Long distance trips100
Low beam bulb, replacing165
Low beam headlights40
M
Maintenance154
Malfunction indicator light34
Manual front seat adjustment66
Manual shifting (Geartronic)108
Manual transmission107
Mirror, rearview49
Mirrors, door-mounted50
O
OBD II156
Occupant safety10
Occupant Weight Sensor (OWS), disabling front passenger's side airbag18
Octane rating101
Oil pressure warning light35
Oil, changing158
On Call Roadside Assistance195
Onboard Diagnostic System (OBD II)156
ProCarManuals.com
